engine overheat Mercury Villager 1996 Owner's Manuals

78
*
[LG07200(ALL)01/95]
Engine Coolant Temperature Gauge
[LG07300(ALL)02/95]
This gauge is accompanied by a thermometer symbol. It will
show you the temperature of the engine coolant when the
ignition is in the ON position.
[LG07400(ALL)02/95]
As the engine warms up, the pointer will move to the
NORMAL band. When you are driving in heavy traffic or
experiencing stop-and-go conditions in hot weather, the pointer
may move to the very top of the normal band.
[LG07500(ALL)01/93]
Under any circumstances, if the pointer moves past the upper
limit of the NORMAL band, the engine is overheating and
engine damage may occur.
*
[LG07600(ALL)01/95]
If your engine overheats:
[LG07700(ALL)01/93]1.
Pull off the road as soon as it is safely possible.
*
[LG07800(ALL)03/95]2.
Turn off the engine. If you do not stop the engine as soon as
safely possible, severe engine damage could result.
*
[LG07900(ALL)05/95]3.
Let the engine cool.DO NOT REMOVE COOLANT
SYSTEM FILL CAP UNTIL THE ENGINE IS COOL.
[LG08000(ALL)02/95]4.
Check the coolant level following the instructions on
checking and adding coolant to your engine, seeEngine
coolantin the Index. If you do not follow these instructions,
you or others could be injured.
*
[LG08100(ALL)05/92]5.
Add as much coolant as your engine needs. If the engine
continues to overheat, have the coolant system serviced.
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

82
[LG09600(ALL)01/93]
The electronic cluster has all of the same warning lights as the
mechanical cluster, however, some of the gauges will be
electronic instead of analog. In addition, the electronic cluster
has a fuel computer for measuring fuel economy, distance to
empty and outside air temperature.
*
[LG09700(ALL)01/95]
Engine Coolant Temperature Gauge
[LG09800(ALL)01/93]
This gauge shows you the temperature of the engine coolant
and is identified by a thermometer symbol. The letter H means
that the coolant is hot, C means that it is cold, and NORMAL
means that the coolant is within the normal operating range.
[LG09900(ALL)09/93]
The indicator bar on the graph will move into the normal
operating range as the engine warms up. When you are in
heavy traffic or stop-and-go driving in hot weather, the gauge
may read at the very top of the NORMAL range. This is
acceptable.
[LG10000(ALL)09/93]
However, if the indicator bar on the graph moves into the
H (hot) position, the engine is overheating and may cause
engine damage. If this happens, you should stop your vehicle as
soon as safely possible. Turn off the engine and let it cool.
Check the coolant level to be sure that it is at the proper level.
If your vehicle needs more coolant, seeEngine coolant, checking
and addingin the Index and read the section regarding adding
coolant.
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

100
*
[IP08100(ALL)06/94]
Improving fuel economy
[IP08200(ALL)04/94]
Whenever you turn on the air conditioning, your vehicle uses
more fuel because the air conditioning compressor is running.
To get better fuel economy while cooling your vehicle, do not
use the air conditioner on mild days. Instead, set the air intake
selector button in the outside air position and turn the
temperature control knob to the COOL position.
*
[IP08300(ALL)04/95]
Operating tips
[IP08400(ALL)04/95]
When stopped in traffic for long periods of time in hot weather,
place the automatic transaxle gearshift selector lever in P (Park)
or in N (Neutral) to increase the engine idle speed. This aids in
engine cooling and air conditioner efficiency. If the engine
overheats, choose the outside air position and turn off the A/C
to stop the compressor for a short time.
*
[IP08500(ALL)10/93]
When your vehicle's engine is operated at full throttle, the air
conditioner compressor will automatically be turned off to allow
maximum engine power. This may occur during passing or
when climbing steep grades. The compressor will return to
normal operation within a few seconds after full throttle is no
longer needed.
[IP08600(ALL)06/94]
NOTE: The compressor will not operate when the outside
temperature is less than about40ÊF (4ÊC).
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Driving Your Villager
241
*
[DR11100(ALL)01/93]
RWARNING
The Anti-Lock Brake System may not prevent brake
lock-up on extremely slippery surfaces.
%*
[DR11200(ALL)01/95]
High water
*
[DR11300(ALL)05/90]
Do not drive through flooded areas unless you are sure that the
water is below the bottom of the wheel hubs.
*
[DR11400(ALL)01/93]
If you must drive through high water, drive slowly. You may
have limited traction or wet brakes so allow extra stopping
distance because your vehicle will not stop as quickly as usual.
*
[DR11500(ALL)01/93]
After you drive through the standing water, apply your brakes
gently several times as your vehicle moves slowly to help dry
the brakes.
*
[DR11600(ALL)01/93]
Rocking the Vehicle
*
[DR11700(ALL)01/93]
If your vehicle gets stuck (for example, in mud or snow), you
may rock it out. Shift in a steady rhythm between forward and
reverse gears. At the same time, press lightly on the accelerator.
If you are still stuck after a few minutes of rocking, call for a
tow truck.
*
[DR11800(ALL)01/93]
Do not rock the vehicle for more than a few minutes. This may
overheat the engine, damage the transaxle, or damage the tires.
*
[DR11900(ALL)03/95]
Driving With a Heavy Load
*
[DR12000(ALL)01/93]
The Safety Compliance Certification Label, located on the
driver's door pillar, provides important information regarding
the weight limits your vehicle can safely carry or tow. The total
weight of your vehicle, including the weight of the passengers
and cargo, should never be more than the Gross Vehicle Weight
Rating (GVWR). Also, the weight that your vehicle carries on
the front axle and rear axle should never be more than the
Gross Axle Weight Rating (GAWR) for the respective axle.
File:11vxdrn.ex
Update:Tue Jun 4 11:42:50 1996

Driving Your Villager
253
*
[DR21300(ALL)01/93]
Allow more room for stopping with a trailer attached. Trailer
brakes should be applied first, whether manually or
automatically controlled, when approaching a stop.
*
[DR21400(ALL)01/93]
For an easy-to-operate vehicle/trailer combination, the trailer
tongue load should be approximately 10-15% of the loaded
trailer weight.
*
[DR21500(ALL)02/94]
Make a thorough check of your equipment before starting out
on the road. After you have traveled about 50 miles (80 km),
stop in a protected area and double-check your hitch and
electrical connections. Also check trailer wheel lug nuts for
tightness.
[DR21600(ALL)01/93]
When stopped in traffic for long periods of time in hot weather,
place the gearshift selector lever in Park (P) to increase the
engine idle speed. This aids in engine cooling and air
conditioner efficiency. If the engine overheats, press the air
intake button to select the fresh air position to stop the air
conditioner compressor. Increase the engine speed for a short
time.
*
[DR21700(ALL)01/93]
Vehicles with trailers should not be parked on a grade.
However, if you must park on a grade, place wheel chocks
under the trailer's wheels as follows:
[DR21800(ALL)04/94]1.
Apply the main brake pedal with your foot and hold it.
*
[DR21900(ALL)11/93]2.
Have another person place the wheel chocks under the
trailer wheels.
[DR22000(ALL)04/94]3.
With the chocks in place, release the brake pedal, making
sure the chocks are holding.
[DR22100(ALL)04/94]4.
Apply the parking brake by pressing the main brake pedal
down firmly with your right foot while depressing the
parking brake pedal with your left foot.
*
[DR22200(ALL)06/95]5.
Shift the gearshift lever into P (Park).
File:11vxdrn.ex
Update:Tue Jun 4 11:42:50 1996

314
%*
[SV18400(ALL)03/95]
Engine Coolant
%*
[SV18500(ALL)09/95]
Checking the Engine Coolant
*
[SV18550(ALL)08/95]
NOTE: Be sure to read and understandPrecautions When
Servicing Your Vehicleat the beginning of this chapter.
[SV18600(ALL)01/93]
Your vehicle's engine coolant protects the engine from
overheating in the summer and from freezing in the winter.
Check the level of the engine coolant at least once a month, but
preferably each time you stop for fuel. Simply check the coolant
reservoir, located in the engine compartment. The coolant
should stay between the MIN and MAX marks. It will be closer
to MAX when the engine is warm and closer to MIN when the
engine is cold. To locate the coolant reservoir, see the diagram
of your vehicle's engine underEngine Compartmentin this
chapter.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996