oil level Mercury Villager 1996 Owner's Manuals
[x] Cancel search | Manufacturer: MERCURY, Model Year: 1996, Model line: Villager, Model: Mercury Villager 1996Pages: 396, PDF Size: 3.67 MB
Page 74 of 396
Warning Lights and Gauges
73
*
[LG02700(ALL)01/95]
Charging System Light
*
[LG02800(ALL)03/95]
This light, shown as a battery symbol on your cluster, indicates
that your battery is not being charged and that you need to
have the electrical system checked.
[LG02900(ALL)09/93]
6 pica art:0040054-A
Charging system light
[LG03000(ALL)01/93]
This light comes on every time you turn your ignition key to
the ON or START position. The light should go off when the
engine starts and the alternator begins to charge.
*
[LG03100(ALL)01/95]
If the light stays on or comes on when the engine is running,
have the electrical system checked as soon as possible.
%*
[LG03200(ALL)02/95]
Engine Oil Pressure Warning Light
[LG03300(ALL)04/94]
The oil pressure light is represented by an oil can symbol. It
indicates the engine's oil pressure, not oil level. However, if
your engine's oil level is low, it could affect the oil pressure.
The oil can symbol will flash if the oil pressure drops below the
normal operating level. When you turn the key to the ON
position, the light will illuminate.
[LG03400(ALL)09/93]
6 pica art:0040060-A
Oil pressure light
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996
Page 75 of 396
74
[LG03500(ALL)04/94]
The light should turn off after a few seconds. If the light stays
on or illuminates when the engine is running Ð you have lost
oil pressure and continued operation will cause severe engine
damage.
[LG03550(ALL)02/95]
If you lose engine oil pressure:
[LG03600(ALL)02/95]1.
Pull off the road as soon as safely possible.
*
[LG03700(ALL)03/95]2.
Turn off the engine. If you do not stop the engine as soon as
safely possible, severe engine damage could result.
[LG03800(ALL)04/94]3.
Check the oil level following the instructions on checking
and adding engine oil in this owner guide. (SeeEngine oilin
the index.) Make sure your vehicle is on level ground.
[LG03900(ALL)01/93]4.
If the level is low, add as much oil as necessary before you
drive your vehicle again. Do not drive your vehicle if the oil
pressure light is on, even if the oil level is correct. For more
information about adding oil, seeEngine oil, checking and
addingin the Index.
%*
[LG04000(ALL)01/93]
Door Ajar Warning Light
*
[LG04100(ALL)08/94]
If the ignition switch is in the ON position and any door or the
liftgate is not completely closed, the light will illuminate.
[LG04200(ALL)09/93]
6 pica art:0040061-B
Door ajar warning light
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996
Page 305 of 396
Servicing Your Villager
311
[SV15500(ALL)02/94]
10-1/2 pica
art:0040196-B
Selecting the right viscosity for your climate
%*
[SV15575(ALL)03/95]
Synthetic engine oils which are CERTIFIED and of the preferred
viscosity may be used in your engine. The engine oil and oil
filter must still be changed according to the maintenance
schedule.
%*
[SV15600(ALL)01/95]
Checking and Adding Engine Oil
*
[SV15700(ALL)03/95]
Since the proper amount of engine oil is important for safe
engine operation, check the oil using the dipstick each time you
put fuel in your vehicle. Remember the engine must be off, the
oil must be warm and the vehicle must be parked on level
ground.
%*
[SV15800(ALL)03/95]
Checking the engine oil level:
*
[SV15900(ALL)02/95]1.
Turn the engine off after it has warmed up and allow a few
minutes for the engine oil to drain back into the oil pan.
[SV16000(ALL)07/95]2.
Set the parking brake fully and make sure that the gearshift
is securely latched in P (Park).
*
[SV16100(ALL)02/95]3.
Open the hood. Protect yourself from engine heat.
*
[SV16200(ALL)03/95]4.
Locate the engine oil dipstick (highlighted in yellow) and
carefully pull it out of the engine.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996
Page 306 of 396
312
*
[SV16300(ALL)01/95]5.
Wipe the dipstick clean and put it back into position, making
sure it is fully seated.
[SV16400(ALL)05/93]
7-1/2 pica art:0040218-A
Engine oil dipstick
[SV16500(ALL)05/94]6.
Carefully pull the dipstick out again. If the oil level is below
the ªLº line, add engine oil as necessary. If the oil level is
beyond the letter ªH,º engine damage or high oil
consumption may occur and some oil must be removed from
the engine.
*
[SV16600(ALL)01/95]7.
Put the dipstick back in and make sure it is fully seated.
%*
[SV16650(ALL)03/95]
Adding engine oil
*
[SV16700(ALL)01/95]
It may be necessary to add some oil between oil changes. Make
sure you use a CERTIFIED engine oil of the preferred viscosity.
Your vehicle's warranty coverage may not apply if engine
damage is caused by the use of improper engine oil.
*
[SV16800(ALL)03/95]
Add engine oil through the oil filler cap highlighted in yellow.
To add oil, remove the filler cap and use a funnel to pour oil
into the opening. Be careful not to overfill the engine. Recheck
the oil level after you finish adding oil.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996
Page 323 of 396
Servicing Your Villager
329
%*
[SV29650(ALL)04/95]
Cleaning the Wheels
*
[SV29675(ALL)05/95]
Wash the wheels with the same detergent you use to wash your
vehicle's body. Do not use acid-based wheel cleaners, steel wool,
abrasives, fuel, or strong detergents. These substances will
damage protective coatings. Use tar and road oil remover to
remove grease and tar.
*
[SV29700(ALL)04/95]
If you have whitewall tires that are difficult to clean with
regular detergent, use whitewall tire cleaner. Follow the
directions on the container and rinse the tires with plenty of
clean water.
*
[SV29725(ALL)09/95]
NOTE: Before going to a car wash, find out if the brushes are
abrasive.
%*
[SV29800(ALL)03/95]
Battery
[SV29900(ALL)05/96]
The Motorcraft low-maintenance battery requires periodic
service as detailed below. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed. For longer, trouble-free operation, keep
the top of the battery clean and dry. Also, make certain the
battery cables are tightly fastened to the battery terminals.
[SV30000(ALL)05/96]
If you see any corrosion on the battery cables or terminals,
remove the cables from the terminal and clean them both with a
wire brush. You can neutralize the acid with a solution of
baking soda and water. Reinstall the cables when you are done
cleaning them, and apply a small quantity of grease to the top
of each battery terminal to help prevent corrosion.
*
[SV30100(ALL)07/95]
Battery replacement
[SV30200(ALL)05/96]
If your original equipment battery requires replacement while
under warranty, it may be replaced by a Motorcraft
low-maintenance battery. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996