Mercury Villager 1998 Owner's Manuals

Roadside Emergencies
247

3. Check the fuse to see if it is blown. Look through the clear side
of the fuse to see if the metal wire inside is separated. If it is,
the fuse is blown and should be replaced.
Fuse puller tool and fuse
248

4. Use the fuse puller tool to remove the blown fuse and replace
the fuse with one that has the right amperage rating (see the
fuse panel cover for amperage ratings).
WARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage rating
can cause severe wire damage and could start a fire.
5. Put the fuse panel cover back on.
Even after you replace a fuse, it may continue to blow if you do
not find what caused the overload. If the fuse continues to
blow, have your electrical system checked.
The following chart indicates the colors and amperage ratings of
standard fuses.
sv0051-b
Roadside Emergencies
249

Engine Compartment Main Fuse Panel
Engine fuse block location
Engine compartment main fuse panel
250

Roadside Emergencies
251

Circuit Breakers
The circuit breakers will reset themselves and allow the electrical
parts to work again once the overload on the circuit is
removed. If the circuit breakers continue to cut off electricity,
have your vehicle's electrical system checked.
If you have questions about circuit breakers or how to check
them, see your Lincoln-Mercury dealer.
If you replace a circuit breaker, use one with the same amperage
rating. To remove a circuit breaker mounted by the fuse
panel, grip it with your finger and thumb and pull it straight out
of its socket.
252

Relays
Relays are devices which receive signals from components or
systems. After receiving signals, relays transfer these signals to
activate or deactivate other components or systems. A relay box is
located near the windshield washer fluid reservoir.
The relay box
Roadside Emergencies
253

Changing a Flat Tire
If you get a flat tire while you are driving, do not apply the
brake heavily. Instead, gradually decrease the speed. Hold the
steering wheel firmly and slowly move to a safe place on the side
of the road. Park on a level spot, turn off the ignition, set the
parking brake, and turn on the hazard flashers.
The Temporary Spare Tire
Your vehicle has a temporary spare tire (unless you ordered the
optional full-size spare tire). This spare tire is smaller than a
regular tire and is designed for emergency use only. Use it only
when you get a flat tire and replace it as soon as you can. This spare
tire is marked with the words TEMPORARY USE ONLY so
that you can easily identify it.
WARNING
If you use the temporary spare tire continuously or do not
follow these precautions, the tire could fail, causing
you to lose control of the vehicle, possibly injuring yourself
or others.
When you drive with the temporary spare tire, DO NOT:
mexceed 50 mph (80 km/h) under any circumstances
mload your vehicle so that it is heavier than the maximum
vehicle load rating listed on the tire decal
mtow a trailer
muse tire chains
mtry to repair the temporary spare tire or remove it from its
wheel
muse the wheel for any other type of vehicle
254

mdrive through an automatic car wash. Because the temporary
spare tire is smaller than a conventional tire, it reduces the
ground clearance. Your vehicle may get caught in the rails and
it could be damaged.
Spare Tire Location
The spare tire is stored underneath your vehicle.
To remove the spare tire:
1. Open the liftgate and find the plastic hex nut cover in the
carpeting of the cargo area. Lift the cover to expose the hex nut.
The spare tire hex nut
Roadside Emergencies
255

2. Find the lug wrench in the tool kit located behind the jack in
the right cargo area side panel.
Jack storage location
256