service Mercury Villager 1998 s Owner's Guide

The parking brake is not designed to stop a moving vehicle, but
you can use the parking brake to stop your vehicle in an
emergency if the service brakes fail. However, since the parking
brake does not stop your vehicle as quickly as the normal
brakes, the stopping distance will increase greatly.
Steering Your Vehicle
Your vehicle has power steering. Power steering uses energy
from the engine to help steer your vehicle.
If the amount of effort needed to steer your vehicle changes at a
constant vehicle speed, have the power steering system
checked. If the power steering system breaks down (or if the
engine is turned off), you can steer the vehicle manually but it takes
more effort.
Never hold the steering wheel in the extreme right or left
position for more than five seconds if the engine is running. This
can damage the power steering pump.
NOTE: After any severe impact such as striking large potholes,
sliding into curbs on icy roads, or a collision involving
the front end, have the front suspension and
steering checked for possible damage.
220

Vehicle/Trailer Loads
Your vehicle may tow a Class I trailer up to 2,000 lbs. (907 kg)
provided the Gross Vehicle Weight (GVW) is less than the GVWR
shown on the Safety Compliance Certification Label. With the
optional trailer tow package, your vehicle can tow a trailer up to
3,500 lbs. (1,588 kg).
Trailer Towing (may require trailer tow option package)
Towing a trailer puts an additional load on your vehicle's
engine, transaxle, axle, brakes, tires and suspension. Always use
the proper equipment for the type of trailer you tow.
mStay within the load limits when you tow.
mCarefully and thoroughly prepare your vehicle for towing,
making sure to use and install the proper equipment. See
Preparing to Towin this section.
mUse extra caution when driving your vehicle while you tow.
SeeDriving While You Towin this section.
mService your vehicle more frequently if you tow a trailer. See
Servicing Your Vehicle if You Towin this section.
Do not tow a trailer until your vehicle has been driven at least
500 miles (800 km).
Vehicle Loading Information
Your vehicle's load capacity is designated by weight, not volume,
so you cannot necessarily use all the available space.
Maximum safe vehicle weights as well as tire sizes, wheel sizes
and inflation pressures are specified for your vehicle at the
assembly plant on the Safety Compliance Certification Label. The
certification label is located on the pillar in the driver's door
opening.
Driving
227

Each additional item of equipment affects how much cargo a
vehicle can carry. If a vehicle is overloaded, performance will suffer
and service concerns may arise.
The following is a typical example of a Safety Compliance
Certification Label and an explanation of how this information
should be used:
NOTE: The vehicle must not be loaded to both the front and rear
GAWR because the GVWR will be exceeded. The
GAWR of the front and rear axles exceed the GVWR
when added together.
There are no numbers on the sample Safety Compliance
Certification Label shown. Refer to the actual numbers on your
vehicle's Safety Compliance Certification Label.
Understanding Loading Information
There are five terms that are used to describe a vehicle's ability
to carry a load:
mBase Curb Weight
The Safety Compliance Certification Label
228

Trailer Tow Module (If equipped)
The trailer tow module on your vehicle (if equipped) allows
turn/stop lamp control on a trailer being towed by your vehicle.
The trailer tow package includes:
mtrailer tow module which is protected by the vehicle stop
lamp fuse
mone SAE J1239 specified connector
mone extension harness within the rear bumper
mheavy duty battery
mfull size spare
If you need further assistance in wiring a trailer to your vehicle,
contact your Ford or Lincoln-Mercury dealer.
Driving While You Tow
Be especially careful when driving while you tow a trailer. Never
drive faster than 45 mph (70 km/h) when you tow in hilly
country on hot days. Also, anticipate stops so that you can brake
gradually.
If you use the speed control while you are towing on very long,
steep grades, the speed control may shut off automatically.
This is caused by the decrease of vehicle speed 5 mph (8 km/h)
lower than set speed.
When descending a steep grade with a trailer, operate in Drive
rather than Overdrive. If additional braking is needed, shift into 2
(Second) or 1 (First) gear.
Servicing Your Vehicle If You Tow
If you tow a trailer for a long distance, your vehicle will need to
be serviced more frequently than usual. See theMaintenance
Schedulebooklet in the Owner's portfolio.
236

To avoid damaging your vehicle or your battery, and to avoid
injury to yourself, follow these directions for preparing your vehicle
to jump-start and connecting the jumper cables in the order
they are given. If in doubt, call for road service.
Preparing Your Vehicle
1. Your vehicle has a 12-volt starting system, so you need to use
a 12-volt jumper system. You will damage your starting
motor, ignition system, and other electrical parts if you connect
them to a 24-volt power supply (either two 12-volt batteries
in series or a 24-volt generator set).
2. Do not disconnect the battery of the disabled vehicle. You
could damage the vehicle's electrical system.
3. Park the booster vehicle close to the hood of the disabled
vehicle.Make sure the vehicles do not touch each other.Set the
parking brake on both vehicles and stay clear of the engine
cooling fan and other moving parts.
4. Check all battery terminals and remove any excessive
corrosion before you attach the jumper cables.
5. Turn on the heater blower in both vehicles. Turn off all other
switches and lights in both vehicles to prevent possible
damage to either vehicle's electrical systems.
Roadside Emergencies
269

Jump-Starting
1. Make sure that the jumper cables are not in the way of
moving engine parts, then start the booster vehicle. Run the
engine at a moderate speed.
2. Let the discharged battery charge for a few minutes and then
start the disabled vehicle. It may take a couple of tries before
the vehicle starts. If the vehicle does not start after several
attempts, there may be a different problem.
3. When both vehicles are running, let them idle for a few
minutes to charge the discharged battery.
Removing jumper cables
1.Always remove the jumper cables in the reverse order.
Remove the negative (±) end of the jumper cable from the
metallic surface on the engine or frame of the disabled
vehicle.
2. Remove the negative (±) cable from the booster battery.
3. Remove the positive (+) cable from the booster battery.
4. Remove the other end of the positive (+) cable from the
discharged battery.
If you need to replace your battery, seeBatteryin theMaintenance
and Carechapter.
Towing Your Vehicle
If you need to have your vehicle towed, contact a professional
towing service or, if you are a member, your roadside assistance
center.
DO NOT TOW YOUR VILLAGER WITH SLINGBELT
EQUIPMENT. Ford Motor Company has not developed or
approved a T-hook sling-type procedure. Use wheel lift or flatbed
equipment.
272

Service Made Easy
Ford has two goals for servicing your vehicle.
1. When we can, we design parts that do not need to be
serviced.
2. We want to make servicing your vehicle as easy as possible.
To help you:
mWe highlight do-it-yourself items in yellow in your engine
compartment so that you can find them easily.
mWhen possible, we design parts that can be replaced without
tools.
mWe give you a Maintenance Schedule that makes tracking
routine service for your vehicle easy. TheMaintenance
Schedulebooklet is part of your owners portfolio.
This chapter tells you about the basic parts that you need to
check and service regularly.
If your vehicle needs professional servicing, your dealership can
provide the parts and service required. Check yourWarranty Guide
to find out which parts and services are covered. Also see the
Customer Assistancechapter of this Owner's Manual.
Ford Motor Company recommends that the Owner Maintenance
Checks listed in theMaintenance Schedulebooklet be
performed for the proper operation of your vehicle. In addition
to the conditions listed in the Owner Maintenance Checklist, be
alert for any unusual noise, vibration, or other indication that
your vehicle may need service. If you do notice something unusual,
see that your vehicle is serviced promptly.
Use only recommended fuels, lubricants, fluids, and service parts
that meet Ford Motor Company specifications. Motorcraft
parts are designed and built to provide the best performance in
your vehicle.
Maintenance and Care
275

Checking Engine Oil
Check the engine oil each time you fuel your vehicle.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain
into the oil pan.
3. Set the parking brake and ensure the gearshift is securely
latched in Park,9P9.
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level indicator (dip
stick).
6. Wipe the indicator clean. Insert the indicator fully, then
remove it again.
mIf the oil level isbetween the L and H marks,the oil level is
acceptable.DO NOT ADD OIL
mIf the level is below the L mark, add enough oil to raise the
level within the L-H range
WARNING
Oil level above the H mark may cause engine damage.
Some oil must be removed from the engine by a service
technician.
7. Put the indicator back in and ensure it is fully seated.
280

Engine Coolant Drain and Flush
To have your engine coolant drained, see your Ford or
Lincoln-Mercury dealer or refer to the procedure in the Service
Manual.
Power Steering Fluid
Check the level of the power steering fluid at least twice a year
(i.e., every Spring and Fall).
Checking and Adding Power Steering Fluid
1. Start the engine and let it run until the power steering fluid
reaches normal operating temperature. The power steering
fluid will be at the right temperature when the engine coolant
temperature gauge in the instrument cluster is near the
center of the NORMAL operating temperature range.
2. While the engine idles, turn the steering wheel back and forth
several times. Make sure that the cap assembly is installed at
this time.
3. Then turn the engine off.
4. Check the fluid level in the power steering fluid reservoir.
Maintenance and Care
289

NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
NOTE: Always use Motorcraft MERCONtor equivalent
MERCONtautomatic transmission fluid when you
refill your automatic transmission fluid.
Battery
The Motorcraft maintenance-free battery normally does not
require additional water during its life of service. However, for
severe service usage or in high temperature climates, check your
battery electrolyte level, at least every 24 months or 24,000
miles (40,000 km). Keep the electrolyte in each cell up to the ``level''
indicator. Do not overfill the battery cells. For longer,
trouble-free operation, keep the top of the battery clean and dry.
Also, make certain the battery cables are always tightly
fastened to the battery terminals.
If you see any corrosion on the battery cables or terminals,
remove the cables from the terminal(s) and clean with a wire
brush. You can neutralize the acid with a solution of baking soda
Automatic transmission fluid dipstick
Maintenance and Care
293