hood open Mercury Villager 1998 Owner's Manuals
[x] Cancel search | Manufacturer: MERCURY, Model Year: 1998, Model line: Villager, Model: Mercury Villager 1998Pages: 400, PDF Size: 2.06 MB
Page 122 of 400
NOTE: Be sure to close all the doors completely. If the doors
are not completely closed, the alarm indicator light will
remain on steadily. The anti-theft system is armed
only when the anti-theft indicator light remains on
steadily for approximately 30 seconds after the last door
is closed, and then flashes every 2.5 seconds.
Disarming an untriggered anti-theft system
Unlock either door with the door key or by pressing the
UNLOCK button on the remote keyless entry transmitter (if
equipped). This will disarm the system. When you unlock the door
with the key, make sure you fully rotate the key in the lock. If
you do not, the system may not disarm, and will trigger when a
door is opened.
If the system is armed and you remain in your vehicle, simply
insert the key into the ignition and turn it to ACC. This disarms the
system and allows you to open the door to exit without
triggering the system. Remember to rearm the system by using
the power door lock or the remote transmitter (if equipped) to lock
the doors.
The remote keyless entry system is designed to work with the
factory installed anti-theft system. It may not work with other
anti-theft systems.
Triggering the anti-theft system
The armed system will be triggered if:
many door is opened without using the door key or the remote
keyless entry transmitter (if equipped)
mthe liftgate is opened or unlocked
mthe hood is opened
11 8
Page 281 of 400
If you must work under the hood while the engine is running:
mSet the parking brake fully and make sure that the gearshift
is securely latched in P (Park). This will prevent your
vehicle from moving unexpectedly.
WARNING
Do not start your engine with the air cleaner removed and
do not remove it while the engine is running.
mAvoid wearing loose clothing or jewelry that could get caught
in moving parts. Take appropriate precautions with long hair.
Opening the Hood
1. Pull the hood release handle, located below the fuse panel
door.
Hood release handle location
Maintenance and Care
277
Page 284 of 400
Checking Engine Oil
Check the engine oil each time you fuel your vehicle.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain
into the oil pan.
3. Set the parking brake and ensure the gearshift is securely
latched in Park,9P9.
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level indicator (dip
stick).
6. Wipe the indicator clean. Insert the indicator fully, then
remove it again.
mIf the oil level isbetween the L and H marks,the oil level is
acceptable.DO NOT ADD OIL
mIf the level is below the L mark, add enough oil to raise the
level within the L-H range
WARNING
Oil level above the H mark may cause engine damage.
Some oil must be removed from the engine by a service
technician.
7. Put the indicator back in and ensure it is fully seated.
280
Page 312 of 400
Before you fill your vehicle with fuel, extinguish all lit cigarettes,
other smoking materials, and any open flames.
To fill the tank properly:
1. Remove the fuel filler cap. Proceed to add fuel to the tank
only if your vehicle is on level ground.
2. Make sure you pump unleaded fuel and put the nozzle all the
way inside the fuel filler pipe. The fuel tank is normally full
after three automatic shutoffs of the nozzle.
3. If you spill any fuel on the body of your vehicle, clean it off
immediately. The fuel may dull or soften the paint if you do
not wash it off.
4. Replace the fuel cap tightly when you are finished. Turn it
clockwise until you hear at least three clicks. The
ratcheting mechanism allows the fuel cap to be sealed without
overtightening.
5. Push the fuel door closed.
Choosing the Right Fuel
Use only UNLEADED FUEL. The use of leaded fuel is prohibited
by law and could damage your vehicle. The damage may not
be covered by your warranty.
Your vehicle was not designed to use fuel containing
manganese-based additives such as MMT. Additionally, vehicles
certified to California emission standards (indicated on the
underhood Vehicle Emissions Control Information label) are
designed to operate on California reformulated gasolines. If
California reformulated gasoline is not available when you refuel,
your vehicle can be operated on non-California fuels. However,
even though your engine will perform adequately on other
308