jacking Mercury Villager 1998 Owner's Manuals

Stowing the spare tire
1. To raise the tire to the stowed position, lay the tire on the
ground with the inboard side facing up. Install the retainer
through the wheel center and slide the tire under the
vehicle. Fit the hex-shaped end of the lug wrench over the hex
nut in the floor of the cargo area. Turn the lug wrench
clockwise until the tire is raised to its original position
underneath the vehicle.
NOTE: The lug wrench ratchets when the tire is raised to the
stowed position. It will not allow you to over-tighten.
2. Check for proper seating against the underbody supports and
retighten if necessary.
WARNING
Make sure the spare tire and jacking equipment are
stowed and secured in the proper storage location.
Preparing to Change the Tire
You should only raise your vehicle with a jack properly placed at
the front or rear jacking points.
1. Make sure that your vehicle will not move or roll and that the
tires and jack are on a level, solid surface. Put the gearshift
lever in P (Park). Set the parking brake and block the wheel Ð
in both directions Ð that is diagonally opposite the tire that
you are changing.
WARNING
When one of the front wheels is off the ground, the
transaxle alone will not prevent the vehicle from moving
or slipping off the jack, even if the vehicle is in P
(Park).
258

5. Fit the jack under the proper jacking point indicated by the notch
in the bottom of the door frame panel.
Anti-theft lug nut
The notches for the jack
262