jump start Mercury Villager 1998 Owner's Manuals

Jump-Starting Your Battery
Your vehicle's battery may discharge if you leave the lights or
any electrical equipment on after you turn the engine off. If this
happens, you may be able to jump-start from a booster
battery to start your vehicle.
WARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
WARNING
To protect yourself when charging a battery, always shield
your face and eyes. Make sure that you can breathe
fresh air.
WARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
WARNING
Batteries contain sulfuric acid which burns skin, eyes, and
clothing.
If the acid touches someone's skin, eyes, or clothing, immediately
flush the area with water for at least 15 minutes. If someone
swallows the acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or vegetable oil. Call a
doctor immediately.
268

To avoid damaging your vehicle or your battery, and to avoid
injury to yourself, follow these directions for preparing your vehicle
to jump-start and connecting the jumper cables in the order
they are given. If in doubt, call for road service.
Preparing Your Vehicle
1. Your vehicle has a 12-volt starting system, so you need to use
a 12-volt jumper system. You will damage your starting
motor, ignition system, and other electrical parts if you connect
them to a 24-volt power supply (either two 12-volt batteries
in series or a 24-volt generator set).
2. Do not disconnect the battery of the disabled vehicle. You
could damage the vehicle's electrical system.
3. Park the booster vehicle close to the hood of the disabled
vehicle.Make sure the vehicles do not touch each other.Set the
parking brake on both vehicles and stay clear of the engine
cooling fan and other moving parts.
4. Check all battery terminals and remove any excessive
corrosion before you attach the jumper cables.
5. Turn on the heater blower in both vehicles. Turn off all other
switches and lights in both vehicles to prevent possible
damage to either vehicle's electrical systems.
Roadside Emergencies
269

Jump-Starting
1. Make sure that the jumper cables are not in the way of
moving engine parts, then start the booster vehicle. Run the
engine at a moderate speed.
2. Let the discharged battery charge for a few minutes and then
start the disabled vehicle. It may take a couple of tries before
the vehicle starts. If the vehicle does not start after several
attempts, there may be a different problem.
3. When both vehicles are running, let them idle for a few
minutes to charge the discharged battery.
Removing jumper cables
1.Always remove the jumper cables in the reverse order.
Remove the negative (±) end of the jumper cable from the
metallic surface on the engine or frame of the disabled
vehicle.
2. Remove the negative (±) cable from the booster battery.
3. Remove the positive (+) cable from the booster battery.
4. Remove the other end of the positive (+) cable from the
discharged battery.
If you need to replace your battery, seeBatteryin theMaintenance
and Carechapter.
Towing Your Vehicle
If you need to have your vehicle towed, contact a professional
towing service or, if you are a member, your roadside assistance
center.
DO NOT TOW YOUR VILLAGER WITH SLINGBELT
EQUIPMENT. Ford Motor Company has not developed or
approved a T-hook sling-type procedure. Use wheel lift or flatbed
equipment.
272

Roadside Assistance
Ford Motor Company has set up a 24-hour, seven-day-a-week
hotline with trained operators who put you in touch with the help
you need if you experience a problem with your vehicle. This
complimentary service is provided to you throughout your
warranty period of 3 years or 36,000 miles (60,000 km),
whichever comes first. To purchase Roadside Assistance coverages
beyond this period (available through Ford Auto Club in the
United States or Ford and Lincoln-Mercury dealers in Canada),
contact your Ford or Lincoln-Mercury dealer. Additional Roadside
Assistance coverage is unavailable in Puerto Rico and the
Virgin Islands.
Roadside Assistance will cover the following:
mMount your spare if you have a flat tire.
mJump-start your battery if it is dead.
mUnlock your vehicle if you are locked out.
mBring you fuel if you run out.
mTow your vehicle if you are stranded. Even non-warranty
related tows, like accidents or getting stuck in mud or snow, are
covered (some exclusions apply, such as impound towing
and repossession).
How to use Roadside Assistance
Your Roadside Assistance (Mercury Commitment) identification
card can be found in the Owner Guide portfolio in your
glove compartment. Complete the card and place it in your
wallet for quick reference.
To receive roadside assistance in the United States call
1-800-241-FORD (in Canada call 1-800-665-2006).
Customer Assistance
345

Ignition
positions of the ignition..................86
Infant seats (see Safety seats)..............151, 153
Instrument panel
cleaning.........................332
lighting up panel and interior...............79
Interval wipers........................89
J
Jack.............................255
operation........................258
positioning........................258
storage..........................255
Jump-starting your vehicle
attaching cables.....................270
disconnecting cables...................272
K
Keys
positions of the ignition..................86
stuck in lock position.................86,213
L
Lamps
bulb replacement specifications chart...........322
checking.........................316
daytime running light system...............78
hazard flashers....................77,241
instrument panel, dimming................79
replacing bulbs......................316
trailer..........................235
Lane change indicator (see Turn signal)...........87
Liftgate...........................102
Index
383