service MITSUBISHI CARISMA 2000 1.G User Guide

MAINTENANCE
9–4
Type 1
M03B029a
Selection of engine oil
(diesel-powered vehicles)
EM03BAKe
(1) Select engine oil of the proper SAE vis-
cosity number according to the atmos-
pheric temperature.
(2) Use engine oil conforming to the follow-
ing classification:
Ty p e 1 :ACEA classification:
“For service B2-96 or B3-96”
Ty p e 2 :API classification:
“For service CF”
NOTE
Use of additives is not recommended
since they may reduce the effectiveness of
additives already included in the engine
oil. It may result in failure of the mechani-
cally assembly.
Type 2
M03B030aM05A069a
Automatic transmission fluid*EM05AAH
The proper amount of automatic trans-
mission fluid is essential to the life and oper-
ation of the automatic transmission. Either in-
sufficient fluid or excessive fluid could cause
transmission trouble. The transmission fluid
filler port cap is equipped with a dipstick. Use
the following procedure to check the fluid
level.
1. Check the fluid level after the vehicle
has been driven enough to warm up
the transmission fluid.
2. Park the vehicle on a flat, level surface
and apply the parking brake.

MAINTENANCE
9–10
Petrol-powered vehicle
M10A005a
Clutch fluid*EM10A-J
Petrol-powered vehicle
To check the clutch fluidThe clutch fluid in the master cylinder
should be checked when performing other
underhood services. In addition, the sys-
tem should be checked for leakage at the
same time.
Check to make certain that the clutch fluid
level is always between the “MAX” and
“MIN” level markings on the fluid reservoir
and refill the fluid, if necessary.
A rapid fluid loss indicates a leak in the
clutch system which should be inspected
by your authorized MITSUBISHI dealer
and repaired immediately.
To replace the fluidRecommended brake fluid conforming to
DOT 3 or DOT 4 should be used.
The reservoir cap must be fully tightened to
avoid contamination from foreign matter or
moisture.
DO NOT ALLOW PETROLEUM-BASED
FLUID TO CONTACT, MIX WITH, OR
OTHERWISE CONTAMINATE THE
BRAKE FLUID. SEAL DAMAGE WILL RE-
SULT.
WARNING
Take care in handling brake fluid as it
is harmful to the eyes and may also
cause damage to painted surfaces.
When the fluid is spilt, wipe it up im-
mediately.
Diesel–powered vehicle
The reservoir for the clutch fluid also serves
as the reservoir for the brake fluid. Refer to
the paragraph on the “Brake fluid”.
M31A019a
Washer fluidEM31AAO
Check the washer fluid level in the container.
If the level is low, replenish as required.
NOTE
The washer fluid container serves the wind-
screen, rear window, and headlamps (if so
equipped).
During cold weather
To ensure proper operation of the washers at
low temperatures, use a fluid containing an
anti–freezing agent.

SPECIFICATIONS
10–12
Other specificationsEP01IMDb
ItemPetrol-powered vehicleDiesel powered vehicleItem1300, 16001800 (GDI)Diesel-powered vehicle
Fuel controlMulti-point injectionGasoline direct injectionInjectionFuel systemFuel pumpElectric motor typeElectric motor and
Mechanical single plunger typeCommon rail type
ClutchDry single disc clutch with diaphragm spring, hydraulic action
Steering systemRack and pinion type, power assisted
SuspensionFrontIndependent type, Mac Pherson sturt, coil springSuspensionRearIndependent type, multi-link, coil spring
TypeHydraulic, diagonally connected double circuit system with power assistance, anti-lock brake*
Service brakesFrontVentilated disc brakes
RearDisc brakes
Parking brakesParking brake acts mechanically on rear wheels
*: Option