instrument cluster MITSUBISHI COLT 2008 Owner's Manual (in English)
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2008, Model line: COLT, Model: MITSUBISHI COLT 2008Pages: 450, PDF Size: 14.57 MB
Page 145 of 450
Instruments and controls3-25
3
NOTE●If the driving range drops below 50 km (30 miles) while
the driving range is displaye d, the display shows “---”.
When this occurs, top up the fu el tank as soon as possible.
● The driving range varies depending on road conditions,
the manner of driving and other related factors. Conse-
quently, the display should be used only as a guide. It is
recommended that you add fuel as soon as the low fuel
warning lamp in the instrument cluster illuminates.
(Refer to “Low fuel warning lamp” on page 3-6.)
● Refueling will update the driving range indication.
● The driving range displayed is based on previous fuel con-
sumption data. Disconnecting the battery cable will result
in the deletion of existing fuel consumption data, which
will affect the unit’s calculations.
● The driving range figure can occasionally increase if the
vehicle is stopped on an inclin e. This is because the fuel
has moved in the tank because of the incline and is not
considered to be a fault.
Average speedE00509500059
This value shows the average speed (in km/h or mph) since the
display was reset. Refer to “To reset the display” on page 3-22.
Page 153 of 450
Instruments and controls3-33
3
Lamp monitor buzzerE00506100067
If the driver’s door is opened when the ignition key is in the
“LOCK” or “ACC” position or removed from the ignition
switch while the lamps are on, a buzzer will sound to remind
the driver to turn off the lamps. Turn off the lamp switch to
stop the buzzer.
Dipper (High/Low beam change)E00506200127
When the lamp switch is in the “ ” position, thebeam changes from high to low (or low to high)
each time the lever is pul led to (1). While the
high beam is on, the high beam indicator lamp
in the instrument cluster will also illuminate.
Page 154 of 450
3-34 Instruments and controls
3
Headlamp flasherE00506300043
The high beams flash when the lever is pulled slightly to (2),
and will go off when it is released.
When the high beam is on, the high beam indicator lamp in the
instrument cluster will also illuminate.
NOTE● The high beams can also flash when the lamp switch is
OFF.
● If you turn the lamps off with the headlamps set to high-
beam illumination, the h eadlamps are automatically
returned to their low-beam setting when the lamp switch
is next turned to the “ ” position.
Headlamp levelling switch
E00506400581
The angle of the headlamp b eam varies depending upon the
load carried by the vehicle.
The headlamp levelling switch (A) can be used to adjust the
headlamp illumination distance (when the lower beam is illu-
minated) so that the headlamps’ glare does not distract the
drivers of approaching vehicles.
Set the switch (referring to the following table) to the appropri-
ate position according to the numb er of people and the load in
the vehicle.
Page 157 of 450
Instruments and controls3-37
3
Hazard warning flasher switch
E00506600088
Use the hazard warning flasher switch when the vehicle has to
be parked on the road for any emergency.
The hazard warning flashers can always be operated, regard-
less of the position of the ignition key.
Push the switch to turn on the hazard warning flashers; push
the switch again to turn them off.
When this switch is operated, all turn-signal lamps flash con-
tinuously, as do the turn-signal indicator lamps in the instru-
ment cluster.
Front fog lamp switch*
E00506800543
The front fog lamps illuminate only when the headlamps or tail
lamps turn on. Push the switch to turn on the front fog lamps,
and push the switch again to turn them off.
The indicator lamp in the instrument cluster will illuminate
while the front fog lamps are on.
NOTE●
The front fog lamps are automa tically turned off when the
headlamps and tail lamps turn off. To turn on the front fog
lamps again, push the switch again when the headlamps or
tail lamps turn on.
● In case of vehicles with Daytime Running Lamp, the front
fog lamp can be operated even if the lamp switch is set to
the “ ” (OFF) position, becau se the low beam of the
headlamps, tail lamps, etc. illuminate when the ignition
key is at the “ON” position.
CAUTION!
● If the lamps are kept flashing for a long time, the
battery will be discharged, resulting in difficulty or
inability to start the engine.
Page 158 of 450
3-38 Instruments and controls
3Rear fog lamp switch
E00506900238
The rear fog lamps illuminate
only when the headlamps or
front fog lamps (if so equipped) turn on.
Push the switch to turn on the rear fog lamp, and push the
switch again to turn it off.
The indicator lamp in the instrument cluster will illuminate
while the rear fog lamp is on.
NOTE● The rear fog lamp is automa tically turned off when the
headlamps and front fog lamps (if so equipped) turned off.
To turn on the rear fog lamp again, push the switch again
when the headlamps or front fog lamps (if so equipped)
turn on.
● In case of vehicles with Daytime Running Lamp, the rear
fog lamp can be operated even if the lamp switch is set to
the “ ” (OFF) position, becau se the low beam of the
headlamps, tail lamps, etc. illuminate when the ignition
key is at the “ON” position.
Type 1
Type 2