isofix MITSUBISHI COLT 2008 Owner's Manual (in English)
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2008, Model line: COLT, Model: MITSUBISHI COLT 2008Pages: 450, PDF Size: 14.57 MB
Page 82 of 450
2-34 Seat and seat belts
2
●Before purchasing a child rest raint system, try installing it
in the rear seat to make sure there is a good fit. Because of
the location of the seat belt buckles and the shape of the
seat cushion, it may be difficult to securely install some
manufacturer’s child restraint systems.
If the child restraint system can be pulled forward or to
either side easily on the seat cushion after the seat belt has
been tightened, choose an other manufacturer’s child
restraint system.NOTE● Depending on the seating position in the vehicle and the
child restraint system that you have, the child restraint can
be attached using one of the following two locations:
• To the lower anchorage in the rear seat ONLY if the
child restraint has ISOFIX mountings (See page 2-40).
• To the seat belt (See page 2-42, 2-45).
WARNING!
● When installing a child rest raint system, refer to the
instructions provided by the manufacturer of the
restraint system. Failure to do so can result in severe
or fatal injury to your child.
● After installation, push an d pull the child restraint
system back and forth, and si de to side, to see that it
is positively secured. If the child restraint system is
not installed securely, it may cause injury to the
child or other occupants in the case of accident or
sudden stops.
● When the child restraint sy stem is not in use, keep
your child or infant seat s ecured with the seat belt or
remove it from the vehicle in order to prevent injury
to your child.
Page 88 of 450
2-40 Seat and seat belts
2
Installing a child restraint system to the lower
anchorage (ISOFIX child restraint mountings)
E00408900228
Your vehicle’s rear seat is fitted with lower anchorages for
attaching a child restraint sy stem with ISOFIX mountings.
Child restraint system with ISOFIX mountingsE00409000473
The child restraint system is designed only for seats that incor-
porate lower anchorages. Retain the child restraint system
using the lower anchorages.
It is not necessary to retain th e child restraint system using the
vehicle’s seat belts. Only a MITSUBISHI MOTORS genuine
child restraint system can be used.
Genuine parts No. : MZ313200
ECE No. : E1-04301133
A: Child restraint system connectors