heating MITSUBISHI ECLIPSE 1993 Workshop Manual

BODY - Moulding23-47
?8UO387
3.REMOVAL OF QUARTER WINDOW MOULDING LOWER/
4. QUARTER WINDOW MOULDING UPPER/B. QUARTER
WINDOW MOULDING FRONTRefer to P.23-59.
6. REMOVAL OF
LIFTGATE MOULDING LOWER17. LIFT-GATE MOULDING
UPPER/8. LIFTGATE MOULDING
SIDERefer to P.23-60.
9. REMOVAL OF SIDE PROTECT MOULDING FENDER/
10. SIDE PROTECT MOULDING FRONT DOOR/l 1.
REMOVAL OF SIDE PROTECT MOULDING QUARTER(1) Using the plastic trim tool, pry off the side protect
moulding.(2) Using the
ptastic trim tool, scale off the both-side
adhesive tape which sticks to the body.
SERVICE POINTS OF INSTALLATION
9. INSTALLATION OF SIDE PROTECT MOULDING FEN-
DER/10. SIDE PROTECT MOULDING FRONT DOOR/11. SIDE PROTECT MOULDING QUARTER
(1) Wipe off application surface of body with clean cloth
dampened with degreaser (MOPAR SUPER KLEEN or
equivalent).
NOTEAfter wiping surface, leave surface as it is to volatilize
degreaser.(2) Using an infrared light or similar instrument, heat the
body painted surface and the side protect moulding.
Heating temperature
Body painted surface..,.. 25-55OC (77-131OF)
Side protect moulding....
25-40°C (77-104OF)

BODY - Aero P&s23-75 ‘!:j:
18A0411Door side garnishSide air dam
0 Adhesive tapea Adhesive tape(Thickness 1 2 mm (047 In )>(.l 18 in.)>18A0912
(2) Using an infrared light or similar instrument, heat the
body painted surface and the side air dam.
Heating temperature
Body painted surface.. . . .
25-55OC (77- 131 OFI
Side air dam . . . . . . . . . . . . . . . . 25-40°C (77-104OF)
(3) Peel off the paper from the-adhesive tape, apply specified
adhesive and sealant at the places shown in the figure,and attach to the body adhesive surface.
Specified adhesive tape:
-3M. ATD Part No.6383 or
equivalent
(4) Using a hand roller or similar tool, apply pressure to theentire surface of the side air dam.
NOTEThe ends of the side air dam tend to loosen easily, so
apply manual pressure again.