brake pads replacement MITSUBISHI ENDEAVOR 2004 Service Repair Manual

The brake fluid level sensor is in good condition if there is no continuity when the
float surface is above "MIN" and if there is continuity when the float surface is
below "MIN".
Fig. 28: Checking Brake Fluid Level Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DISC BRAKE PAD CHECK AND REPLACEMENT NOTE: The brake pads (LH wheel) have indicators that contact the
brake disc when the brake pad thickness becomes 2 mm
(0.08 inch), and emit a squealing sound to warn the driver.
2004 Mitsubishi Endeavor LS
2004 BRAKES Basic Brake System - Endeavor

1. Check the brake pad thickness through the caliper body check port.
Standard value: 10.0 mm (0.39 inch)
Minimum limit: 2.0 mm (0.08 inch)
Fig. 29: Checking DISC Brake Pad And Replacement

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAUTION:
Whenever a pad must be replaced, replace both
LH and RH wheel pads as a set to prevent the
vehicle from pulling to one side when braking. If there is a significant difference in the
thicknesses of the pads on the left and right
sides, check the sliding condition of the piston
and slide pins.

2004 Mitsubishi Endeavor LS
2004 BRAKES Basic Brake System - Endeavor