audio MITSUBISHI GRANDIS 2008 Owner's Manual (in English)

Overview
Instruments and Controls (Instrument panel)
E00100102658
LHD
Multi centre display*
p. 3-15
Ventilators p. 5-2
Rear window demister
switch p. 3-45
Hazard warning flasher
switch p. 3-38
Ashtray (fixed position)
p. 5-54
Cup holder (for front seats)
p. 5-68 Gearshift or selector lever p. 4-23, 4-26
Parking brake lever p. 4-6
Cigarette lighter*
p. 5-55Supplemental restraint
system - air bag (for
front passenger’s seat)
p. 2-53
Front automatic air con-
ditioning p. 5-7
Audio p. 5-21 Instrument panel upper box p. 5-65
Heated seat switch* p. 2-8Front passenger’s air
bag ON-OFF switch
p. 2-59 Front passenger’s air
bag off indication
lamp p. 2-62Multi display station*
Refer to the separate
“Multi display station
owner’s manual”BK-XP08E1ENUK.en-uk.book Page 3 Monday, August 13, 2007 2:20 PM

Overview
RHD
Instrument panel upper box p. 5-65
Ventilators p. 5-2
Supplemental restraint
system - air bag (for
front passenger’s seat)
p. 2-53
Rear window demister
switch p. 3-45
Front passenger’s air bag
ON-OFF switch p. 2-59
Gearshift or selector lever
p. 4-23, 4-26
Ashtray (fixed position)
p. 5-54
Cup holder (for front seats)
p. 5-68
Heated seat switch* p. 2-8Hazard warning flasher switch p. 3-38
Parking brake lever p. 4-6Front automatic air
conditioning p. 5-7
Audio p. 5-21Multi centre display*
p. 3-15
Front passenger’s air
bag off indication lamp
p. 2-62 Multi display station*
Refer to the separate
“Multi display station
owner’s manual”
BK-XP08E1ENUK.en-uk.book Page 4 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-3
1
• Keep away from audio systems, personal computers,
TVs, and any other equipment that generates a magnetic
field.
• Do not wash with ultrasonic cleaners or similar equip-
ment.
• Do not leave the key where it may be exposed to high
temperature or high humidity.
●The engine is designed so that it will not start if the ID
code registered in the immobilizer computer and the key’s
ID code do not match. Refer to the section entitled “Elec-
tronic immobilizer” for details and key usage.
Keys should never be placed in areas which contain mag-
netic or metal objects as this may interfere with the trans-
ponder.
Electronic immobilizer
(Anti-theft starting system)
E00300201003
The electronic immobilizer is designed to reduce significantly
the possibility of vehicle theft. The purpose of the system is to
immobilize the vehicle if an invalid start is attempted. A valid
start attempt can only be achieved (subject to certain condi-
tions), using a key “registered” to the immobilizer system.NOTE●In the following cases, the vehicle may not be able to
receive the registered ID code from the key. This means
the engine will not start even when the registered key is
turned to the “START” position.
• When the key contacts a key ring or other metallic or
magnetic object (Type A)
• When the key grip contacts metal of another key
(Type B)
• When the key contacts or is close to other immobilizing
keys (including keys of other vehicles) (Type C)
In cases like these, remove the object or additional key
from the vehicle key and turn the key back to the “ACC”
or “LOCK” position. Then try again to start the engine.
If the engine does not start, we recommend you to con-
tact your MITSUBISHI MOTORS Authorized Service
Point.
BK-XP08E1ENUK.en-uk.book Page 3 Monday, August 13, 2007 2:20 PM

Seat and seat belts
2-39
2 Seat belt pre-tensioner system and force
limiter system
E00405700052
The driver’s seat and front passenger’s seat each have a seat
belt equipped with a pre-tensioner system.Pre-tensioner system
E00405800923
The pre-tensioner system will retract their respective seat belts
instantaneously, thus maximizing the seat belt’s effectiveness,
if there is a frontal impact severe enough to injure the driver
and/or front passenger and the ignition switch is in the “ON” or
“START” position.
The seat belt pre-tensioner includes the following components:
NOTE●The pre-tensioner seat belts will be activated if the vehicle
suffers a severe frontal impact, even if the seat belts are
not worn.
●The pre-tensioner seat belts are designed to work only
once. After the pre-tensioner seat belts have been acti-
vated, we recommend you to replaced by a MITSUBISHI
MOTORS Authorized Service Point.
1- Air bag control unit
2- Front impact sensor
3- Seat belt pre-tensioner
WARNING
!●To obtain the best results from your pre-tensioner
seat belt, make sure you have adjusted your seat
correctly and wear your seat belt properly.
CAUTION
!●Installation of audio equipment or repairs in the
vicinity of the pre-tensioner seat belts or floor con-
sole must be performed in line with MITSUBISHI
guidelines. It is important to do so because the work
could affect the pre-tensioner systems.●If you need to scrap the vehicle, please consult a
MITSUBISHI MOTORS Authorized Service Point.
It is important to do so because unexpected activa-
tion of the pre-tensioner seat belts could cause inju-
ries.
BK-XP08E1ENUK.en-uk.book Page 39 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-17
3
Digital clock
E00503700118
Following modes are available for digital clock adjustment:
●For vehicles with MITSUBISHI MOTORS genuine audio
automatic mode and manual mode
●Except for vehicles with MITSUBISHI MOTORS genu-
ine audio manual mode onlySelect the automatic mode or the manual mode by performing
the following operations:
1. Enter the function setup mode by pushing the “MENU”
button.
BK-XP08E1ENUK.en-uk.book Page 17 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-19
3
3. Make your selection by pressing the “ ” button or the
“ ” button.NOTE●After selecting a mode, you can leave the function setup
mode by taking either of the following steps:
• Press the “MENU” button for at least 2 seconds.
• Make no entry for 7 seconds.
Automatic mode (For vehicles with MITSUBISHI
MOTORS genuine audio)The automatic mode can set the local time automatically by
using the signal from the local RDS stations. In this mode, CT
(A) is shown in the display. Refer to “Radio data system
(RDS)” on page 5-29.
- CT ON (Automatic mode)
- CT OFF (Manual mode)
BK-XP08E1ENUK.en-uk.book Page 19 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-21
3
NOTE●The outside temperature can be displayed from -40 °C to
50 °C.
●The outside temperature displayed may differ from the
actual temperature on account of surrounding conditions,
driving conditions, etc.
●When the outside temperature is below -40 °C or over
50°C, the display will remain -40 °C or 50 °C.
Driving information
E00509000041
For vehicles with MITSUBISHI MOTORS genuine
audioThe momentary fuel consumption, average fuel consumption,
driving range and average speed can be displayed.
When the ignition switch is turned “ON”, the display shows the
4 items sequentially and returns to the original display that is
shown before the ignition switch was last turned “OFF”.NOTE●If the “DISP” button is pressed while the display is scroll-
ing through the sequence mentioned above, the display
stops scrolling and shows the item that was shown before
the ignition switch was last turned to the “OFF” position.Except for vehicles with MITSUBISHI MOTORS genu-
ine audioOnly the momentary fuel consumption can be displayed. Refer
to “Momentary fuel consumption” on page 3-22.
BK-XP08E1ENUK.en-uk.book Page 21 Monday, August 13, 2007 2:20 PM

3-22 Instruments and controls
3
Change of driving information (For vehicles with MIT-
SUBISHI MOTORS genuine audio)
E00509100068
Every time the “DISP” button is pressed lightly (less than
5 seconds), the display can be changed.
Momentary fuel consumption → Average fuel consumption →
Driving range → Average speed
Momentary fuel consumption
E00509200014
This value shows the momentary fuel consumption (in
L/100km, km/L or mpg). Calculation and indication of the
value begin when the vehicle speed rises above
6km/h(4mph).
BK-XP08E1ENUK.en-uk.book Page 22 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-29
3
Display unit selection
E00509700051
It is possible to change the units in which distance, fuel con-
sumption, and time are displayed.NOTE●Except for vehicles with MITSUBISHI MOTORS genu-
ine audio, only the unit of momentary fuel consumption
can be changed to km or miles.
1. Press and hold down button (A), then press the “M” but-
ton (B) within 1 second. A buzzer will sound, and the sys-
tem will allow units to be changed.2. Use the “H” button (C) or “M” button (B) to select the
desired speed unit, then press the “SET” button (D) to
enter the setting.
H - km
M - mile
BK-XP08E1ENUK.en-uk.book Page 29 Monday, August 13, 2007 2:20 PM

For pleasant driving
5-21
5 LW/MW/FM electronic tuning radio with CD player
E00708501019
The audio system can be used when the ignition switch is in the “ON” or “ACC” position.A- Display window
B- Audio system
BK-XP08E1ENUK.en-uk.book Page 21 Monday, August 13, 2007 2:20 PM