battery location MITSUBISHI L200 2004 Owner's Manual (in English)

STARTING AND DRIVING
5-35 If the lamp illuminates while
driving
(1) Since there will always be a possibility
of the vehicle becoming unstable
when brakes are applied rapidly, en-
sure that brakes are applied gently
and that high-speed driving is not at-
tempted. Furthermore, bring the vehi-
cle to halt in a safe location.
Restart the engine and check to see
whether the lamp goes out after a few
minutes driving. If it then remains off
during driving, there is no problem.
However, if the lamp does not go out
or if it lights up again when the vehicle
is driven, have the vehicle checked by
an authorized MITSUBISHI dealer as
soon as possible.
(2) After starting the engine using jumper
cables, if you attempt to start the vehi-
cle before the battery is sufficiently
charged, the engine will run irregu-
larly and the ABS warning lamp will il-
luminate indicating that the vehicle
should not be driven.
This situation, however, is caused
merely by insufficient battery voltage
and is not an abnormal situation.
If such a situation occurs, run the en-
gine at idle for some time to charge
the battery.
Limited-slip differential*
EC17A-Ha
A limited-slip differential is applied for the
rear wheel differential only. The features
of this limited-slip differential are de-
scribed below:
Just as with a conventional differential, the
wheel on one side is allowed to turn at a
different speed from the wheel on the
other side when the vehicle is cornering.
The difference between the limited-slip dif-
ferential and a conventional differential is
that if the wheel on one side of the vehicle
loses traction, a greater amount of torque
is applied to the rear wheel on the other
side to improve traction.
NOTE
Even if there is a difference in the amount
of traction the wheels can get, if both of
them are spinning, the limited-slip differ-
ential will not be effective. NOTE
(1) Immediately after the vehicle starts
moving after engine start up, a whin-
ing sound of a motor will be heard
from the engine compartment, and if
the brake pedal is depressed at that
moment, a pulsating is felt. These
sound and shock are due to the self-
diagnosis operation of the ABS and
does not indicate a malfunction.
(2) After driving on snowy roads, remove
any snow and ice which may have be-
come adhered to the wheel areas.
When doing this, be careful not to
damage the wheel speed sensors
and cables located at each wheel on
vehicles equipped with an ABS.
(3) The ABS becomes operative after the
vehicle has accelerated to a speed in
excess of approximately 10 km/h. It
stops operating when the vehicle de-
celerates to a speed below approxi-
mately 5 km/h.
I24A010
05engL2_240082_4 22-01-2004 13:05 Page 5-35