transmission fluid MITSUBISHI LANCER EVOLUTION IX 2005 Workshop Manual

ENGINE – SPECIAL TOOLS, ENGINE TUNING, CAMSHAFT, VALVE STEM SEAL11 - 4
Engine tuning
1. Checking revolutions when the engine is
idling
The standard revolutions for when the engine is idling have been
changed. Other servicing guidelines remain unchanged.
Standard revolutions: 800 ± 50 r/min
2. Checking compression pressure
The standard for compression pressure and the limit for
compression pressure have been changed. Other servicing
guidelines remain unchanged.
Standard compression pressure: 1000 kPa – 250 r/min
Compression pressure limit: 650 kPa – 250r/min
Camshaft, valve stem seal
Removal and fitting
Caution
1. If Brembo brake callipers are being used take care that they are not scratched by other components or tools
because there is a chance that the paint might peel off. In addition, if any brake fluid gets on the callipers, it
should be wiped off immediately.
2. Parts marked with * should be removed and then fitted for each cylinder in turn.
Jobs to be completed before removal and after fitting
• Removal and refitting of the undercover (Ref Section 51: Front bumper)
• Checking the tension of the drive belt (only after fitting)
• Draining and refilling of the coolant
• Removal and refitting of the air duct
• Removal and refitting of air pipe C
• Removal and refitting of the timing belt (refer to P11-20)
ToolNumberNameFunction
MB991454Engine hanger
balancerHolding the engine assembly while the
transmission assembly is removed/installed
Recommended
tools MZ203830
panzai or
MZ203831 safe
vehicle handlingMechanical engine
hanger
MB991928
A: MB991929
B: MB991930
C: MB991931
D: MB991932
E: MB991933
F: MB991934Engine hanger
A: joint (50) x2
B: joint (90) x2
C: joint (140) x2
D: Foot (standard) x4
E: Foot (short) x4
F: Chain and hook
ASSYSlide bracket (HI)