lock MITSUBISHI LANCER EVOLUTION VI 1999 Owner's Manual

MITSUBISHI LANCER EVOLUTION VI 1999 Owner's Manual LANCER EVOLUTION VI 1999 MITSUBISHI MITSUBISHI https://www.carmanualsonline.info/img/19/57324/w960_57324-0.png MITSUBISHI LANCER EVOLUTION VI 1999 Owner's Manual

Page 77 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-52
REMOVAL SERVICE POINTS
AOIL PAN REMOVAL
(1) Remove all oil pan bolts.
(2) Drive in the special tool between the cylinder block and
oil pa

Page 78 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-53
ECOUNTERBALANCE SHAFT REAR BEARING
REMOVAL
Using the special tool, remove the left counterbalance shaft
rear bearing from the cylinder bl

Page 79 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-54
CCOUNTERBALANCE SHAFT FRONT BEARING
INSTALLATION
Using special tools, install front bearing.
DCOUNTERBALANCE SHAFT OIL SEAL
INSTALLATIO

Page 80 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-55
GOIL PUMP DRIVEN GEAR / OIL PUMP DRIVE
GEAR INSTALLATION
Apply engine oil amply to the gears and line up the alignment
marks.
HFRONT CA

Page 81 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-56
(2) Secure the oil pump driven gear onto the left
counterbalance  shaft by tightening the flange bolt to
specified torque.
KPLUG INSTALLA

Page 88 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Piston and Connecting Rod11-63
CPISTON RING NO. 2 / PISTON RING NO. 1
INSTALLATION
(1) Using piston ring expander, fit No. 2 and then No. 1 piston
ring into position.
NOTE
1. The ring end

Page 89 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Piston and Connecting Rod11-64
(2) The connecting rod bearing identification mark is stamped
at the position shown in the illustration.
Crankshaft pinConnecting rod bearing
Classi-
fication

Page 92 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Crankshaft and Flywheel11-67
CRANKSHAFT AND FLYWHEEL
REMOVAL AND INSTALLATION
Apply engine oil to all
moving parts before
installation.
1 2
3
4 56
78 910 11 12
13 1415
25 Nm + 9011 Nm132 N

Page 93 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Crankshaft and Flywheel11-68
INSTALLATION SERVICE POINTS
ACRANKSHAFT THRUST BEARING INSTALLATION
(1) Install the two thrust bearing in the number 3 bearing
bore in the cylinder block. For

Page 94 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Owners Manual ENGINE – Crankshaft and Flywheel11-69
Crankshaft journal outside diameterCylinder block bearing boreCrankshaft bearing
Identification colorSize mmIdentification markIdentification mark or color
Yell