wheel bolts MITSUBISHI MIRAGE 2014 6.G Owners Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2014, Model line: MIRAGE, Model: MITSUBISHI MIRAGE 2014 6.GPages: 460, PDF Size: 20.86 MB
Page 364 of 460
6-24 For emergencies
6
6. Clean out any mud, etc. on the hub surface (F), hub bolts
(G) or in the installation holes (H) in the wheel, and then
mount the spare tire.
WA R N I N G
!Mount the spare wheel with the valve stem (I) facing
outward. If you cannot see the valve stem (I), you
have installed the wheel backwards.
Operating the vehicle with the spare wheel installed
backwards can cause vehicle damage and result in
an accident.
BK0162600US.book 24 ページ 2013年3月22日 金曜日 午後2時41分
Page 365 of 460
For emergencies
6-25
6
7. Install the wheel nuts with their tapered ends facing
inward, then tighten by hand until the wheel is no longer
loose.8. Lower the vehicle slowly until the tire touches the ground,
by rotating the wheel nut wrench counterclockwise.
CAUTION
!Never apply oil to either the wheel bolts or the nuts
or they will tighten too much.
Steel wheel
Aluminum wheel
BK0162600US.book 25 ページ 2013年3月22日 金曜日 午後2時41分
Page 366 of 460
6-26 For emergencies
6
9. Tighten the nuts in the order shown in the illustration until
each nut has been tightened to the torque listed here.
65 to 80 ft-lb (88 to 108 N•m)
10. Lower the jack all the way and remove it.11. Check the tire inflation pressure. The recommended tire
pressure for your vehicle is listed on the tire and loading
information placard attached to the driver’s door sill as
shown in the illustration. Refer to “Tire inflation pres-
sures” on page 7-23.
CAUTION
!Never use your foot or a pipe extension to apply
added force to the wheel nut wrench when tighten-
ing the wheel nuts. If you do so, you can over-tighten
the wheel nuts and damage the wheel, wheel nuts
and hub bolts.
BK0162600US.book 26 ページ 2013年3月22日 金曜日 午後2時41分
Page 424 of 460
7-50 Vehicle care and maintenance
7
Front fog lights
(if so equipped)
N00943600763
1. To create enough work space, turn the steering wheel all
the way in the direction opposite to the side you wish to
replace.
2. Remove the clips/bolts (A) to turn up the cover (B).3. While pressing the tab (C), pull out the connector (D).
4. Turn the bulb (E) counterclockwise to remove it.
BK0162600US.book 50 ページ 2013年3月22日 金曜日 午後2時41分