relay MITSUBISHI OUTLANDER PHEV 2014 Owner's Manual (in English)

2-Rear fog lamp (driver’s side): 21 W
(W21W)
Reversing lamp (passenger’s side): 21 W (W21W)
3- Licence plate lamps: 5 W (W5W) 4- Rear turn-signal lamps: 21 W (PY21W)
5- Stop and tail lamps

Codes in parentheses indicate bulb types.NOTEl The following lamps are not possible to re-
pair or replace only the bulb.
If you need to repair or replace these lamp
bulbs, contact a MITSUBISHI MOTORS
Authorized Service Point.
• Side turn-signal lamps
• High-mounted stop lamp
• Stop and tail lampsInside
E01003401912
1- Luggage room lamp: 8 W
2- Room lamp (rear): 8 W
3- Map & room lamps (front): 8 W
4- Downlight
5- Vanity mirror lamps: 2 W
6- Glove box lamp: 1.4 W
NOTEl An LED, not a bulb, is used in the down-
light. Contact a MITSUBISHI MOTORS
Authorized Service Point when there is a
need for repair or replacement.Headlamps (low beam, halogen
bulb)
E01009301421
1. When replacing the bulb on the left side
of the vehicle, remove the bolt (A) hold-ing down the relay box and move the re-
lay box.
*: Front of the vehicle
Replacement of lamp bulbs
11-24OGGE14E5Maintenance11

4.To install the bulb, perform the removal
steps in reverse.Position lamps
E01003702231
When replacing the bulb on the left side of the vehicle, move the relay box.
(Refer to “Headlamps (low beam, halogen
bulb): Step 1” on page 11-25)
Except for vehicles equippedwith high intensity discharge
headlamps
1. Turn the cap (A) anticlockwise to re-
move it.
*: Front of the vehicle
2. Pull out the socket (B), and then pull the
bulb out of the socket.
3. To install the bulb, perform the removal
steps in reverse.
Vehicles equipped with high in-
tensity discharge headlamps
1. Turn the socket (A) anticlockwise to re-
move it, and then pull the bulb out of the
socket.
*: Front of the vehicle
2. To install the bulb, perform the removal
steps in reverse.
Replacement of lamp bulbs
11-26OGGE14E5Maintenance11