headlamp MITSUBISHI SHOGUN 2008 Owner's Manual (in English)

Overview
Instruments and Controls (Driver’s area)
E00100102052
Electric remote-controlled outside rear-view mirror switch p. 4-11
Front fog lamp switch* p. 3-66 Rear fog lamp switch p. 3-67
Combination headlamps and dipper switch p. 3-58 Turn-signal lever p. 3-65 Headlamp washer switch* p. 3-76
Supplemental restraint system-airbag (for driver’s seat) p. 2-58 Horn switch p. 3-78
Instruments p. 3-2
Windscreen wiper and washer switch p. 3-68 Rear window wiper and washer switch p. 3-75
Daytime dipper button (meter illumination control) p. 3-9
Cruise control switch* p. 4-70
Fuse box lid p. 8-29
Bonnet release lever p. 8-3
Ignition switch p. 4-14
Fuel tank filler door release lever p. 3
LHD
Hazard warning flasher switch p. 3-66
Active stability control switch p. 4-63
Steering wheel height adjustment p. 4-8
Audio switch* p. 5-70 Sonar cancel switch* p. 4-78
Headlamp levelling switch* p. 3-62
BK-BK2008E1ENUK.en-uk-Section2.fm Page 1 Wednesday, January 9, 2008 4:26 PM

Overview
Electric remote-controlled outside rear-view mirror switch p. 4-11
Combination headlamps and dipper switch p. 3-58Turn-signal lever p. 3-65 Headlamp washer switch* p. 3-76
Supplemental restraint system-airbag (for driver’s seat) p. 2-58 Horn switch p. 3-78
Instruments p. 3-2
Windscreen wiper and washer switch p. 3-68Rear window wiper and washer switch p. 3-75
Daytime dipper button (meter illumination control) p. 3-9
Cruise control switch* p. 4-70 Fuse box lid p. 8-29
Bonnet release lever p. 8-3
Ignition switch p. 4-14
Fuel tank filler door release lever p. 3
Headlamp levelling switch* p. 3-62
Front fog lamp switch* p. 3-66Rear fog lamp switch p. 3-67
RHD
Steering wheel height adjustment p. 4-8
Hazard warning flasher switch p. 3-66 Active stability control switch p. 4-63 Audio switch* p. 5-70 Sonar cancel switch* p. 4-78
BK-BK2008E1ENUK.en-uk-Section2.fm Page 2 Wednesday, January 9, 2008 4:26 PM

Overview
Outside (Front)
E00100502434
Front fog lamps* p. 3-66, 8-36, 8-42
Engine compartment p. 9-16 Bonnet p. 8-3
Windscreen wiper and washer p. 3-68
Headlamps p. 3-58, 8-36, 8-38
Electric window control p. 1-16
Outside rear-view mirrors p. 4-11 Approach lamps* p. 1-12
Sunroof* p. 1-21
Front turn-signal lamps p. 3-65, 8-36, 8-41
Side turn-signal lamps* p. 3-65
Position lamps p. 3-58, 8-36, 8-41
Locking and unlocking p. 1-7 Keyless entry system* p. 1-5
Rear side/quarter window p. 1-20 Antenna p. 5-77
Headlamp washer* p. 3-76
Rain sensor* p. 3-71
BK-BK2008E1ENUK.en-uk-Section2.fm Page 8 Wednesday, January 9, 2008 4:26 PM

3
Instruments and controls
Instruments. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3- 2 Indicator and warning lamps . . . . . . . . . . . . . . . . .3- 10Indicator lamps. . . . . . . . . . . . . . . . . . . . . . . . . . . .3- 12Warning lamps . . . . . . . . . . . . . . . . . . . . . . . . . . . .3- 13Centre information display* . . . . . . . . . . . . . . . . .3- 17Combination headlamps and dipper switch . . . . . .3- 58Headlamp levelling . . . . . . . . . . . . . . . . . . . . . . . .3- 62Turn-signal lever . . . . . . . . . . . . . . . . . . . . . . . . . .3- 65Hazard warning flasher switch. . . . . . . . . . . . . . . .3- 66Fog lamp switch . . . . . . . . . . . . . . . . . . . . . . . . . . .3- 66Wiper and washer switch . . . . . . . . . . . . . . . . . . . .3- 68Wiper deicer switch* . . . . . . . . . . . . . . . . . . . . . . .3- 77Rear window demister switch . . . . . . . . . . . . . . . .3- 77Horn switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3- 78
BK-BK2008E1ENUK.en-uk-Section6.fm Page 1 Wednesday, January 9, 2008 4:32 PM

3-10 Instruments and controls
3
Indicator and warning lamps
E00501501353
1- Turn-signal indication lamps/Hazard warning indication
lamps
→ p. 3-12
2- Rear fog lamp indication lamp
→ p. 3-12
3- Position lamp indication lamp
→ p. 3-12
4- Front fog lamp indication lamp*
→ p. 3-12
5- Automatic headlamp levelling warning lamp*
→ p. 3-64
6- High-beam indication lamp
→ p. 3-12
7- Active stability control function OFF indication lamp
→ p. 4-67
8- Active stability control function indication lamp/Active trac-
tion control function indication lamp
→ p. 4-67, 4-69
9- Anti-lock brake system (ABS) warning lamp
→ p. 4-60
10- Brake warning lamp
→ p. 3-13
11- Supplemental restraint system (SRS) warning lamp
→ p. 2-75
12- Seat belt warning lamp
→ p. 2-40
13- A/T fluid temperature warning lamp (vehicles with A/T)
→ p. 4-31
14- CRUISE indication lamp*
→ p. 4-72
15- “SONAR OFF” indication lamp*
→ p. 4-84
16- Diesel particulate filter (DPF) warning lamp*
→ p. 4-22
17- Diesel preheat indication lamp (diesel-powered vehicles)
→ p. 3-12
18- Fuel filter indication lamp (diesel-powered vehicles)
→ p. 3-13
19- Check engine warning lamp
→ p. 3-15
20- Charge warning lamp
→ p. 3-16
21- Oil pressure warning lamp
→ p. 3-16
22- Low fuel warning lamp
→ p. 3-8
23- 2WD/4WD operation indication lamp
→ p. 4-38
BK-BK2008E1ENUK.en-uk-Section6.fm Page
10 Wednesday, January 9, 2008 4:32 PM

3-58 Instruments and controls
3
Combination headlamps
and dipper switch
E00506001353
HeadlampsNOTE●
Do not leave the lights on for a long time while the engine is stationary (not running). A run-down battery could result.
●
When it rains, or when the
vehicle has been washed, the
inside of the lens sometimes becomes foggy, but this does not indicate a functional pr
oblem. When the lamp is
switched on, the heat will
remove the fog. However, if
water gathers inside the lamp, we recommend you to have it checked.
Type 1Rotate the switch to turn on the lamps.OFF All lamps off
Position, tail, licence plate and instrument panel lamps on Headlamps and other lamps go on
BK-BK2008E1ENUK.en-uk-Section6.fm Page
58 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-59
3
Type 2Rotate the switch to turn on the lamps.
NOTE●
The sensitivity of the automatic on/off control can be adjusted. For further information, we recommend you to consult a MITSUBISHI MOTORS Auth
orized Service Point.
●
When the headlamps are turned off by the automatic on/off control with the ignition switch in the “ON” posi- tion, the front fog lamps (if so equipped) and rear foglamps also go off. When the headlamps are subsequently turned back on by the automatic on/off control, the front fog lamps also come on but the rear fog lamps stay off. Ifyou wish to turn the rear fo
g lamps back on, operate the
switch again.
●
Do not cover the sensor (A) for the automatic on/off con- trol by affixing a sticker or label to the windscreen.
OFF All lamps off AUTO
With the ignition switch in the “ON” position, head- lamps, position, tail, licence plate, and instrument panel lamps turn on and off automatically in accord-ance with outside light level. All lamps turn off auto-matically when the ignition switch is turned to the “OFF” position. Position, tail, licence plate and instrument panel lamps on Headlamps and other lamps go on
BK-BK2008E1ENUK.en-uk-Section6.fm Page
59 Wednesday, January 9, 2008 4:32 PM

3-60 Instruments and controls
3
●
If the lamps do not turn on or off with the switch in the “AUTO” position, manually operate the switch and we recommend you to have your vehicle checked.
Daytime running lamp
*
When the ignition switch is in the “ON” position and the lamp switch is set to the “OFF” position, the low beam of the head-lamps, tail lamps, etc., will illuminate.Lamps (headlamps, fog lamps, etc.) auto-cutout function●
If the ignition key is turned to “LOCK” or “ACC” posi- tion or removed from the ignition switch, and without opening the driver’s door for 3 minutes while the lamp switch in the “ ” position, the lamps will turn off auto- matically.
●
If the ignition key is turned to “LOCK” or “ACC” posi- tion or removed from the ignition switch and the driver’s door is opened within 3 minutes while the lamp switch in the “ ” position, a buzzer will sound to warn the driver that the lamps have not been turned off, and these lamps will automatically turn off.
NOTE●
The lamp auto-cutout will not function when the lamp switch is in the “ ” position.
●
When the ignition key has b
een turned to either the
“LOCK” or “ACC” position or removed from the ignition switch with the lamp switch in the “ ” position, and the lamp switch is returned to the “OFF” position within approximately 3 minutes, the auto-cutout function will notbe activated.
When you want to keep the lamps on●
Turn the lamp switch in the “OFF” position while the ignition key is in the “LOCK” or “ACC” position.
●
Turn on the lamps with the switch in the “ ” or “ ” position again, then the lamps will remain on.
●
Remove the ignition key.
NOTE●
For further information, we recommend you to consult MITSUBISHI MOTORS Authorized Service Point.
Lamp monitor buzzer
E00506100256
If the driver’s door is opened when the ignition key is in the“LOCK” or “ACC” position or removed from the ignitionswitch while the lamps are on,
a buzzer will sound to remind
the driver to turn off the lamps. When the lamp auto-cutout func
tion acts, the buzzer will stop
automatically.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
60 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-61
3
Dipper (High/Low beam change)
E00506200055
When the lamp switch is in the “ ” position, the beam changes from high to low (or low
to high) each time the lever is
pulled fully (1). While the high b
eam is on, the high beam indi-
cation lamp in the instrument cluster will also illuminate.
Headlamp flasher
E00506300128
The high beams flash when the lever is pulled slightly to (2), and will go off when it is released. When the high beam is on, th
e high beam indication lamp in
the instrument cluster will illuminate.NOTE●
The high beams can also flash when the lamp switch is OFF.
●
If you turn the lamps off with the headlamps set to high beam, the headlamps are automa
tically returned to their
low-beam setting when the lamp
switch is next turned to
the “ ” position.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
61 Wednesday, January 9, 2008 4:32 PM

3-62 Instruments and controls
3
Headlamp levelling
E00517400015
Headlamp levelling switch*
E00517500133
Except for vehicles with discharge headlampsThe angle of the headlamp beam varies depending upon the load carried by the vehicle. The headlamp levelling dial can
be used to adjust the headlamp
illumination distance (when the lower beam is illuminated) sothat the headlamps’ glare does
not distract other drivers.
Set the dial according to
the following table.
NOTE●
When adjusting the beam position, first put the dial in the “0” position (the highest beam position).
CAUTION
!●
Always perform adjustments before driving. Do not attempt to adjust while driving, as it could cause an accident.
LHD RHD
BK-BK2008E1ENUK.en-uk-Section6.fm Page
62 Wednesday, January 9, 2008 4:32 PM