REAR DISC BRAKE (CL14H, CL14HB) - Caliper
1 Remove piston by turning it counterclockwise
with suitable long nose pliers.
SBR646
i--/
2 Pry off ring from piston and remove adjusting
nut
SBR648
3 Disassembly cylinder body
(1) Pry off ring A with suitable pliers, then remove
spring cover, spring and seat
SBR651
rnbly
(2) Pry off rmg B, then remove key plate, push rod
and rod
(3) Removepi Bn seal
Be careful not to damage cylinder body
4. Remove return spring and lever
SBR663
SBR656
SBR657
BR-I 4
REAR DISC BRAKE (CL14H, CL14HB) - Caliper
CAUTION:
Use brake fluid to clean Never use mineral oil
CYLINDER BODY
Check inside surface of cylinder for score, rust,
wear,
damage or presence of foreign materials
If any of the above conditions are observed,
replace cylinder body
Minor damage from
rust of foreign materials
may be eliminated by polishing surface with
a
fine emery paper Replace cylinder body if
necessary
TORQUE MEMBER
Check for wear, cracks or other damage Replace if
necessary
PISTON
Check piston for score, rust, wear, damage or
presence of foreign materials Replace
if any of the
above conditions are observed
CAUTION.
Piston sliding surface IS plated. Do not polish with
emery paper even
if rust or foreign matter is stuck
to sliding surface.
PIN AND PIN BOOT
Check for wear, cracksor other damage Replace if
any of the above conditions are observed
Assembly
Install cup securely in the specified direction
Adjust nu1
SBR849
Fit push rod into square hole in key plate Also
fit convex portion of key plate with concave
portion of cylinder
onvex portmn
v SBRB42
Install ring B with suitable tool
Rmg B
Key plate
Push rod
S0R843
Install seat, spring, spring cover and ring A with
suitable press and
drift.
Ring A-
Spring cover-
Seat-
BR-15
