ECU NISSAN 300ZX 1984 Z31 Rear Suspension Workshop Manual

DRIVE SHAFT-'"Tripod-Tripod" Type
Inspection
DRIVE SHAFT
Check for cracks or other damage Replace if
necessary
TRIPOD JOINT
Check spider assembly for bearing and washer
damage Replace spider assembly if necessary
Check slide joint housing and housing sub-
assembly for any damage Replace if necessary
Assembly
After drive shaft has been assembled, ensure
that
it moves smoothly over its entire range
without binding
Use NISSAN GENUINE GREASE or equiva-
lent after every overhaul
WHEEL SIDE
Be careful not to scratch boot with drive shaft
serration.
Install spider assembly.
1) Place drive shaft in a vise, using soft cushioning
pads.
2) Install spider assembly securely, ensuring marks
are properly aligned
Press-fit with spider assembly serration chamfer
facing shaft.
* k
Sultable tool
Chamfer
3) Stake serration portion evenly at three places
Avoid
areas which have been previously staked
Always stake
two or three teeth at each place.
Stake more than 1 mm (0.04 in)
More than 1 mm 10.04 m)
SFAd22