brake rotor NISSAN 350Z 2007 Z33 Road Wheels And Tires Workshop Manual

WT-8
ROAD WHEEL TIRE ASSEMBLY
Revision: 2006 November2007 350Z
c. If calculated balance weight value exceeds 50 g (1.76 oz), install
two balance weight sheets in line with each other (as shown in
the figure).
CAUTION:
Do not install one balance weight sheet on top of another.
3. Start tire balance machine again.
4. Install drive-in balance weight on inner side of road wheel in the
tire balance machine indication position (angle).
CAUTION:
Do not install more than two balance weights.
5. Start tire balance machine. Make sure that inner and outer resid-
ual unbalance values are 5 g (0.17 oz) each or below.

If either residual unbalance value exceeds 5 g (0.17 oz), repeat installation procedures.
Wheel balance (Maximum allowable unbalance):
Tire RotationNES00019
CAUTION:

Do not include the T-type spare tire when rotating the tires.

Use NISSAN genuine wheel nuts for aluminum wheels.
NOTE:
Tire cannot be rotated in vehicle, as front tire are different size from rear tire and the direction of wheel rotation
is fixed in each tire.
DESCRIPTION
Safety Device Preventing from Being Incorrectly Installed
Front brake disc rotor and front wheel

Front and rear wheel size for this model differs, therefore a special pin has been installed on the front
brake disc rotor. To accommodate this pin a hole has been provided on the front wheel (the rear wheel
does not have this hole.) and in some case the rear wheel is being mistakenly installed on the front.
Maximum allowable
unbalanceDynamic (At rim flange) 5 g (0.17 oz) (one side)
Static (At rim flange) 10 g (0.35 oz)
SMA056D
SEIA0316E