engine NISSAN GT-R 2015 R35 Owner's Manual

0-10Illustrated table of contents
1. Trip A/B reset switch (P.�f-6)
�f. Spee�bometer (P.�f-6)
3. Tachometer (P.�f-7)/Upshift in�bicator (P.�f-9)
4. Transmission position in�bicator (P.�f-9)
5. Engine coolant temperature gauge (P.�f-7)
6. ENTER switch (P.�f-15)7. Instrument brightness control switch (P.�f-11)
8. Vehicle information �bisplay (P.�f-1�f)
9. O�bometer/twin trip o�bometer (P.�f-6)
10. Fuel gauge (P.�f-8)
11. NEXT switch (P.�f-15)
NOTE:
.
Meters and gauges will illuminate
when the ignition switch is pushed to
the ON position.
. The needle indicators may move
slightly after the ignition switch is
pushed to the OFF position. This does
not indicate that there is a malfunction.
METERS AND GAUGES

1. Fuse/fusible link holder (P.�f-24�b
2. Battery (P.�f-17�b
3. Engine oil filler cap (P.�f-13�b
4. Engine oil dipstick (P.�f-13�b
5. Brake fluid reservoir (P.�f-15�b
6. Air cleaner (P.�f-21�b7. Power steering fluid reservoir (P.�f-14�b
�f. Radiator filler cap (P.�f-10�b
9. Coolant reservoir cap (pressure type�b (P.�f-10�b
10. Coolant reservoir (P.�f-10�b
11. Window washer fluid reservoir (P.�f-16�b ITEMS GT-R SPECIFIED FLUIDS
Engine oil Mobil 1 (0W-40�b*1
Transmission oil Genuine NISSAN Transmission
Oil R35 Special
Differential oil
(front and rear�b Differential Oil R35 COMPE-
TITION type 21�f9E
Brake fluid Genuine NISSAN Brake Fluid
R35 Special II*2
*1: Mobil 1 (0W-40�b (100% synthetic�b is the factory fill oil. The VR3�f engine with its plasma-sprayed
bores was developed using this oil. NISSAN
cannot ensure proper engine operation and
durability if other 0W-40 synthetic oil is used.
If Mobil 1 (0W-40�b is not available, Mobil 1
(10W-40�b (100% synthetic�b may be used;
however, some performance loss may be
noticed.
*2: Genuine NISSAN Brake Fluid R35 Special II is the factory fill brake fluid. The Vehicle Dynamic
Control (VDC�b unit and other related parts were
specially designed for this brake fluid and
NISSAN cannot ensure proper operation of the
vehicle if other brake fluid is used.
Illustrated table of contents0-11
ENGINE COMPARTMENT

0-12Illustrated table of contents
Warninglight Name
Page
All-Wheel Dri�fe (AWD) warning
light 2-2�b
Anti-lock Braking System
(ABS) warning light2-26
Brake warning light
2-26
Charge warning light2-27
Engine oil pressure warning
light2-27
Intelligent Key warning light 2-27
Low tire pressure warning light 2-27
Master warning light
2-29
Seat belt warning light 2-29
Supplemental air bag warning
light2-29
Transmission warning light 2-30 Warning
light Name
Page
Vehicle Dynamic Control (VDC)
warning light 2-31Indicator
light Name
PageCruise main switch indicator
light 2-31
Cruise set switch indicator light 2-31
Exterior light indicator
2-31
Front passenger air bag status
light2-31
High beam indicator light 2-31
Malfunction Indicator Light
(MIL)2-31
Turn signal/hazard indicator
lights2-32
Vehicle Dynamic Control (VDC)
off indicator light2-32
WARNING AND INDICATOR LIGHTS

FRONT SEATS
Front power seat adjustment
Operating tips
.The power seat motor has an auto-reset
overloa\f protection circuit. I\b the motor
stops \furing operation, wait 30 secon\fs,
then reactivate the switch.
. Do not operate the power seat switch \bor a
long perio\f o\b time when the engine is o\b\b.
This will \fischarge the battery.
Safety — Seats, seat belts and supplemental restraint system1-3

1. Trip A/B reset switch (P.2-�f)
2. Speed�bmeter (P.2-�f)
3. Tach�bmeter (P.2-7)/Upshift indicat�br (P.2-9)
4. Transmissi�bn p�bsiti�bn indicat�br (P.2-9)
5. Engine c�b�blant temperature gauge (P.2-7)
�f. ENTER switch (P.2-15)7. Instrument brightness c�bntr�bl switch (P.2-11)
8. Vehicle inf�brmati�bn display (P.2-12)
9. Od�bmeter/twin trip �bd�bmeter (P.2-�f)
10. Fuel gauge (P.2-8)
11. NEXT switch (P.2-15)
NOTE:
.
Meters and gauges will illuminate
when the ignition switch is pushed to
the ON position.
. The needle indicators may move
slightly after the ignition switch is
pushed to the OFF position. This does
not indicate that there is a malfunction.
Instruments and controls2-5
METERS AND GAUGES

RESET switch for more than 1 second\f
NOTE:
When the battery is disconnected, the
memory for trips
&Aand&Bis erased,
and both return to zero.
TACHOMETER
The tachometer indicates the engine speed in
revo\butions per minute (rpm) \f Do not rev the
engine into the red zone
*1\f
NOTICE
When engine speed approaches the red
zone, shift to a higher gear or reduce
engine speed. Operating the engine in
the red zone may cause serious engine
damage.
ENGINE COOLANT TEMPERATURE
GAUGE
The gauge indicates the engine coo\bant tem-
perature\f
The engine coo\bant temperature is within the
norma\b range when the gauge need\be points
within the zone
*1shown in the i\b\bustration\f
The engine coo\bant temperature varies with the
outside air temperature and driving conditions\f
Instruments and controls2-7

2-8Instruments and controls
NOTICE
If the gauge indicates engine coolant
temperature near the hot (H) end of the
normal range, reduce vehicle speed to
decrease temperature. If gauge is over
the normal range, stop the vehicle as
soon as safely possible. If the engine is
overheated, continued operation of the
vehicle may seriously damage the en-
gine. (
“If your vehicle overheats”
page 6-8)
FUEL GAUGE
The gauge indicates the approximatefuel level
in the tank�f
The gauge may move slightly du�bing b�baking,
tu�bning, accele�bation, o�b going up o�b down hills�f
The gauge needle �betu�bns to E (Empty) afte�b the
ignition switch is pushed to the LOCK position�f
Refill the fuel tank before the gauge
registers “E” (Empty) .
The low fuel wa�bning will be indicated on the
vehicle info�bmation display when the fuel tank is
getting low�f Refuel as soon as it is convenient,
p�befe�bably befo�be the gauge �beaches “E”�f The�be
will be a small �bese�bve of fuel in the tank when the fuel gauge needle �beaches “E”�f (
“Low
fuel wa�bning” page 2-40)
The
indicates that the fuel-fille�b doo�b is
located on the passenge�b’s side of the vehicle�f
(
“Fuel-fille�b doo�b” page 3-24)
NOTE:
If the vehicle runs out of fuel, the
Malfunction Indicator Light (MIL) may
come on. Refuel as soon as possible. After
a few driving trips, the
light should
turn off. If the light remains on after a few
driving trips, have the vehicle inspected by
a GT-R certified NISSAN dealer.
(
“Malfunction Indicator Light (MIL)”
page 2-31)

TRANSMISSION POSITION INDICA-
TOR
The transmission position indicator indicates the
gear positions.
The indicator blinks i\f it is not possible to shi\ft
the gear when in the
&Mposition.
1. Upshi\ft indicator \bgreen)
2. Upshi\ft indicator \byellow)
3. Upshi\ft indicator \bred)
UPSHIFT INDICATOR
When the upshi\ft indicator is set to on, the
indicators on the tachometer will illuminate to
help upshi\ft at a constant engine speed \from any
gear or to warn the driver o\f over-revving.
The upshi\ft indicator operates only when the
shi\ft lever is in the
&Mposition. This \function
consists o\f two modes that can be selected on
the vehicle in\formation display: AUTO setting
and MANUAL setting.
Instruments and controls2-9

to go to ALERT > UPSHIFT. The c�frrent
st�bt�fs of the �fpshift indic�btor will be shown on
the UPSHIFT screen. Note th�bt the f�fnction is
set to AUTO �bs the f�bctory def�b�flt setting.
To ch�bnge the �fpshift indic�btor mode, choose
SETTING on the UPSHIFT screen. Set one of
the following modes by p�fshing the NEXT
switch
, �bnd then p�fsh ENTERto
complete.
. AUTO
. 3,000 to 6,300 RPM (MANUAL)
. OFF
The n�fmber will incre�bse by 100 RPM. To
incre�bse the n�fmber by 500 RPM, p�fsh �bnd
hold the NEXT switch
.
Example
When the maximum engine speed is
desired:
Set the �fpshift indic�btor to AUTO. The yellow
indic�btor ill�fmin�btes �bpproxim�btely 700 RPM
before the red zone, �bnd the red indic�btor
ill�fmin�btes j�fst before the red zone.
When the maximum engine torque is
desired:
Set the fig�fre �bt 6,000 RPM. The green
indic�btor st�brts fl�bshing from �bpproxim�btely 5,500 RPM �bnd ill�fmin�btes �bt 6,000 RPM.
When breaking-in the vehicle:
To help �bvoid high engine speeds d�fring bre�bk-
in, set the �fpshift indic�btor to less th�bn 3,500
RPM. The green indic�btor st�brts fl�bshing �bp-
proxim�btely 500 RPM before the set fig�fre �bnd
ill�fmin�btes from the set fig�fre. (
“Bre�bk-in
sched�fle” p�bge 5-39)
NOTE:
. There may be a slight difference be-
tween the timing of the upshift indica-
tor illumination and the tachometer
indication.
. When the battery terminal is discon-
nected, the set memory will be erased
and the mode returns to the default.
INSTRUMENT BRIGHTNESS CON-
TROL
The instr�fment brightness c�bn be �bdj�fsted
when the ignition switch is in the ON position.
P�fsh the switch to �bdj�fst the brightness �fp
*1
or down*2. The brightness level is shown on
the vehicle inform�btion displ�by.
When the he�bdlights �bre on, the brightness of
the interior switches is �blso �bdj�fsted �bt the s�bme
time.
Instruments and controls2-11

2-12Instruments and controls
NOTE:
.The instrument brightness can be ad-
justed separately for daytime and
nighttime conditions. The adjusted set-
tings are automatically stored.
. When the battery terminal is discon-
nected, the set memory will be erased
and the setting returns to the default. The vehicle information dis�flay can dis�flay the
following information�b
.
Engine oil level dis�flay
. Transmission system check dis�flay
. Instrument brightness control level dis�flay
(
“Instrument brightness control” �fage
2-11)
. Drive com�futer
(
“Drive com�futer” �fage 2-15)
. Warning dis�flay
(
“Warning dis�flay” �fage 2-33)
. O�feration dis�flay
(
“O�feration dis�flays” �fage 2-43)
. Cruise control dis�flay
(
“Cruise control” �fage 5-34)
ENGINE OIL LEVEL DISPLAY
When the ignition switch is �fushed to the ON
�fosition, the engine oil status before starting the
engine is indicated as illustrated�b
When the oil level is normal
“OIL LEVEL OK” is dis�flayed�b Push the dis-
�flayed LEVEL switchto check the oil level�b
VEHICLE INFORMATION DISPLAY