TPMS NISSAN GT-R 2017 R35 Warranty Booklet

TIRE PRESSURE MONITORING SYSTEM (TPMS)
A tire pressure-monitoring system (TPMS) is a safety
system found in most vehicles manufactured after
2005. There are pressure sensing transmitters mounted
inside of each tire that sends readings to the central
computer (ECU) in your vehicle. The TPMS system will
alert you when one or more of your tires are underin-
flated by 25% or more by turning on a warning light on
your vehicle’s dashboard or heads up display (HUD)
screen. This means that one or more of your tires may
have a low-pressure condition. Follow the instructions
in your owner’s manual.
ROTATION and WEAR
**
Falken recommends rotating your tires at least every
8,000km (5,000 miles) and periodically inspecting your
tires to make sure they are free of road hazards (such as
nails, screws, large wood splinters, etc.) that might
penetrate your tires causing them to lose air pressure
and to ensure they are wearing evenly. Common irregu-
lar wear patterns are: misalignment wear, where the tire
shows excessive outer or inner tread wear. Tire side-
walls should also be inspected for cuts, snags, bruises,
and weather cracking. If any of these noted conditions
are present during inspection, we recommend returning
to your servicing tire dealer to be corrected to ensure
long tire life.TIRE REPLACEMENT
Falken recommends replacing your tires when the tread
wears down to the wear bars at 1.6mm (2/32 of an
inch) , which are located across the tread in several
locations around the tire. If only two tires are being
replaced, the two new tires should always be installed
on the rear of the vehicle to aid in preventing your
vehicle from hydroplaning, even if your car is front wheel
drive. It’s always recommended to have your new tires
balanced during installation, and alignment checked if
the previous tires show and irregular wear. Tires that
have been in use for 5 (five) years or more should
continue to be inspected by a qualified tire specialist, at
least annually. It is recommended that any tires 10 (ten)
years old or older from the date of manufacture, includ-
ing spare tires, be replaced with new tires as a precau-
tion even if such tires appear serviceable and even if
they have not reached the legal worn out limit at 1.6mm
(2/32 of an inch) .
TIRE REPAIRS
In the event that you get a flat tire while driving, it is best
to find a nearby, safe place to stop and install your spare
tire or call a tow truck. The less distance that you drive
on your low or flat tire, the better chances your tire has of
being repairable. Once you are able to get to your local
servicing tire dealer, have them dismount the tire from
the rim and thoroughly inspect the inside of the tire. It is
important to know the difference between a proper tire
repair and an improper one because it can be critical to
you and your vehicle’s safety. An improper repair could
pose a safety threat to you and your family and couldalso affect your tire’s manufacturer warranty. Here are
some tips in determining if your damaged tire can be
properly repaired or not:
●Always have the tire removed from the wheel and
inspected before any repair is performed.
●Tires with less than 1.6mm (2/32 of an inch) of tread
should NOT be repaired.
●Never repair a tire with a puncture larger than 6mm
(1/4 of an inch) .
●Repairs should be limited to the tread area only.
●Repairs cannot overlap one another.
●A plug and patch or plug/patch combo should be
used to effectively repair a tire puncture.
●If anything seems questionable at any time during the
repair process, ask your service advisor for more
details and/or call the tire manufacturer to make sure
the tire’s warranty isn’t being voided.
TIRE MIX USAGE
WARNING
SAFETY WARNING
Never mix tires of different size or con-
struction and/or type on any axle. (Except
for temporary use as a spare tire.) Always
refer to the vehicle’s owner manual for
proper tire fitments.
(Continued on next page)
** Never include a temporary spare tire in your rotation pattern
FALKEN TIRE LIMITED WARRANTY 53