NISSAN LEAF 2011 Owners Manual

— Do not use if a malfunctionoccurs or if charger has been
damaged in any manner. Return
to a NISSAN certified LEAF deal-
er for replacement.
— The charger contains no user serviceable parts. Do not at-
tempt to repair the charger,
doing so will void your warranty.
CAUTION
. Only charge using a standard 110 -
120 volt, 15A dedicated electrical
outlet (For example do not use an
electric generator) . Failure to do so
may cause charging to fail and could
cause damage to the Li-ion battery
charging equipment due to power
surges.
. NISSAN recommends using genuine
NISSAN charging equipment to
charge the vehicle. Using non-
NISSAN equipment could cause
the Li-ion battery to not charge
correctly and may damage the Li-
ion battery.
. Trickle charging is performed using an AC
110 - 120 volt, 15A dedicated electrical
outlet using the EVSE (Electric Vehicle
Supply Equipment) provided with the vehi-
cle.
. The genuine NISSAN EVSE (Electric Vehi-
cle Supply Equipment) charging equipment or trickle charge cable performs a commu-
nication function with the vehicle before Li-
ion charging starts. If this communication
does not occur because other equipment is
used, the Li-ion battery will not charge.
. Immediate charge, charging timer and re-
mote charge can be performed in the trickle
charge mode. See “Charging timer” and
“Charging related remote function” later in
this section.

4. Store in its case.NOTE:
Perform the following procedure to
store the EVSE (Electric Vehicle Supply
Equipment) in the case.
a. Wind the charge cable into a sizethat will allow it to be stored in the
case (approximately 9.8 in (250 mm)
in diameter) .
b. Place the EVSE (Electric Vehicle Supply Equipment) control box into
the back of the case.
c. Place the charge cable and charge connector into the case in front of the EVSE (Electric Vehicle Supply
Equipment) control box.
WARNING
WARNING
.
Always use a quick charger that is
compatible with the LEAF. Using an
incompatible quick charger may
cause a fire or malfunction resulting
in serious personal injury or death.
. Before starting the quick charge,
carefully read the instructions pro-
vided on the quick charger and
make sure the quick charge con-
nector is properly connected and
locked. Failure to connector or op-
erate the quick charger correctly
could cause damage to the vehicle
or the charging equipment.
ChargingCH-15

To start charging:
1. Push the P position switch to place thevehicle in the P (Park) position and apply the
electric parking brake.
2. When charging the Li-ion battery, place the power switch in the OFF position. When the
power switch is in the ON position, the Li-
ion battery will not start charging.
3. Open the charge port lid and charge port cap. See “Charge port lid” and “Charge port
cap” in the “3. Pre-driving checks and
adjustments” section.
CAUTION
.Be sure to insert the charge con-
nector straight into the quick charge
port right up to the base. Failure to
do so may result in the Li-ion battery
not charging or could cause damage
to the charging equipment.

CAUTION
.As the quick charge connector is
heavier in comparison to the other
charge connectors, allowing it to
drop could cause damage to the
vehicle or charge connector or per-
sonal injury. When removing the
connector, be sure to pull it out
straight and as carefully as possible.
and
touch [Charging Timer].
CHARGING METHODS