heating NISSAN NOTE 2016 Service Service Manual

VTL-8
< REMOVAL AND INSTALLATION >
DUCT AND GRILLE
Removal
1. Remove instrument panel assembly. Refer to IP-15, "Removal and Installation".
2. Remove screws and foot duct (LH/RH) from heating and cooling unit assembly.
Installation
Installation is in the reverse order of removal.
REAR FLOOR DUCT
REAR FLOOR DUCT : Remo val and InstallationINFOID:0000000012430557
REMOVAL
1. Remove driver seat (if necessary). Refer to SE-20, "DRIVER SIDE : Removal and Installation".
2. Remove passenger seat (if necessary). Refer to SE-22, "
PASSENGER SIDE : Removal and Installation".
3. Remove rear seat cushion. Refer to SE-26, "
SEAT CUSHION : Removal and Installation".
4. Remove dash side finisher (LH/RH). Refer to INT-24, "
DASH SIDE FINISHER : Removal and Installation".
5. Remove center pillar lower finisher (LH/RH). Refer to INT-25, "
CENTER PILLAR LOWER FINISHER :
Removal and Installation".
6. Remove center console lower. Refer to IP-20, "
Removal and Installation"
7. Position floor trim and floor insulators aside.
8. Release and remove rear floor ducts.
INSTALLATION
Install in the reverse order of removal.
Revision: August 2015 2016 Versa Note

cardiagn.com

FRONT BLOWER MOTORVTL-9
< REMOVAL AND INSTALLATION >
C
DE
F
G H
J
K L
M A
B
VTL
N
O P
FRONT BLOWER MOTOR
Exploded ViewINFOID:0000000012430558
Removal and InstallationINFOID:0000000012430559
REMOVAL
1. Disconnect the negative battery terminal. Refer to PG-70, "Exploded View".
2. Remove instrument lower panel LH. Refer to IP-24, "
Removal and Installation".
3. Remove knee bolster. Refer to IP-14, "
Exploded View".
4. Remove the accelerator pedal assembly. Refer to ACC-3, "
Removal and Installation".
5. Remove the brake pedal assembly. Refer to BR-20, "
Removal and Installation".
6. Disconnect the harness connectors from the front blower motor.
7. Disconnect the harness connector from the thermo control amp.
8. Remove the front blower motor screw (A).
9. Press the flange holding hook, turn the front blower motor coun- terclockwise and remove.
INSTALLATION
Installation is in the reverse order of removal.
1. Heating and cooling unit assembly 2. Front blower motor 3. Front blower motor resistor
AWIIA1465ZZ
JMIIA1741ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com