ROAD WHEEL AND TYRE ASSEMBLY
WT-5
C
D
F
G
H
I
J
K
L
MA
B
WT
c. If calculated balance weight value exceeds 50 g (1.76 oz), install
two balance weight pieces in line with each other as shown in
the figure.
CAUTION:
Do not install one balance weight sheet on top of another.
3. Start tyre balance machine again.
4. Install drive-in balance weight on inner side of road wheel in the
tyre balance machine indication position (angle).
CAUTION:
Do not install more than two balance weights.
5. Start tyre balance machine. Make sure that inner and outer
residual unbalance values are 10 g (0.35 oz) each or below.
If either residual unbalance value exceeds 10 g (0.35 oz), repeat installation procedures.
RotationBES0004J
Follow the maintenance schedule for tyre rotation service inter-
vals. Refer to MA-8, "
PERIODIC MAINTENANCE" .
Do not include the spare tyre when rotating tyres.
CAUTION:
When installing wheels, tighten them diagonally by divid-
ing the work two to three times in order to prevent the
wheels from developing any distortion.
Be careful not to tighten wheel nut at torque exceeding
the criteria for preventing strain of disc rotor.
Maximum allowable unbalanceDynamic (At rim flange) Less than 10 g (0.35 oz) (one side)
Static (At rim flange) Less than 20 g (0.71 oz)
SMA056D
Tightening torque of wheel nut:
108 N·m (11 kg-m, 80 ft-lb)SMA829C
WT-6
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)PFP:00030
Road WheelBES0004K
Ty r eBES0004L
Unit: kPa (bar, kg/cm2 , psi) Kind of wheel Aluminum Steel
Maximum radial runout limitLateral deflection Less than 0.3 mm (0.012 in) Less than 0.8 mm (0.031 in)
Radial deflection Less than 0.3 mm (0.012 in) Less than 0.5 mm (0.020 in)
Maximum allowable unbalanceDynamic (At rim flange) Less than 10 g (0.35 oz) (one side)
Static (At rim flange) Less than 20 g (0.70 oz)
Tyre sizeAir pressure
Front Rear
205/65R16 95H 220 (2.2, 2.2, 32) 200 (2.0, 2.0, 29)
215/55R17 93V 240 (2.4, 2.4, 35) 220 (2.2, 2.2, 32)
