technical specifications NISSAN TIIDA 2007 Service Repair Manual

EM-318
< DISASSEMBLY AND ASSEMBLY >[K9K]
CYLINDER BLOCK
19. Screw sliding hammer [SST: KV113B0020 (Emb. 880)] onto oil
jet remover [SST: KV113B0120 (Mot. 1485-01)] and remove the
oil jet.
20. To remove the piston pin, remove the snap ring using a screwdriver, then release the pin.
Removing the Piston Pins
NOTE:
It is imperative to mark the connecting rod to match it to its piston, because the piston height classes
in the same engine may be different (see Technical Specifications section).
ASSEMBLY
1. The oil jets must be installed using oil jet remover plate [SST: KV113B0170 (Mot. 1494)].
2. Install oil jets for NO. 1 and NO. 3 cylinders with the following procedure.
a. Install plate (A) of oil jet remover plate [SST: KV113B0170 (Mot. 1494)] onto the cylinder block (as shown)
without tightening the two bolts (C).
b. Position the guide rod (B) in the plate (A) and the end of the guide rod in the hole of the oil jet to center the
plate (A).
c. Tighten the two bolts (C).
d. Remove the guide rod.
e. Install the push rod instead of the guide rod, then insert the oil jet
into the push rod.
NOTE:
Check that the oil jet is correctly oriented with the end of
the jet (D) directed towards the center of the cylinder.
f. With a hammer, tap the push rod until the shoulder (E) of the
push rod comes into contact with the plate (A).
3. Install oil jets for NO. 1 and NO.4 cylinders with the following procedure.
MBIB0451E
MBIB0453E
MBIB0454E