ignition Oldsmobile Achieva 1997 s Workshop Manual

Fuse
IGN MOD
HVAC BLO MOT
PCM BATT
CLG FAN
HDLP
STOP
LPS PWR
ACC
RR DEFG
ABS
IGN SW
Usage
Ignition System
Heater/ Air Conditioner-High
Blower, Generator-Voltage
Sense
Powertrain Computer
Engine Cooling Fan
Lighting Circuits
Power Accessory,
Stoplamp Circuits,
Rear Window Defogger
Anti-Lock Brakes,
Variable
Effort Steering
Ignition Switched Circuits
Replacement Bulbs
Outside Lamps Bulb
Headlamp .............................. 9004
Back-up ............................... 2057
High Level Stop
.......................... 912
Tail/Stop/Turn
.......................... 3057
Inside Lamps Bulb
Dome .................................. 562
6-61
- . -

Ignition Transaxle Lock Check
While parked, and with the parking brake set, try to turn
the ignition key to LOCK in each shift lever position.
With an automatic transaxle, the key should turn to
LOCK only when the shift lever is in PARK (P).
With a manual transaxle, the key should turn to LOCK
only when the shift lever is in REVERSE (R).
On vehicles with
a key release button, try to turn the key
to
LOCK without pressing the button. The key should
turn to
LOCK only when you press the key button.
On all vehicles, the key should come out only
in LOCK.
Parking Brake and Automatic Transaxle PARK (P)
Mechanism Check
When you are doing this check, your vehicle
could begin
to move. You or others could be
injured and property could be damaged. Make
sure there
is room in front of your vehicle in case
it begins to roll. Be ready to apply the regular
brake at once should the vehicle begin to move. Park
on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot
on the regular brake, set the
parking brake.
0
0
To check the parking brake’s holding ability: With
the engine running and transaxle in NEUTRAL
(N),
slowly remove foot pressure from the regular brake
pedal.
Do this until the vehicle is held by the parking
brake only.
To check the PARK (P) mechanism’s holding ability:
With the engine running, shift to PARK
(P). Then
release all brakes.
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud and other debris
can collect.
7-44

Guide en FranGais 11
GVWR ....................................... 4-33
.. .................................
Halogen Bulbs ................................ 6-35
Hazard Warning Flashers
.......................... 5-2
Head Restraints
................................. 1-5
Headlamps
.................................... 2-44
Bulb Replacement
............................ 6-35
HighLow Beam Changer
...................... 2-37
OnReminder
................................ 2-44
Wiring
..................................... 6-57
Hearing Impaired. Customer Assistance
.............. 8-4
Heating
........................................ 3-4
High-Beam Headlamps
.......................... 2-37
Highway Hypnosis
.............................. 4-24
Hill and Mountain Roads
......................... 4-24
Hitches. Trailer
................................. 4-38
Hood Checking Things Under
......................... 6-8
Release
...................................... 6-9
Horn ......................................... 2-34
Hydraulic Clutch
............................... 6-23
Hydraulic Clutch Fluid
........................... 6-23
Hydraulic Clutch System Check
................... 7-42
Hydroplaning
.................................. 4-20
If a Tire Goes Flat .............................. 5-21
Ignition Positions
............................... 2- 14
Illuminated EntryExit System
..................... 2-46
Inflation. Tire
.................................. 6-41
Inside Daymight Rearview Mirror
................. 2-49 Inspections
Brakesystem
................................ 7-46
Caliper/Knuckle Maintenance
................... 7-46
Exhaust Systems
............................. 7-45
Front-Wheel-Drive Axle Boot
.................. 7-45
Front-Wheel-Drive Axle Seal
................... 7-45
Radiator and Heater Hose
...................... 7-45
Steering
.................................... 7-45
Suspension
.................................. 7-45
Throttle Linkage
.............................. 7-45
Instrumentpanel
............................... 2-56
Brightness Control
............................ 2-46
Cleaning
.................................... 6-50
Cluster
..................................... 2-58
FuseBlock
.................................. 6-58
Interior Lamps
................................. 2-46
Jack. Tire
.................................... 5-24
Jump Starting
................................... 5-3
Key Lock Cylinders Service
..................... 7-42
Key Release Button
............................. 2-16
Keys
.......................................... 2-2
Labels Certification
................................. 4-33
Service Parts Identification
..................... 6-56
Tire-Loading Information
...................... 4-33
Vehicle Identification Number
................... 6-56
Lamps
........................................ 2-43
Interior
..................................... 2-46
OnReminder
................................ 2-44
Exterior
.................................... 2-43
Fog
........................................ 2-45
9-5
.