lock Oldsmobile Achieva 1998 Owner's Manuals
[x] Cancel search | Manufacturer: OLDSMOBILE, Model Year: 1998, Model line: Achieva, Model: Oldsmobile Achieva 1998Pages: 356, PDF Size: 18.04 MB
Page 7 of 356
Vehicle Symbols
These are some of the symbols you may find on your vehicle.
For example,
these symbols are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
BATTERY
CAUSE
BURNS
ACID COULD
&
AVOID
SPARKS
OR
FLAMES
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols are important
for you and
your passengers
whenever your
vehicle is
driven:
DOOR LOCK
UNLOCK
FASTEN SEAT
BELTS
POWER
WINDOW
These symbols have to
do with
your lamps:
SIGNALS e
TURN
PAEJN&
pf
WARNING A
HAZARD
FLASHER
RUNNING
.‘:**o
DAYTIME LAMPS
***
FOG LAMPS # 0
These symbols are. on some
of
your controls:
WINDSHIELD
WIPER
WINDSHIELD DEFROSTER
WINDOW
DEFOGGER
VENTILATING FAN
These symbols are used on
warning and
indicator lights:
COOLANT F-
TEMP -
CHARGING BAllERY
SYSTEM
BRAKE
(a)
COOLANT
ENGINE OIL
PRESSURE
Wb
ANTI-LOCK (@)
BRAKES
Here are some
other symbols
you may see:
FUSE
I
LIGHTER
HORN
)b.
SPEAKER
b
FUEL p3
V
Page 10 of 356
Seats and Seat Controls
This section tells you about the seats -- how to
adjust them,
and also about reclining seatbacks and
head restraints.
Manual Seats
I
You can lose control of the vehicle if you try to
adjust
a manual driver’s seat while the vehicle is
moving. The sudden movement could startle and confuse you, or make
you push a pedal when you
don’t want to. Adjust the driver’s seat only when
the vehicle is not moving. lvlove the lever under the front seat to unlock it. Slide
the seat to where you want it. Then release the lever and
try to move the seat with your body, to make sure the
seat
is locked in place.
1-2
Page 11 of 356
4-Way Manual Seat
There are two levers at the front of the seat. The left
lever adjusts
the seat forward and back. The right lever
adjusts the angle of the front of the seat.
The lever near the outer side of the seat unlocks the seat
allowing
it to slide forward and back. Then release the
lever and try to move the seat to be certain that it
is
locked in place.
The lever on the right allows you to tilt the seat
up
and down.
Manual Lumbar Support (If Equipped)
Turn the knob on the right of the driver’s seat cushion
to the right or to the left to adjust support for the
lower back.
1-3
Page 12 of 356
Power Seat (If Equipped)
To adjust the power seat:
Front Control (A): Raise the front of the seat by
holding the switch up. Lower the front
of the seat by
holding the switch down.
Center Control (B): Move the seat forward or back by
holding the control to the front or back.
Move the seat higher by holding the control up. Lower
the seat by holding
the control down.
Rear Control (C): Raise the rear of the seat by holding
the switch up. Lower the rear
of the seat by holding the
switch down.
Reclining Front Seatbacks
To adjust the seatback, lift the lever on the outer side of
the seat and move the seatback where you want it.
Release
the lever to lock the seatback.
Pull up
on the lever and the seat will go to an
upright position.
Page 20 of 356
How to Wear Safety Belts Properly
Adults
This part is only for people of adult size.
Be aware that there are special things to know about
safety belts and children. And there are different
rules for smaller children and babies.
If a child
will be riding in your vehicle, see the part
of this
manual called “Children.” Follow those rules
for
everyone’s protection.
First, you’ll want to know which restraint systems your
vehicle has.
We’ll start with the driver position.
Driver Position
This part describes the driver’s restraint system.
Lap-Shoulder Belt
The driver has a lap-shoulder belt. Here’s how to wear
it properly.
1. Close and lock the door.
2. Adjust the seat (to see how, see “Seats” in the Index)
so you can sit up straight.
3. Pick up the latch plate and pull the belt across you.
4. Push the latch plate into the buckle until it clicks.
Don’t
let it get
twisted.
1-12
Page 22 of 356
‘1 !A
The lap part of the belt should be worn low and snug on
the hips, just touching the thighs. In a crash, this applies
force
to the strong pelvic bones. And you’d be less
likely to slide under the lap belt.
If you slid under it, the
belt would apply force at your abdomen. This could
cause serious or even fatal injuries. The shoulder belt
should
go over the shoulder and across the chest.
These
parts of the body are best able to take belt
restraining forces.
The safety belt locks if there’s
a sudden stop or crash.
1-14
Page 23 of 356
Shoulder Belt Height Adjuster
Before you begin to drive, move the shoulder belt
adjuster to the height that
is right for you.
To move it down, squeeze the release button and move
the adjuster to the desired position. You can move the
adjuster up just by pushing up on the shoulder belt
guide. After you move the adjuster to where you want it,
try to move it down without squeezing the release button
to make sure
it has locked into position.
Adjust the height
so that the shoulder portion of the
belt is centered on your shoulder. The belt should be
away from your face and neck, but not falling
off
your shoulder.
1-15
Page 38 of 356
I I I I I I t I I I I
The lap part of the belt should be worn low and snug on
the
hips, just touching the thighs. In a crash, ths applies
force to the strong pelvic bones. And you'd be less likely
to slide under the lap belt.
If you slid under it, the belt
would apply force at your abdomen.
This could cause
serious
or even fatal injuries. The shoulder belt should go
over the shoulder and across the chest. These parts of the
body
are best able to take belt restraining forces.
The safety belt locks
if there's a sudden stop or a crash.
1-30
Page 65 of 356
Section 2 2s and COI :- 11s
Here you can learn about the many standard and optional features on your vehicle, and information on starting,
shifting and braking. Also explained
are the instrument panel and the warning systems that tell you if everything is
working properly
-- and what to do if you have a problem.
2-2
2-4
2-6 2-10
2-11
2- 12
2-13
2-13
2- 14
2-
17
2-18
2-23
2-24 2-26 Keys
Door Locks
Remote
Lock Control
(If Equipped)
Trunk
Theft
Passlock@
New Vehicle “Break-In”
Ignition Positions”
Starting Your Engine
Engine Coolant Heater (If Equipped)
Automatic Transaxle Operation
Parking Brake
Shifting Into PARK (P)
Shifting Out of PARK (P) 2-26
2-27
2-27
2-28
2-29 2-29
2-30
2-37
2-39
2-42
2-43 2-45
2-46
2-50 Parking Over
Things That
Burn
Engine Exhaust
Running Your Engine While You’re Parked
Windows
Horn
Tilt Wheel
Turn Signal/Multifunction Lever
Exterior Lamps
Interior Lamps
Mirrors Storage Compartments
Accessory Power Outlet
Instrument Panel
Warning Lights, Gages and Indicators
2-1
Page 67 of 356
One key
ignition,
all other is used for the
the doors and
locks.
When a new vehicle
is delivered, the retailer removes
the key tag from the keys, and gives them to the
first owner. [f
you need a new key, go to your Oldsmobile retailer
for the correct key code.
I
~ NOTICE:
Your vehicle has a number of new features that
can help prevent theft, therefore you can have a
lot
of trouble getting into your vehicle if you ever
lock your keys inside. You may even have to
damage your vehicle to get in.
So be sure you
have extra keys.
Each tag has a code on it that tells your retailer or a
qualified locksmith how to make extra keys. Keep the
tags in a safe place.
If you lose your keys, you’ll be
able to have new ones made easily using these tags.
2-3