instrument panel OLDSMOBILE AURORA 1995 User Guide

Headlamps
300: Turn the band to this symbol to turn on:
Parking Lamps
%
0 Side Marker Lamps
0 Taillamps
Instrument Panel Lights
License Plate Lamps
/, Turn the band to this symbol to turn on:
Headlamps
-'Q-
Parking Lamps
Side Marker Lamps
0 Taillamps
Instrument Panel Lights
License Plate Lamps
Turn the band to
OFF to turn off the lamps/lights.
Headlamp High-Low Beam
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release
it.
When the high beams are on, a blue light on the
instrument panel also will be on.
2-39
ProCarManuals.com

Daytime Running Lamps (Canada Only)
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful
in many different driving
conditions, but they can be especially helpful
in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered. The DRL system
will make your low-beam headlamps conle on at
a
reduced brightness when:
0 The ignition is ON,
The headlamp switch is OFF, and
0 The transaxle is not in PARK (P).
When the DRL are on,
only your low beam headlamps
will be on. The taillamps, sidemarker and other lamps
won’t be on. Your instrument panel won’t be
lit up either.
When it’s dark enough outside, your
low beam
headlamps will change to
full brightness automatically.
The other lamps that come on with your headlamps
will
also come on. When
it’s bright enough outside, the regular lamps
will
go off, and your low beam headlamps will change to the
reduced brightness of DRL.
To idle your vehicle with the DRL off, shift the
transaxle into PARK
(P). The DRL will stay off until
you shift out of PARK (P). If it’s dark, you must also
move the Twilight Sentinel control to MIN.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
Fog Lamps
To turn on the fog lamps,
first turn
on the parking
lamps or headlamps. Then
press the fog lamp switch.
A light will glow on the
switch when the switch
is
on. To turn off the fog
lamps, press
it again. The
fog lamps will also switch
off when you turn on your
high beam headlamps.
but
will turn on again when you
switch to low beams.
2-41
ProCarManuals.com

Instrument Panel Intensity Control
INTERIOR LIGHTS TWILIGHT SENTINEL
You can brighten or dim your instrument cluster, radio and
climate control displays and control lights
by rotating the
lNTERlOR LIGHTS control between
LO and HI when
your lights are on. Rotate the control all the way to
HI and
you will turn on the interior courtesy lamps.
Twilight Sentinel
The Twilight Sentinel Does Two Things:
0 First, depending on how dark it becomes outside, the
Twilight Sentinel turns your headlamps on automatically, when they’re needed. Avoid covering
the sensor located near the windshield, by the defroster
outlet--otherwise your headlamps
will stay on.
Also, it’s possible that your headlamps might go out
if you drive from a dark area into a bright area, such
as a lighted parking lot. If this happens, turn on your
headlamps with the regular headlamp switch.
Second, to light your way when you leave your
vehicle, the Twilight Sentinel will keep your
headlamps
on for as long as three minutes.
2-42
ProCarManuals.com

Power Remote Control Mirrors
The controls on the far left
of the instrument panel
control both outside
rearview mirrors. Move the
center switch
to the left to
select the driver’s side
rearview mirror, or to the
right
to select the
passenger’s side
I/ I rearview mirror.
Then press the arrows
to adjust each mirror so that you
can just see the side of your vehicle when you are sitting
in
a comfortable driving position.
To lock the controls, leave the selector switch in the
middle position.
When you operate the rear window defogger, a defogger
also warms
the driver’s and passenger’s outside
rearview mirrors to help clear them
of ice and snow.
Convex Outside Mirror
Your passenger’s side mirror is convex.
A convex mirror’s surface is curved so you can see more
from the driver’s seat.
2-51
ProCarManuals.com

The Instrument Panel == Your Information System
2-58
ProCarManuals.com

The Aurora instrument panel is designed to let you
know at a glance how your vehicle is running. You’ll
know how fast you’re going, how much fuel you’re
using, and many other things you’ll need
to drive safely
and economically.
The main components
of your instrument panel are:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Power Mirrors Control Switch
Fog Lamp Switch
Turn SignalMultifunction Lever
Instrument ClusterIGages
Hazard Warning Flashers Switch
Horn
Windshield Wiper/Washer Control
Driver Information Center
Climate Controls
Audio System
Glove
Box (Trunk Security Override Switch inside) 12.
Passenger Side Air Bag
13. Accessory Power Outlet
14. Gearshift Lever
15. Selectable Shift
16. Traction Control Button
17. Ashtray and Lighter
18. Fuel Door Release Switch
19. Trunk Release Switch
20. Steering Wheel Touch Controls for Audio System
21. Ignition Switch
22. Driver Side Air Bag
23.
Tilt Steering Wheel Lever
24. Steering Wheel Touch Controls for Climate Control
System
25. Twilight Sentinel Control
26. Instrument Panel Intensity Control
ProCarManuals.com

Instrument Panel Cluster
Your Aurora is equipped with this instrument panel cluster, which includes indicator warning lights and gages that
are explained
on the following pages.
2-60
ProCarManuals.com

Safety Belt Reminder Light
FASTEN
BELTS
When the key is turned to RUN or START, a chime will
come on for about eight seconds to remind people to
fasten their safety belts.
The safety belt light will also
come on and stay on for about
70 seconds. If the driver’s
belt is already buckled, neither the chime nor the light
will come on.
Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows
AIR BAG. The system checks the
air bag’s electrical system for malfunctions.
The light
tells you
if there is an electrical problem. The system
check includes the air bag sensors and modules, the
wiring and
the diagnostic module. For more information
on the air bag system, see “Air
Bag” in the Index.
AIR BAG
You will see this light
flash for
a few seconds
when you turn your
ignition to RUN or
START. Then the light
should go out. This
means the system is
ready.
If the air bag readiness light doesn’t come on when you
start your vehicle, or stays on, or comes on when you
are driving, your air bag system may not work properly.
Have your vehicle serviced right away.
2-64
ProCarManuals.com

indicating there may be a problem. See your Aurora
retailer for service.
The digital screen displays the outside temperature or
the inside temperature setting, the fan speed, and the
heating mode
you have selected. Hold down the OFF
button on the Driver Information Center for five seconds
to change between English and metric displays. Keep
in
mind that this will also change the display on the Driver
Information Center between English and metric.
The red and blue buttons below the digital display set
the interior temperature
you want. The temperature you
set will be displayed on
the digital screen for five
seconds after
you press either the red or blue button (to
raise or lower temperature, respectively). Then the
outside temperature will be displayed.
Once you set
the temperature, the system will try to
maintain that
set temperature, whether you are in the
auto or manual modes. But if you set the temperature for
60°F (16°C) or 90°F (32"C), the fan will stay on high
speed unless you select
a different speed. The system
will maintain
full cold or full hot operation at these
extreme temperature settings. Your
system has two sun sensors
on top of the
instrument panel that detect direct sunlight and the
increased warming caused by it.
To keep you
comfortable, the sensors may reduce the interior
temperature
by as much as 5 "F (3 "C) below the setting
on the digital screen, if necessary. Be careful not
to put
anything over these sun sensors.
If you do, the system
will
think it's night and warm up the vehicle.
ProCarManuals.com

AUTO-PUSH: To allow the system to automatically
control
the temperature, air distribution and Fdn speed:
1. Set the temperature you want with the colored
temperature buttons.
2. Press the AUTO-PUSH switch. The AUTO light will
appear below the selector.
To maintain proper comfort, the air flow direction
will
automatically change with increases or decreases in
outside temperature, interior temperature, or sun load.
After starting a cold engine, there may be up to a
four-minute delay before the fan is turned on. The fan
will automatically increase
in speed as the coolant
temperature rises.
AUTO FAN: Sets the fan speed. Turn this knob to the
right to raise
the fan speed, to the left to lower the fan
speed. The fan speed
will be displayed by the lights
around the knob (except
in the AUTO mode).
Use the following controls when you wish to override
the AUTO setting.
Directional Controls
When the AUTO-PUSH knob is pressed, the fan speed
will go
to AUTO unless you select a different speed.
After
you turn the knob to a directional control, the set
interior temperature
will be displayed for about five
seconds,
then the outside temperature will be displayed
"ri Upper: Directs air flow through the upper air
outlets
in the instrument panel.
f0 /I' Bi-Level: Use on cool, but sunny days. This
setting brings
in the outside air, but directs it in two
ways. The cool air is directed
to the upper portion of
your body through the instrument panel outlets, but most
warmed air is directed through the heater ducts and
a
little to the defrost and side window vents. At times, this
temperature difference may be more apparent than
others.
3-3
ProCarManuals.com