mirror Oldsmobile Aurora 1998 Owner's Manuals

Power Lumbar Control
I -- . .. .........._ ..........................................................
The power lumbar controls are located on the driver’s
and passenger’s door panels.
The rear lumbar control adjusts upper lumbar support,
and the front control adjusts lower lumbar support.
Press the front
of the switch to increase support. Press
the back
of the switch to decrease support.
Memory Seat and Mirrors
The memory function
controls both the driver’s
seat cushion and outside
mirror positions. It does
not store the lumbar or
recline positions.
at3
% ............... -... ................... -. ..... -_.. ... ._
To set your memory seat cushion and mirrors:
1. Position the driver’s seat and both outside mirrors
where you want them. See “Mirrors” in the Index.
2. Press the SET button. You will hear one beep.
3. Within five seconds, press either the 1 or 2 button.
You will hear two beeps.
1-3
-

The seat cushion and mirror positions will be stored
for the number pressed. Repeat the procedure to store
another position with the other number if desired.
To
adjust the seat and mirrors to the stored position, press
the number corresponding to the position. The memory
function will only work with the gearshift in PARK
(P).
To stop the automatic movement, move the seat switch
in any direction. For easier exiting, press the
1 and 2
buttons at the same time to move the seat completely
down and back.
Memory Seat and Mirror
Personalization Feature
The transmitters can also be programmed to move the
driver’s seat and outside mirors to a set memory position
when the transmitter’s
UNLOCK button is pressed.
To program the system:
1.
2.
3.
4.
Adjust the driver’s seat to a comfortable position.
Adjust both outside mirrors to suit you. See
“Mirrors” in the Index.
Press the SET button on the driver’s door panel.
You will hear one beep.
Within five seconds, press one
of the two memory
buttons on the door panel. You will hear two beeps
to confirm that the mirror and the seat cushion
positions are entered into memory.
Press the
UNLOCK button on the appropriate
transmitter within five seconds.
You will hear
two beeps.
The second transmitter can be programmed to record
a different seat and mirror position by following the
same steps.

If you prefer to program the exit seat position, which
moves the seat completely down and back, follow
these steps:
1. Press the SET button on the driver’s door panel.
You will hear one beep.
2. Press one of the memory buttons on the driver’s
door panel. You will hear one beep, but the seat
will not move at this time.
3. Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
This personalization feature will work only when the
vehicle is in
PARK (P). A beep will sound inside the
vehicle when the UNLOCK button on the transmitter
is pressed to move the seat and mirrors.
To turn this feature off, press
SET and then UNLOCK
within five seconds.
Heated Front Seat (Option)
7- I
This feature will quickly heat the lower cushions and
lower back of the driver and front passenger seats for
added comfort.
Press the button once to turn the heater on high. The
HI
indicator light below the button will glow. Press it again
to turn the heater on low. The
LO indicator light below
the button will glow. Press it a third time to turn the
heater off. The heater will turn
off automatically when
the ignition is turned to
OFF.

Section 2 Features and Controls
Here you can learn about the many standard and optional features on your vehicle, and information on starting,
shifting
and braking. Also explained are the instrument panel and the warning systems that tell you if everything is
working properly
-- and what to do if you have a problem.
2-2
2-4
2-9
2- 14
2-15
2- 16
2-1s
2- 19
2-20
2-21
2-23
2-27
2-28
2-30
2-3
1
Keys
Door Locks
Remote Lock Control TrUIlk
Theft
Universal Theft-Deterrent
PASS-Key(%
New Vehicle “Break-In”
Ignition Positions Starting Your Engine
Engine Coolant Heater (Option)
Parking Brake
Shifting Into PARK (P)
Shifting Out of PARK (P)
Parking Over Things That Burn 2-3 1
2-3
3
2-34
2-34
2-42
2-45
2-48
2-52
2-55
2-55 2-55
2-56
2-60
2-64
2-75 Engine Exhaust
Windows
Tilt Wheel
Turn SignaVMultifunction Lever
Exterior Lamps Interior Lamps
Mirrors
Storage Compartments
Cellular Telephone (Option)
Accessory Power Outlet
Sunroof (Option)
Universal Transmitter
Instrument Panel
Warning Lights, Gages and Indicators
Driver Information Center
2-1

Personalization Features
The following list of features that are available on your
vehicle can be programmed
to the driver’s preference
for each transmitter.
Security Feedback
0
0
0
0
0
Memory Door Locks: This feature programs your
door locks to automatically lock or unlock when
shifting in and out of PARK (P).
Security Feedback: This feature provides feedback
to the driver when the vehicle receives a command
from the remote lock control transmitter.
Delayed Locking: This feature lets the driver delay
the actual locking of the vehicle. When
all doors
have been closed, the doors will lock automatically after five seconds.
Perimeter Lighting: When the UNLOCK button on
the transmitter is pressed, the headlamps, parking
lamps, back-up lamps and cornering lamps will turn
on in dark conditions.
Memory Seat and Mirrors: This feature programs
your driver’s seat and outside mirrors to a set
memory position when the UNLOCK button on the
transmitter is pressed.
For more detailed information and programming
instructions, refer to the Index for each individual
feature listed above. This personalization feature
provides feedback to the
driver when the vehicle receives a command from the
remote lock control transmitter. The following modes
may be selected:
4
5
1
2
3
Mode Security Feedback
0 No transmitter response when locking or
unlocking the vehicle.
No transmitter response when locking;
headlamps, parking lamps and cornering
lamps flash when unlocking the vehicle.
Headlamps, parking lamps and cornering
lamps flash when locking; no response
when unlocking the vehicle.
Headlamps, parking lamps and cornering
lamps flash when locking and when
unlocking the vehicle.
Headlamps, parking lamps and cornering lamps flash and horn chirps when locking;
no response when unlocking the vehicle.
Headlamps, parking lamps and cornering
lamps flash and horn chirps when locking;
exterior lamps flash when unlocking
the vehicle.
2-11

Rear Reading Lamps
These lamps go on when you open the doors. You can
also turn them on by pressing the button to
the side of
the lamp. Press
it again to turn them off.
Trunk Lamp
When you open the trunk to its full open position, a
lamp will come on inside the trunk. This lamp will
automatically
turn off when the trunk is closed.
Inadvertent Load Protection
This feature automatically shuts off the interior lamps
if any are left on for more than
10 minutes when the
ignition is off or
a door is left open. This will keep your
battery from running down.
Mirrors
Electrochromic Daymight Rearview Mirror
with Compass
(If Equipped)
Your vehicle may have an electrochromic inside
rearview mirror with a compass.

Mirror Operation
When set in the MIRROR position, this mirror
automatically changes to reduce glare
from headlamps
behind you.
A time delay feature prevents rapid
changing from the day to night positions while driving
under lights and through traffic.
The mirror
also includes an eight-point compass display
in the upper right corner of the mirror face. When on, the
compass automatically calibrates as the vehicle is driven.
When cleaning the mirror, use a paper towel or similar
material dampened with glass cleaner.
Do not spray
glass cleaner directly on the mirror as that may cause
the liquid cleaner to enter the mirror housing. Use a
cotton swab and glass cleaner to clean the photocells
when necessary. The right side
of the switch located at the bottom
of the
mirror
turns the electrochromic mirror on and off. To
turn on the automatic dimming feature, press MIRROR.
To turn off automatic dimming, press MIRROR again.
The green indicator light will be illuminated when
this
feature is active.
Compass Operation
Press the COMPASS switch once to turn the compass
on or
off.
When the ignition and the compass feature are on, the
compass
will show two character boxes for
approximately
two seconds. After two seconds, the
mirror will display the compass heading.
2-49

If, after two seconds, the display does not show a
compass heading
(“N’ for North, for example), there
may be a strong magnetic field interfering with the
compass. Such interference may be caused by a
magnetic antenna mount, magnetic note pad holder
or a similar magnetic item.
Compass Variance
The mirror is set in zone eight upon leaving the factory.
It will be necessary to adjust the compass to compensate
for compass variance if you live outside zone eight.
Under certain circumstances, as during a long distance
cross-country trip, it will be necessary to adjust for
compass variance. Compass variance
is the difference
between earth’s magnetic north and true geographic
north. If not adjusted
to account for compass variance,
your compass could give false readings.
To adjust
for compass variance:
1. Use the COMPASS button located at the bottom of
the mirror.
2. Press and hold the COMPASS button until a zone
number appears in the display.
on the following zone map.
3. Find your current location and variance zone number
4. Press the COMPASS button on the bottom of
the mirror until the new zone number appears
in the display. After you stop pressing the
button, the compass will need to be calibrated.
(This is the automatic calibration mode. Drive in
a circle to calibrate the mirror. See “Compass
Calibration” following.)
2-50

Compass Calibration
If the letter “C” should ever appear in the compass
window, the compass may need calibration.
The mirror can be calibrated in one of two ways:
0 Drive the vehicle in circles at five mph (8 km/h) or
less until the display reads a direction, or
0 Drive the vehicle on your everyday routine.
Power Remote Control Mirror
The controls on the far
left of the instrument
panel control both outside
rearview mirrors. Move
the center switch to the
left to select the driver’s
side rearview mirror, or
to the right to select the
passenger’s side
rearview mirror.
To lock the controls, leave the selector switch in the
middle position.
When you operate the rear window defogger, a defogger
also warms the driver’s and passenger’s outside
rearview mirrors to help clear them of ice and snow.
Your vehicle
is equipped with the memory function. The
mirror positions, along with the driver’s set position, can
be stored into memory. See “Memory Seat and Mirrors”
in the Index.
Parallel Park Assist Mirror
The passenger’s outside rearview mirror also includes a
tilt-down feature that operates when the shift lever is in
reverse. This feature assists the driver with improved
rear obstacle detection.
Move the power remote control mirror switch to the
left
(L) or center position to enable this feature. Move
the switch to the right
(R) to turn this feature off.
Then press the arrows
to adjust each mirror so that you
can just see the side
of your vehicle when you are sitting
in a comfortable driving position.
2-51

Convex Outside Mirror
Your passenger’s side mirror is convex. A convex
mirror’s surface is curved so you can see more from
the driver’s seat.
I A CAUTION:
rn 3
A convex mirror can make things (like other
vehicles) look farther away than they really are.
If you cut too sharply into the right lane, you
could hit
a vehicle on your right. Check your
inside mirror or glance over your shoulder
before changing lanes.
Heated Outside Rearview Mirror
When you operate the rear window defogger, a defogger
also warms the heated driver’s and passenger’s outside
rearview mirrors to help clear them of ice and snow.
Storage Compartments
Glove Box
Use the door key to lock and unlock the glove box. To
open, pull the latch release on the left side of the glove
box door.
Front Storage Armrest
The front armrest opens into a storage area. To open it,
lift the front edge. Inside you will find storage for
cassettes, compact discs and coins.
2-52