wipers OLDSMOBILE SILHOUETTE 1996 Owners Manual

WindsL'-.'3 Wipers
The windshield wiper and washer controls are located to
the right of the instrument cluster.
For a single wiper cycle: Press the switch marked
MIST and release. For more cycles, press and hold
the switch.
For pulse delay wiper cycles: The pulse delay cycle
system allows you to set the wiper speed as slow as
20 seconds between cycles, or faster. Pulse delay cycles
are very useful in light rain
or snow. Slide the upper
control to the
DELAY area. The lower the position, the
slower the cycle; the higher the position, the faster
the cycle.
For steady wiper cycles: Slide the upper control either
to the
LO or HI position, depending on the wiper speed
you want.
To turn the wipers off: Slide the upper control to the
OFF position.
Remember that damaged wiper blades may prevent
you
from seeing well enough to drive safely. To avoid damage,
be sure to clear ice and snow from the wiper blades before
using them. If they're frozen to the windshield, carefully
loosen or thaw them. If your blades do become damaged,
get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
ProCarManuals.com

Windshie
To wash your windshield, press and hold the windshield
washer switch. The washers and wipers will operate.
When you release the switch, the washers will stop, and
the wipers will continue to operate for two cycles, unless
your wipers had already been on. In that case, the wipers
will resume the wiper speed you had selected earlier.
2-42
Driving without washer fluid can be dangerous. A bad mud
splash can block your vision, You could hit another vehicle or
go off the road. Check your washer fluid level often.
In freezing weather, don’t use your washer until
the windshield
is warmed. Otherwise the washer
fluid
can form ice on the windshield, blocking
your vision.
ProCarManuals.com

NOTICE:
Don’t add anything electrical to your Oldsmobile
unless you check with your retailer
first. Some
electrical equipment can damage your vehicle and the damage-wouldn’t be covered by your
warranty. Some add-on electrical equipment
can keep other components from working as
they should.
Headlamp Wiring
The headlamp wiring is protected by a circuit breaker in
the lamp switch. An electrical overload will cause the
lamps to go on and
off, or,in some cases to remain off.
If this happens, have your headlamp system checked
right away.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse.
If the motor overheats due to heavy
snow, etc., the wiper will stop until the motor cools.
If
the overload is caused by some electrical problem, be
sure to get it fixed.
Power Windows and Other Power Options
Circuit breakers in the circuit breakerhelay panel protect
the power windows and other power accessories. When
the current load is too heavy, the circuit breaker opens and closes, protecting
the circuit until the problem
is fixed.
6-52
ProCarManuals.com