ECU OPEL COMBO 2010 User Guide

137
Self-help, vehicle care
Picture no: 12461s.tif
Combo van
The jack and the vehicle tools are secured
behind the driver’s seat.
The jack is secured in place by a wing
screw. The vehicle tools are secured to the
jack with rubber bands.
Changing wheels There may be a tyre repair kit instead of a
spare wheel 3142.
Make the following preparations and
observe the following information:
zPark the vehicle on a level, firm and non-
skid surface. The front wheels must be in
the straight-ahead position.
zSwitch on the hazard warning flashers,
apply the hand brake, engage first gear
or reverse.
zSet up the warning triangle correctly.
Warning triangle 3133.
zRemove the spare wheel from beneath
the vehicle floor 3134.
zNever change more than one wheel at
once. zUse the jack only to change wheels.
zIf the ground on which the vehicle is
standing is soft, a solid board (max. 1 cm
thick) should be placed under the jack.
zBlock the wheel diagonally opposite the
wheel to be changed by placing wedge
blocks or equivalent in front and behind
the wheel.
zNo people or animals may be in the
vehicle when it is jacked up.
zNever crawl under a jacked-up vehicle.
zDo not start the vehicle when it is raised
on the jack.
zBefore screwing in the wheel bolts, clean
them and lightly coat the taper of each
wheel bolt with commercially available
grease.

158 Self-help, vehicle care
Picture no: 15135s.tif
Number plate lamps 1. Unscrew both screws. Remove lamp
insert.
Picture no: 15136s.tif
2. Press bulb slightly towards spring clip
and remove.
3. Insert new bulb.
4. Insert lamp insert and secure using a
screwdriver.
Picture no: 11667s.tif
Courtesy lamps Front courtesy lamp
1. Prise lamp out of recess using a
screwdriver.