ignition OPEL CORSA 2009 Workshop Manual

110 LightingShort turn signal 3
Push stalk until you feel resistance and
release. The turn signal flashes three times,
e.g. for changing lanes. This function can
be activated or deactivated depending on
the key that is used, see "personalised key",
P3 339, 341.
Acoustic turn signal 3
The volume of the acoustic turn signal can
be adjusted. This function can be
programmed depending on the key used,
see "Personalised key", P7 339, 341.
Picture no: 18199s.tif
Fog lamps
> 3

The fog lamps can only be switched on
when both the ignition and lights are on.
Operated with the > button.
Fog tail lamp
r
The fog tail lamp can only be switched on
both the ignition and dipped beam/parking
lamps are on.
Operated with the r button.
The vehicle fog tail lamp are deactivated
when towing.
Reversing lamps The reversing lamps come on when the
ignition is on and reverse gear is engaged.
Back to overview

111
Lighting
Picture no: 18169s.tif
Hazard warning lamps Operated with the ¨ button.
To aid location of the pushbutton, the red
surface is illuminated when the ignition
switched on. When the button is pressed,
its control indicator flashes in time with the
hazard warning lamps.
The hazard warning flashers activate
automatically if the airbags deploy.
Picture no: 18200s.tif
Headlamp range adjustment
? 3

Adjust headlamp range to suit the vehicle
load to avoid dazzling oncoming traffic.
Push button
I or
J step-by-step until the
required setting is displayed on the
kilometre display.
The display shows for 4 seconds, when
dipped beam is switched on or every time
the beam range is changed, together with
the symbol ?.
Picture no: 18419s.tif
0 = Front seats occupied
1 = All seats occupied
2 = All seats occupied and luggage
compartment load
3 = Driver’s seat occupied and luggage compartment load
Back to overview

112 Lighting
Picture no: 17793j.tif
Adaptive Forward Lighting
3
(AFL) ensures better illumination of
zbends (curve lighting),
z crossings and narrow bends
(cornering light).
Curve lighting (1)
The light beam pivots based on
steering wheel position and speed
(from approx. 10 km/h).
The headlamps shine at an angle of up to
15 to the right or left of the direction of
travel.
Picture no:
Cornering light (2)
An additional light is switched on
depending on the stee ring wheel position
(from rotation of approx. 90), turn signal
position and speed (up to approx. 40 km/h).
The light is thrown approx. 90 to the
left or right of the car, to a distance of
approx. 30 metres.
Reversing function
If the lights are on, reverse gear is
engaged, and the turn signal is activated,
the cornering light on the appropriate side
is switched on. The cornering light stays on
for 15 seconds once the turn signal has
been switched off.
Picture no: 18249s.tif
Control indicator fo r adaptive driving
lamps
B
Illuminated: Fault in system. The system is
not ready for operation.
Contact a workshop for assistance.
If control indicator
B flashes for
approx. 4 seconds after the ignition is
switched on, this is a reminder that the
headlamps have been set to symmetrical
dipped beam; see "Headlamps when
driving abroad" 3117.
Back to overview

113
Lighting
Picture no: 18302s.tif
Lead-me lighting
3
The dipped beam remains switched on for
approx. 30 seconds once you have left the
vehicle and closed the driver’s door.
To activate
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk toward steering wheel.
5. Close driver’s door.
If the driver’s door is left open, the lamps
will go out after two minutes.
The light is switched off immediately by
inserting the key into the ignition or pulling
the turn signal stalk towards the steering
wheel again.
Picture no: 18420s.tif
Switching on the exterior lighting
with the remote control
3
The lead-me-to-the-car light function
switches the dipped beam on for
approx. 30 seconds.
Program function
This function can be activated and
deactivated depending on the key used,
see "Personalised key", P1 339 341. To activate
Press button
q on the remote control twice
when the vehicle is locked.
Country-specific application 3: To switch
on the Lead-me-to-the-car light function,
press button q on the remote control once
the vehicle is locked.
Switching on the ignition or pressing
button p on the remote control will
deactivate the Lead-me-to-the-car light
function early.
Back to overview

114 Lighting
Picture no: 18370s.tif
Parking lamps The front parking lamp and tail lamp of
one side of the vehicle can be activated
when parking:
1. Set light switch to 7 or A 3,
2. Ignition off,
3. Move turn signal stalk all the way up (right parking lamp) or down (left
parking lamp).
Confirmed by a signal and the
corresponding turn signal control indicator.
To switch it off, swit ch on the ignition or
move the turn signal stalk in the opposite
direction.
Picture no: 18201s.tif
Instrument illumination
,
Information display illumination

Lights come on when ignition is switched
on.
Adjustable brightness when exterior
lighting is switched on:
Hold down the button until the required
brightness is achieved.
Display mode 33100.
Courtesy lamp Automatic interior light
Comes on automatically when the vehicle is
unlocked with the remote control, when a
door is opened or when the key is removed
from the ignition switch after the ignition is
switched off.
Goes off automatically after a delay when
the doors are closed or immediately when
the ignition is switched on or the doors are
locked.
Brighter = Push button +
Darker = Push button -
Back to overview

115
Lighting
Picture no: 18303s.tif
Front courtesy lamp
Centre switch position: automatic interior
light, see previous page.
To operate manually from inside when the
doors are closed:
Picture no: 17131t.tif
Front courtesy lamp with reading lamps3
Automatic interior light, see previous page.
Pressing the button c when the doors are
closed.
Picture no: 17132t.tif
Front reading lamps 3
Operating using buttons a with the ignition
switched on.
On = Switch position I
Off = Switch position 0
Back to overview

116 Lighting
Picture no: 17133t.tif
Courtesy lamps and rear reading lamps 3
Operated with switch (I = on, 0 = off,
centre = automatic interior light). Welcome Light
3
After unlocking the car, the instrument and
switch lighting, the front and rear foot well
lighting 3 and the information display 3
come on for a few seconds.
Glove compartment lighting 3
Glove compartment lighting comes on
when the lid is opened.
Luggage compartment lighting
The luggage compartment light comes on
when the tailgate is open.
Automatically regulated centre console
lighting 3
Spotlight in housing of interior mirror.
Daylight-dependent, automatically
regulated centre console lighting with
ignition switched on.
Battery discharge protection To prevent the battery from becoming
discharged, the courtesy lamp, reading
lamps 3, luggage compartment lighting
and glove compartment lighting 3 switch
off automatically 5 minutes after the
ignition is switched off. Misted light covers The inside of the light covers may mist up
briefly in poor, wet and cold weather
conditions, in heavy rain or after washing.
The mist disappears quickly by itself; to
help, switch on the lights.
Back to overview

117
Lighting
Headlamps when driving abroad The asymmetrical dipped beam increases
the field of vision on the passenger side of
the lane.
This causes glare for oncoming traffic if the
vehicle is driven in countries where traffic
drives on the opposite side of the road. Do as follows to prevent glare:
Vehicles with halogen headlamps
Have headlights conv
erted in a workshop. Vehicles with Adaptive Forward Lighting
3
(AFL)
1. Pull and hold stalk for main beam on steering wheel (headlamp flash).
2. Switch on ignition.
3. After approx. 3 seconds, an acoustic signal sounds and then AFL control
indicator
B flashes approx. 4 seconds.
After the switch, AFL control indicator
B
flashes for 4 seconds each time the ignition
is switched on.
To return to asymmetrical dipped beam,
pull and hold the main beam stalk again,
switch on the ignition and wait for the
acoustic signal. AFL control indicator
B
will then discontinue flashing.
Control indicator
B
3 85. 3112.
Back to overview

131
Climate control
If a temperature below 16 C is set, Lo
appears in the display: the climate control
system runs constantly at maximum
cooling power. The temperature is not
regulated.
If a temperature above 28 C is set, Hi
appears in the display: the climate control
system runs constantly at maximum
heating power. The temperature is not
regulated.
The temperature setting is saved when the
ignition is switched off.
Picture no: 18484s.tif
Window demisting and de-icing
Misted or icy windows, e. g. due to damp
weather, damp clothing or low outside
temperatures:
Press V button. V appears in display:
control indicator in button illuminates.
Temperature and air distribution are set
automatically and the fan runs at a high
speed. The air flow can be increased or decreased
by turning the right knob.
To return to automatic mode: press
button
V or AUTO .
Heated rear window 346.
9
Warning
Disregard of the instructions could lead
to misting or icing of the windows and
subsequent accidents due to impaired
visibility.
FM AS [TP] REG CDinMP3

90.6
MHz
Back to overview

132 Climate control
Picture no: 18218s.tif
Manual settings
Under certain circumstances (e.g. iced or
misted windows), the functions of the
climate control system can be modified
manually.
Climate control system settings can be
changed via the centre knob, the buttons
and the menus depicted on the display.
To call up the menu, press the centre knob.
The Climate menu appears in the display.
Picture no: 18219s.tif
Individual menu items are marked by
turning the centre knob and selected by
pressing it. Selecting certain menus by
pressing the knob will open a submenu 3.
To exit a menu, turn the centre knob left or
right to Return or Main and select.
Manual settings are saved when the
ignition is switched off.
Picture no: 18221s.tif
Activating and deactivating cooling
system
Find option Climate in the menu AC and
press to select.
Deactivate when cooling or drying is
unnecessary (greatest fuel savings): Eco
appears in the display. The inflowing air is
neither cooled nor dehumidified. This
restricts the level of comfort offered by the
electronic climate control system. This may,
for example, cause the windows to mist up.
When cooling operates, condensation
forms and drips from the underside of the
vehicle.
Climate
Air distribut.
AC
Autom. blower
Air distribut.
Climate
Air distribut. AC Air conditioning
Autom. blower on / off
Back to overview