ignition OPEL MERIVA 2009 Service Manual

107
Lighting
Picture no: 14302s.tif
Lead-me lighting
3
Lead-me lighting when leaving the
vehicle 3
The dipped headlamps come on for
around 30 seconds after switching on and
closing the driver’s door.
To activate:
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door. If the driver’s door is left open, the lamps
will go out after two minutes.
The light is switched off immediately by
inserting the key into
the ignition or pulling
the turn signal stalk towards the steering
wheel again.
Picture no: 17920S.tif
Lead-me lighting when opening the
vehicle 3
The Lead-me-to-the-car lighting function
allows the dipped headlamps to be lit for
around 30 seconds using the remote
control.
This function must be activated (once):
Unlock the vehicle, put the key in the
ignition and press the light switch for
approx. 5 seconds - see next page,
Fig. 14136 S.
To deactivate the function permanently,
contact a workshop.

108 LightingTo activate the lead-me-to-the-car light
function, press button q on the remote
control twice with the vehicle locked.
Country-specific version 3: to enable the
lead-me-to-the-car function, press
button q on the remote control once with
the vehicle locked.
The lead-me-to-the-car light function is
deactivated immediately by pressing
button p of the remote control or
switching on the ignition.
Picture no: 14759s.tif
Instrument illumination
k,
Information display illumination
Lights come on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: Push to release knob
k and then turn it clockwise or
anticlockwise and hold until the desired
brightness is obtained.
Display mode 3 396.
Picture no: 14136s.tif
Courtesy lamp Automatic interior light
Comes on automatically when the vehicle is
unlocked with the radi o remote control or
when a door is opened.
Goes off automatically after a delay when
the doors are closed or immediately when
the ignition is switched on or the doors are
locked.
Front courtesy lamp
To operate manually from inside when the
doors are closed: on = Press light switch 0
off = Press light switch 0 again

109
Lighting
Picture no: 11607s.tif
Front reading lamps 3
Operate using buttons with the ignition
switched on.
Picture no: 12344t.tif
Courtesy lamps and rear reading lamps 3
Centre switch position: The rear courtesy
lamp comes on together with the front one
when a door is opened.
The rear reading lamps on the left and
right can be switched on separately. With
ignition on: Entry lighting
3
After unlocking the vehicle, the instrument
and switch illumination plus the courtesy
lamps come on for a few seconds.
Illuminated mirror in the sun visors 3
The lighting switches on when the cover is
opened.
Glove compartment lighting 3
The glove compartment light comes on
when the ignition is on and the lid is
opened.
Luggage compartment lighting 3
The luggage compartment light comes on
when the tailgate is open.
Automatically regulated centre console
lighting 3
Spotlight in housing of interior mirror.
Daylight-dependent, automatically
regulated centre console lighting with
ignition switched on. On = Switch position I
Off = Switch position 0

110 LightingBattery discharge protection
3
Some consumers such as the interior
lighting switch themselves off after
approx. 30 minutes if the ignition is off in
order to protect the battery charge. Misted light covers The inside of the light covers may mist up
briefly in poor, wet and cold weather
conditions, in heavy rain or after washing.
The mist disappears quickly by itself; to
help, switch on the lights. Headlamps when driving abroad The asymmetrical dipped beam increases
the field of vision on the passenger side of
the lane.
In countries where traffic drives on the
opposite side of the road, prevent glare as
follows.
Vehicles with halogen headlamp system
or Xenon headlamp system 3
Have headlights conver ted in a workshop.
Picture no: 14053h.tif
Vehicles with Adaptive headlight 3 (AFL)
1. Pull stalk towards steering wheel and hold.
2. Switch on ignition.
3. After approx. 3 seconds, an acoustic signal sounds and then AFL control
indicator
B flashes approx. 4 seconds.
After the switch, AFL control indicator
B
flashes for 4 seconds each time the ignition
is switched on. To return to asymmetrical dipped beam,
pull and hold the main beam stalk again,
switch on the ignition and wait for the
acoustic signal. AFL control indicator
B
will then discontinue flashing.
Control indicator
B
3 106.

123
Climate control
Picture no: 16496s.tif
Automatic mode
Basic setting for maximum comfort:
zPress AUTO button.
z Open all air vents.
z Switch on AC compressor 3125.
z Preset temperature to 22 C with turn
knob.
The temperature can be set higher or lower
as desired. Switching off the air conditioning
compressor (
ECO appears in display) can
have a detrimental effect on comfort and
safety 3125.
All air vents are actuated automatically in
automatic mode. The air vents should
therefore always be open 3115. Temperature preset
The left rotary knob can be used to set the
temperature to values of between 16 C
and 28 C.
For the sake of comfort, only change the
pre-selected temperature in small steps.
If the temperature setting is less
than 16 C,
LO appears in the air
conditioning display: the climate control
system runs constantly at maximum
cooling power, and the temperature is not
regulated.
If the temperature setting is
above 28 C, HI appears in the air
conditioning display: the climate control
system runs constantly at maximum
heating power, and the temperature is not
regulated.
The temperature settings remain stored
when the ignition is turned off.

124 Climate controlManual settings
Under certain circumstances (e.g. iced or
misted windows), the functions of the
climate control system can be modified
manually.
Manual settings are saved when the
ignition is switched off.
Make manual settings as follows when
necessary:
Picture no: 16501s.tif
Window demisting and defrosting
Misted or icy windows, e. g. due to damp
weather, damp clothing or low outside
temperatures:
Press button V, V appears in the air
conditioning display. Temperature, air dist
ribution and blower
are set automatically.
To return to automatic mode: press
button V or AUTO .
Heated rear window 341.
9 Warning
Disregard of the instructions could lead
to misting or icing of the windows and
subsequent accidents due to impaired
visibility.

126 Climate control
Picture no: 16506s.tif
Manual air recirculation mode
The air recirculation system prevents the
entry of outside air and the air in the
passenger compartment is circulated. Press button
4, % appears in the air
conditioning display.
To switch off manual air circulation: press
button 4 again.
Picture no: 16507s.tif
Air conditioning with the engine not
running
When the vehicle is stopped and the
ignition off, the residu al heat or cooling in
the system can be used for climate control
in passenger compartment, e.g. when
stopped at a level crossing.
Press AUTO with the ignition off. The
preselected temperature appears in the air
conditioning display. The temperature can
be adjusted with the left-hand rotary knob.
Residual climate control can only operate
for a limited period of time. To cancel,
press the AUTO button.
9 Warning
The exchange of fresh air is reduced in
air circulation mode. The quality of the
passenger compartment air
deteriorates which may cause the
vehicle occupants to feel drowsy. In
operation without cooling the air
humidity increases, so the windows may
mist up. Consequently, the air circulation
system should only be run for short
periods of time.

132 Driving and operation
Picture no: 17889s.tif
Winter programme T
In the event of difficulties starting off on
slippery roads, press button T ("A" and T
appear on the transmission display). The
manual transmission automated switches
to automatic mode and the vehicle sets off
in second gear.
The Winter programme is switched off by:
z pressing the T button again.
z turning off the ignition.
z switching to Manual mode.
z when clutch temperature is too high.
Picture no: 13322a.tif
Kickdown
If the accelerator pedal is pressed past the
pressure point, the transmission shifts to a
lower gear depending on engine speed.
During kickdown no manual gear shifting is
possible.
When the engine speed approaches its
upper limit, the transmission shifts to a
higher gear during kickdown even in
Manual mode.
Without kickdown this automatic shift is
not effected in Manual mode. Engine braking
Automatic mode:
When driving downhill, the manual
transmission automated does not shift into
higher gears until a fairly high engine
speed has been reached. When braking,
the manual transmission automated shifts
down in good time.
Manual mode:To utilise the engine br
aking effect, select a
lower gear in good time when driving
downhill.
"Rocking the car"
The selector lever should only be moved
between o (centre position) and R
repeatedly if it beco mes necessary to rock
the vehicle to free it from sand, mud, snow
or a hole. Do not race the engine and avoid
sudden acceleration.

133
Driving and operation
Picture no: 14083j.tif
Manoeuvring the vehicle
For accurate manoeuvring when parking,
at garage entrances etc., the creeping
movement can be utilised by releasing the
foot brake with a gear selected.
Never actuate accelerator and brake
pedals simultaneously.
To prevent damage, the manual
transmission automated deactivates the
"creep function" when the temperature of
the automatic clutch is extremely high. Vehicle storage
Apply the handbrake and remove the key
from the ignition. The most recently
engaged gear (indicator in transmission
display) remains engaged. With
N, no gear
is engaged.
When the ignition is switched off the
manual transmission automated no longer
responds to movement of the selector
lever.
If the ignition key is not removed, the
battery may be discharg ed if the vehicle is
then left to stand for a lengthy period of
time.
If the hand brake has not been applied, the
control indicator R flashes for a few
seconds after the ignition is switched off.
Picture no: 17890s.tif
Fault
To prevent damage to the automated
manual transmission, the clutch is closed
automatically at high clutch temperatures.
Warning light A lights up if there is a fault.
It is possible to continue driving but manual
mode can no longer be used for changing
gear.
If "F" also appears in the transmission
display, it is not possible to continue
driving.
Have cause of fault remedied by a
workshop. The system’s integrated self
diagnostics allow faults to be quickly
remedied.

134 Driving and operation
Picture no: 14721s.tif
Interruption of power supply
The clutch is not disengaged if there is an
interruption of the power supply when a
gear is engaged. The vehicle cannot move.
If the battery is flat, start the car using
jump leads 3166.
If the cause is not a flat battery, contact a
workshop for assistance. If the vehicle has
to be moved out of flowing traffic,
disengage clutch.
1. Apply hand brake and switch off ignition.
2. Open bonnet and engage support. 3. Clean transmission around the cap (see
Fig.) so that no dirt can get into the
opening when the cap is removed.
4. Rotate cap to slacken and remove by lifting upwards – see figure.
5. Turn the adjusting screw clockwise using a flathead screwdriver (vehicle tools 3
3 171) until clear resistance can be felt.
The clutch has now been disengaged.
6. Fit cleaned cap again. The cap must be in full contact with the housing.
Contact a workshop for assistance
immediately.
Picture no: 15270s.tif
Manual transmissionTo engage reverse, with the vehicle
stationary wait 3 seconds after declutching
and then pull up the bu tton on the selector
lever and engage the gear.
If the gear does not engage, set the lever in
neutral, release the clutch pedal and
depress again; then re peat gear selection.
Do not grind the clutch unnecessarily.
When operating, depress the clutch pedal
completely. Do not use the pedal as a foot
rest (increases clutch wear).
Caution
Do not turn beyond the resistance, since
this can damage the Easytronic.
Caution
Towing the vehicle and starting the
engine is not permitted when the clutch
has been released in this way, although
the vehicle can be moved a short
distance.