ignition PEUGEOT 106 2001.5 Owners Manual

YOUR 106 AT A GLANCE3
1-Side windows demisting vents
2 -Windscreen demisting vents
3 -Passenger airbag
4 -Adjustable centre vents
5 -Radio cassette player or spare
6 -Headlamp height adjustment
7 -Interior alarm protection disarm button
8 -Lights, fog lamps and horn stalk
9 -Instrument panel lighting rheostat
10 -Steering wheel with AIR BAG
11 -Windscreen wash/wipe stalk
12 -Ignition,ignition lock and engine immobiliser
13 -Electric mirrors switch
14 -Storage compartment 15
-Controls for: ¥Air conditioning or left-hand heated seat
¥ Lighter
¥ Hazard warning lights
¥ Rear screen and mirrors demisting
¥ Air recirculation or right-hand heated seat
16 -Gear lever
17 -Handbrake
18 -Electric window switches
19 -Passenger airbag disarming switch
20 -Ashtray
21 -Glove box
22 -Adjustable side vent
23 -Fuse box
24 -Bonnet opening control
06-05-2002

YOUR 106 AT A GLANCE4
The remote control Asingle press on button Alocks the
doors and boot or tailgate. A single press on button Bunlocks
the vehicle. Key The key switches on the ignition, locks and unlocks the doors, tailga-te, fuel filler flap and disarms thepassenger airbag.
Keep your key number in a safe place. This will enable you to
obtain a new key if it is lost or stolen.60LOCKING AND UNLOCKING
AB
06-05-2002

YOUR 106 AT A GLANCE5
ENGINE IMMOBILISER
This locks the engine control sys- tem and therefore prevents startingof the vehicle by anyone who does
not have the key. Operation Each key has a special code. When the ignition is switched on the key code is recognised by theengine immobiliser system andstarting is possible. The engine immobiliser automati- cally locks the engine control sys-tem a few moments after the igni-
tion has been switched off. Confidential card This shows the identification code which is required if any work is car-ried out on the system by your
PEUGEOT dealer. This code is hid-den by a film which must not beremoved unless required. Keep your card in a safe place, never in your vehicle.When buying a second- hand car:
- Make sure that you are giventhe confidential card.
- It is advisable to have the keycodes memorised by yourPEUGEOT dealer in order toensure that the keys in yourpossession are the only oneswhich can start the vehicle.57
06-05-2002

SEATS WITH MANUAL CONTROLS
1 .Forwards-backwards adjustment.
2 .Seat back angle adjustment.
3 .Access to rear seats (3 door).
For models fitted with air conditio- ning, the storage compartment forthe handbook and maintenanceguide is under the passenger seat.
FRONT AND SIDE AIRBAGS
Disarming the passenger airbag. Insert the ignition key in switch 1
and turn it:
Ðto t he ÇONÈ position, the pas-
senger airbag is armed,
Ð to the Ç OFFÈ position, the pas-
senger airbag is not armed.
Operational Check This is by means of the warning light on the instrument panel. If the passenger airbag is armed or if your vehicle is not fitted with apassenger airbag, the warning lightcomes on for 6 seconds when theignition is switched on. If the passenger airbag is notarmed, the warning light remainson. Always contact your PEUGEOT dealer if the warning light flashes. Passenger airbag precautionsFor a vehicle fitted with a disarming switch:
-disarm the air-bag if you ins-tall a rear-wards-facingchild seat,
-arm the airbag
when an adultis in the seat.
For a vehicle not fitted with a disar-ming switch: -do not installrear-wards-facing childseats on thefront passen-ger seat.
Never place your feet or any objecton the fascia.
YOUR 106 AT A GLANCE6
50
23
13
1
71
06-05-2002

-If the needle is in zone E, the
temperature is correct.
- If the needle is in zone F, the
temperature is too high. To lower the temperature of the oil, reduceyour speed.
Oil temperature gauge*
Engine auto-diagnostics
warning light*
It comes on each time the ignition isswitched on. If it comes on with the engine run- ning it indicates a malfunction in theinjection, ignition or emissioncontrol system. If your vehicle is Þt-
ted with a catalytic converter, thereis a risk of damage to it.
Contact a PEUGEOT dealer rapidly.
Front and side*
airbags
If the passenger airbag is armed or if your vehicle is not Þtted with apassenger airbag, the warning lightcomes on for 6 seconds when theignition is switched on.
Front airbag disarmed
If the passager airbag is disarmed,the indicator light remains on. In all cases, if the warning light ßashes, contact a PEUGEOT dea-
ler.
AIR
BAG
INSTRUMENTS AND CONTROLS22
F
E
Fuel supply cut-off* If there is a major collision, a device
switches off the supply of fuel to theengine.
To re-establish the supply to the
engine, press the button. * According to speciÞcation
Low fuel level warning
Indicates that the quantity of fuel remaining is less than 1 gallon
[5 litres] (Tank capacity approxima-tely 10 gallons [45 litres]).
06-05-2002

-If the needle is in zone E, the
temperature is correct.
- If the needle is in zone F, the
temperature is too high. To lower the temperature of the oil, reduceyour speed.
Oil temperature gauge*
Engine auto-diagnostics
warning light*
It comes on each time the ignition isswitched on. If it comes on with the engine run- ning it indicates a malfunction in theinjection, ignition or emissioncontrol system. If your vehicle is Þt-
ted with a catalytic converter, thereis a risk of damage to it.
Contact a PEUGEOT dealer rapidly.
Front and side*
airbags
If the passenger airbag is armed or if your vehicle is not Þtted with apassenger airbag, the warning lightcomes on for 6 seconds when theignition is switched on.
Front airbag disarmed
If the passager airbag is disarmed,the indicator light remains on. In all cases, if the warning light ßashes, contact a PEUGEOT dea-
ler.
AIR
BAG
INSTRUMENTS AND CONTROLS22
F
E
Fuel supply cut-off* If there is a major collision, a device
switches off the supply of fuel to theengine.
To re-establish the supply to the
engine, press the button. * According to speciÞcation
Low fuel level warning
Indicates that the quantity of fuel remaining is less than 1 gallon
[5 litres] (Tank capacity approxima-tely 10 gallons [45 litres]).
06-05-2002

INSTRUMENTS AND CONTROLS23
Instrument panel display When the ignition is switched on, this display shows in turn, the following infor- mation: - digital clock,
- service indicator,
- oil level indicator,*- total distance. Engine oil level When the ignition is switched on, engine not running, the service indicator is dis- played for a few seconds, then the engine oil level is indicated for approximate-ly 10 seconds.Maximum Minimum Check the level with the dipstick and top it up. The Þgure shown is only correct if the vehicle has been on stable, level ground, withthe engine stopped, for 10 minutes. No oil When the LEDs ßash, it is essential to top up the oil to the correct level, otherwise the engine will be damaged.
* According to speciÞcation
T otal distance and trip recorder
One brief press on button Achanges the
display between total distance and the
trip recorder. Resetting the trip recorder to zero A long press on the button resets the trip recorder to zero.
A
06-05-2002

INSTRUMENTS AND CONTROLS24
SERVICE INDICATOR This is a reminder of when the next service is due in accordance with the
manufacturerÕs maintenance sche-dule. Operation When the ignition is switched on the display shows the distance remai-ning (rounded Þgures) before thenext service is due. Example:4800 miles remain before
the next service is due. For Þve seconds after the ignition is switchedon, the display shows: 5 seconds after switching on the igni- tion the display resumes normal ope-ration and shows the total and tripdistances. When the distance remainingbefore the next service is lessthan 500 miles. Example:
450 miles remain before
the next service is due. For Þve seconds after the ignition is switched on, the display shows: 5 seconds after switching on the igni- tion the display resumes normal ope-ration. This indicates that a serviceshould be carried out shortly: When a service is overdue. For Þve seconds after the ignition is switched on, the service symbol andthe excess distance ßash. Example:
the service is overdue by
300 km The vehicle should be servi- ced very soon. For 5 seconds after the ignition is switched on the display shows: 5 seconds after switching on the igni- tion the display resumes normal ope-ration.
06-05-2002

INSTRUMENTS AND CONTROLS25
Service intervals If your vehicle is used in certain par-
ticularly difficult conditions it isnecessary to follow the "Arduousconditions" servicing schedule,which involves shorter intervals bet-
ween services (see the Warrantyand Maintenance Record booklet). Comment:If the time limit between
two services is reached before the relevant mileage limit, the servicespanner symbol will light up and thedisplay will show 0.
To change the service interval
- Switch off the ignition.
- Press and hold button 1. -
Switch on the ignition.
- Release the button straight away.
- The service interval is displayed.
- Each time button 1is pressed
brießy, the service intervals are alternated.
Example - When the required service interval is displayed, press button 1for
10 seconds to confirm (theselected service interval ßashes
for 10 seconds).
Release the button to conÞrm whenthe display stops ßashing. Reset to zero Y
our PEUGEOT dealer will carry out
this operation after each service.
However, if you carry out your service yourself, the zero resetprocedure is as follows:
- switch off the ignition,
- press and hold button 1,
- switch on the ignition,- keep button 1pressed for
10 seconds,
the display indicates [= 0]and the
service spanner symbol disappears.
1
06-05-2002

INSTRUMENTS AND CONTROLS25
Service intervals If your vehicle is used in certain par-
ticularly difficult conditions it isnecessary to follow the "Arduousconditions" servicing schedule,which involves shorter intervals bet-
ween services (see the Warrantyand Maintenance Record booklet). Comment:If the time limit between
two services is reached before the relevant mileage limit, the servicespanner symbol will light up and thedisplay will show 0.
To change the service interval
- Switch off the ignition.
- Press and hold button 1. -
Switch on the ignition.
- Release the button straight away.
- The service interval is displayed.
- Each time button 1is pressed
brießy, the service intervals are alternated.
Example - When the required service interval is displayed, press button 1for
10 seconds to confirm (theselected service interval ßashes
for 10 seconds).
Release the button to conÞrm whenthe display stops ßashing. Reset to zero Y
our PEUGEOT dealer will carry out
this operation after each service.
However, if you carry out your service yourself, the zero resetprocedure is as follows:
- switch off the ignition,
- press and hold button 1,
- switch on the ignition,- keep button 1pressed for
10 seconds,
the display indicates [= 0]and the
service spanner symbol disappears.
1
06-05-2002