lock PEUGEOT 207 2008 Owners Manual

FAMILIARISATION
Panoramic roof
This extensively glazed roof provides
incomparable visibility and light in the
passenger compartment.

 79
Static directional lighting
This additional lighting automatically pro-
vides extended visibility when turning.

 84 Opening rear screen (SW)
This equipment permits easy access to
the luggage compartment without the
need to open the tailgate.
Check that the rear screen is closed
properly before opening the boot or
locking the vehicle.

 77
Tyre under-infl ation detection
This equipment monitors the pressure
in each tyre and warns you if a puncture
or defl ation occurs.

 101 Rear parking assistance
This equipment provides a
warning when reversing by
detecting obstacles located
behind the vehicle.

 122

i
FAMILIARISATION
Remote control key

A. Unfolding/Folding the key.

B. Unlocking the vehicle.

C. Unlocking and partially opening the
rear screen (SW).

 66

Also...

D. Normal locking
or
Deadlocking of the vehicle. Fuel tank

1. Opening the fuel fi ller fl ap.

2. Opening and hooking the fuel fi ller
cap.
Capacity of the tank: approximately
50 litres.

 80 Bonnet

A. Interior control.

B. Exterior control.

C. Bonnet strut.

 125

i
FAMILIARISATION
Boot (SW)

1. Unlocking the vehicle.

2. Opening the boot.

 77 Vehicle locked
Panoramic roof (SW)

1. Unlocking and partially opening the
rear screen.

2. Opening the rear screen.

1. Opening the shutter.

2. Closing the shutter.

 79

1. Partially opening the rear screen.

2. Opening the rear screen.

 77
Vehicle unlocked
The tailgate and the rear screen
cannot both be open at the same
time, to prevent damage to the
glass and to the rear screen itself. Rear screen (SW)

FAMILIARISATION

1. Audio equipment steering wheel
control.

2. Steering lock and ignition.

3. Wipers/wash-wipe/trip computer
controls.

4. Instrument panel.

5. Driver's air bag.
Horn.

6. Dynamic stability control
(ESP/ASR) button.
Rear parking assistance button.
Central locking button.
Alarm button.
Electric child lock button.

7. Gear lever.

8. Handbrake.

9. Panoramic roof shutter control
(SW).

10. Exterior mirror controls.
Electric window controls.
Rear electric windows deactivation control.

11. Headlamp height adjustment.

12. Front door window de-icing vent.

13. Side adjustable and closing vent.

14. Windscreen de-icing vent.

i
FAMILIARISATION

Also...

5. Access to the rear seats
(3-door).

6. Armrest (except 3-door).
Front seat adjustment
Steering wheel adjustment

1. Forwards-backwards adjustment.

2. Height adjustment.

3. Seat back angle adjustment.

4. Head restraint height and angle
adjustment.

 50
1. Unlocking the control.

2. Height and depth adjustment.

3. Locking the control.

 57

FAMILIARISATION
Instrument panel Controls bar

A. With the ignition on, the fuel gauge
needle should rise.

B.
With the engine running, the associated
low level warning light should switch
off.

C. With the ignition on, the oil level
indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the
level which is low.

 18 Lighting of the indicator light indicates
the status of the corresponding function.

A. Deactivation of the ESP/ASR system.

 103

B. Deactivation of the rear parking as-
sistance.

 122

C. Central locking.

 66

D. Deactivation of the interior protection
alarm.

 70

E. Activation of the electric child lock * .

 99

1. With the ignition on, the orange and
red warning lights come on.

2. With the engine running, these
warning lights should switch off.
If a warning light remains on, refer to
the page concerned.

 19
Warning lights
* Except 3-door.

!
21
When the engine is running or the vehi-
cle is moving, the lighting of one of the
following warning lights indicates the
occurrence of a fault which requires
action on the part of the driver. Centralised alert.
Lighting of the centralised alert
is associated with the lighting
of another warning light:
- punctured wheel,
- braking,
- engine oil pressure,
- coolant temperature.
It is imperative that the vehicle is
stopped as soon as it is safe to do so. Service.
Lighting of the service warning
light indicates the occurrence of
a problem in one of the systems
which does not have a specifi c
warning light.
To identify the problem, consult the
message on the multifunction display.
After checking:
- the remote control battery,
- the engine oil level,
- the screenwash level,
for other cases, contact a PEUGEOT
dealer.
Punctured tyre.
The lighting of this warning light
indicates that one or more tyres
are punctured. It is imperative
that the vehicle is stopped as soon as it
is safe to do so.
Change the damaged wheel and have it
repaired by a PEUGEOT dealer.
Anti-lock braking system
(ABS).
The lighting of this warning light
indicates the occurrence of a fault
in the anti-lock braking system.
However, this does not prevent the opera-
tion of the vehicle’s assisted braking.
Any fault resulting in the lighting of
a warning light must be the subject
of further diagnostics by reading
the associated message on the
multifunction display.
If a problem arises, do not hesitate
to contact a PEUGEOT dealer.
Warning lights

i
i
25
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve min-
utes for the zero reset to be taken
into account.


Service indicator zero reset
After each service, the service indicator
must be reset to zero.
To do this, carry out the following pro-
cedure:

 switch off the ignition,

 press and hold the trip distance
recorder zero reset button,

 switch on the ignition; the distance
recorder display begins a count-
down,

 when the display indicates "=0" ,
release the button; the spanner
disappears.
The distance remaining may be
weighted by the time factor, depend-
ing on the driver’s driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Service overdue
For 5 seconds after the ignition is
switched on,
the spanner fl ashes to
indicate that the service must be carried
out as soon as possible.

Example: the service is overdue by
300 miles (km).
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the distance recorder resumes its
normal operation. The spanner re-
mains lit .

27
Total distance recorder
System which measures the total dis-
tance travelled by the vehicle during its
life. Lighting rheostat
System for manual adjustment of the
brightness of the instruments and con-
trols in relation to the exterior brightness. CLOCK
Integrated system which displays the
time with independent setting of the
hours and minutes.
The total and trip distances are dis-
played for thirty seconds when the ig-
nition is switched off, when the driver’s
door is opened and when the vehicle is
locked or unlocked.
Trip distance recorder
System which measures a distance
travelled during a day or other period
until it is reset to zero by the driver.

 With the ignition on, press the button
until zeros appear. Activation
When the lights are on:

 press the button to change the
brightness of the instruments and
controls,

 when the lighting reaches the mini-
mum setting, release the button,
then press again to increase it,
or

 when the lighting reaches the maxi-
mum setting, release the button,
then press again to reduce it,

 when the lighting reaches the level
of brightness required, release the
button.
Deactivation
When the lights are off, or in day mode
on vehicles fi tted with daytime lights,
pressing the button does not have any
effect. Setting

 Press the corresponding button
briefl y to obtain slow scrolling.
or

 Continue to press the corresponding
button to obtain rapid scrolling.
Button
1 : setting of the hours.
Button 2 : setting of the minutes.

!
!
51
No person or object must prevent
the seat slide from returning to its
initial position; return to this posi-
tion is necessary for the seat to
lock in place.
Take care not to trap the seat belt
to avoid hindering the passage of
the rear passengers.
4. Access to rear seats
(3-door)

 Pull the handle to fold the seat back
and move the seat forwards. On re-
positioning, the seat returns to its
initial position. 5. Head restraint height and angle
adjustment

 To raise the head restraint, pull it up-
wards.

 To remove the head restraint, press
the lug A and pull the head restraint
upwards.

 To put the head restraint back in po-
sition, locate the stems of the head
restraint in the holes, taking care
to keep them in line with the seat
back.

 To lower the head restraint, press
the lug A and the head restraint at
the same time.

 To tilt the head restraint, tilt the lower
part forwards or rearwards. The head restraint has a frame with
a notch which prevents the head
restraint from lowering; this is a
safety device which provides pro-
tection in the event of an impact.

The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never drive with the head restraints
removed; they must be in place and
correctly adjusted.