water pump Peugeot 207 CC 2014 Owner's Manual

8
i
!
CHECKS
121
207CC_EN_CHAP08_VERIFICATIONS_ED01-2014
BONNET
Protects the components of the engine
and provides access for checking levels.
 Push the exterior safety catch B to
the left and raise the bonnet.  Unclip the stay
C from its housing.
 Fix the stay in one of the two notch- es to hold the bonnet open.
Closing
 Take the stay out of the support notch.
 Clip the stay in its housing.
 Lower the bonnet and release it at the end of its travel.
 Pull on the bonnet to check that it is secured correctly.
RUNNING OUT OF FUEL
(DIESEL)
Opening
 Open the front left door.
 Pull the interior release lever A ,
located at the bottom of the door
frame.
The location of the interior release
lever prevents opening of the bon-
net while the left hand front door is
closed.
When the engine is hot, handle the
exterior safety catch and bonnet
stay with care (risk of burns).
1.6 litre HDi engine
 Fill the fuel tank with at least fi ve li-tres of diesel.
 Open the bonnet.
 If necessary, unclip the styling cover for access to the priming pump.
 Squeeze and release the priming pump repeatedly until resistance is
felt (there may be resistance at the
fi rst press).

Operate the starter until the engine
starts (if the engine does not start at the
fi rst attempt, wait around 15 seconds
before trying again).
 If the engine does not start after a few attempts, operate the priming
pump again then start the engine.
 Clip the styling cover back in place.
 Close the bonnet. On vehicles fi tted with HDi engines, the
fuel system must be primed if you run
out of fuel; refer to the corresponding
engine compartment view.
If the tank on your vehicle is fi tted with
a misfuel prevention device, refer to the
"Misfuel prevention (Diesel)" section.
Because of the presence of elec-
trical equipment under the bonnet,
it is recommended that exposure
to water (rain, washing, ...) be re-
stricted. If the engine does not start fi rst time,
don't keep trying but start the procedure
again from the beginning.

9PRACTICAL INFORMATION
145
207CC_EN_CHAP09_INFO PRATIQUES_ED01-2014
Engine compartment fuses
The fusebox is placed in the engine
compartment, near the battery (left-
hand side).
Access to the fuses
 Unclip the cover.
 Replace the fuse (refer to the cor-responding paragraph).
 When you have fi nished, close the cover carefully to ensure correct
sealing of the fuse box. Fuse table
Fuse N° Rating Functions
F1 20 A Engine control unit and fan assembly control relay
supply, timing and canister electrovalves (1.6 l 16V THP),
air fl ow sensor (Diesel), injection pump
(Diesel), water in Diesel sensor (Diesel), EGR
electrovalves, air heating (Diesel).
F2 15 A Horn.
F3 10 A Front wash-wipe.
F4 20 A Headlamp wash.
F5 15 A Fuel pump (petrol), Turbo electrovalves
(1.6 l 16V THP).
F6 10 A Vehicle speed sensor, automatic gearbox.
F7 10 A Electric power steering, directional headlamps,
directional headlamps control relay, switching and
protection unit (Diesel).
F8 20 A Starter motor control.
F9 10 A ABS/ESP control unit, brake pedal switch.
F10 30 A Engine control unit actuators (petrol: ignition coils,
electrovalves, oxygen sensors, injectors, heaters,
electronic thermostat) (Diesel: electrovalves,
heaters).
F 11 40 A Air conditioning blower.
F12 30 A Windscreen wipers Low/High speed.
F13 40 A Built-in systems interface supply (ignition positive).