change time Peugeot 208 2015 Owner's Manual

13
208_en_Chap01_instruments-bord_ed01-2016
Stop & Start time counter.
Average speed of the vehicle. Current or average fuel consumption. Remaining driving range.
Distance travelled by the vehicle.Neutral.
Automatic mode. Reverse. Park position.
Manual mode.
Change up
/ Change down.
Trip computerGearbox
Snow programme. Sport programme.
1
Instruments

1
31
208_en_Chap01_instruments-bord_ed01-2016
F Select the "Driving" menu.
F

S

elect the desired tab using your finger.
Touch screen
F Press the MENU button to
display the main menu. Successively:
Current information
Range
(miles or km)
The distance that can be
travelled using the remaining
fuel in the tank (based on the
average fuel consumption over
the last few miles).
Once the remaining range is below 20 miles

(30 km), dashes are displayed. After topping-up
with at least 5 litres of fuel, the range is recalculated
and displayed if it exceeds 60 miles (100 km).
Current fuel consumption
(l/100 km or km/l or mpg)
Calculated over the last few seconds.
Stop & Star t time counter
(if function present)
(In minutes
/ seconds -
hours
/ minutes)
This function is only displayed above
20

mph (30 km/h).
This value can vary following a change
in driving conditions or the relief of the
road, giving rise to a big difference in
current fuel consumption.
If dashes instead of figures continue
to be displayed when driving, contact
a PEUGEOT dealer or a qualified
workshop. If your vehicle has Stop & Start, a time counter
records the periods in STOP mode during a
j o u r n ey.
It is reset to zero every time the ignition is
switched on using the key.
Instruments

Access41
208_en_Chap02_ouvertures_ed01-2016
The alarm provides the following types of monitoring:
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compartment or
moves inside the vehicle. Activation
F

Switch off the ignition and get out of the vehicle.
F Press the locking button on the
remote control.
Timing:
The exterior perimeter monitoring is activated
after a delay of 5 seconds.
The interior volumetric monitoring after a delay
of 45 seconds.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds at the same time as the
interior volumetric monitoring. Automatic activation (depending on
version)
Monitoring is active 2 minutes after the last
door or the boot is closed.
F

T
o avoid triggering the alarm on entering
the vehicle, first press the button on the
remote control before opening a door.
The alarm monitoring system is
active (armed): the indicator lamp in
the button flashes once per second.
- Tilt*
The system monitors changes in the attitude of
the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or damaged.
Self-protection function
The alarm is triggered if the battery, the
central control or the siren wiring is put
out of service or damaged.
For all work on the alarm system, contact a
PEUGEOT dealer or a qualified workshop.
Total protectionDeactivation
* On GTi version. F

P
ress the unlocking button on
the remote control.
The alarm system is switched off
(disarmed): the indicator lamp in the
button goes off.
2

Driving115
208_en_Chap06_conduite_ed01-2016
Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently and change up without waiting.
During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you to engage the most suitable gear:
as soon as the indication is displayed in the instrument panel, follow it
straight away.
For vehicles fitted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and
CO
2 emissions and also helps reduce the background traffic noise.
I
f your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the
temperature in the passenger compartment down (sunroof and window
blinds...).
Switch off the air conditioning, unless it has automatic regulation, as
soon as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(film, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
6

Driving123
208_en_Chap06_conduite_ed01-2016
Electronic gearbox
5-speed 6-speed
R. Reverse.
N. N
eutral.
A.
A

utomated mode.
M.
M

anual mode.
R. R
everse.
N. N
eutral.
A.
A

utomated mode.
M.
M

anual mode.
Automated mode
This mode allows gear changing without action
by the driver.
Moving off
Lever at position N .
F
P
ress the brake pedal firmly.
F

S
tart the engine.
F

P
lace the lever at A or R .
F

R
elease the brake pedal and press the
accelerator pedal progressively.
If the engine does not start:
-
If N is flashing in the instrument panel,
move the lever to position A then to
position N .
-

I
f the message "Foot on the brake" is
displayed, press firmly on the brake pedal.
The A , R or N position of the lever is indicated
in the display.
You can change from position A to M
and from M to A at any time.
6

Driving127
208_en_Chap06_conduite_ed01-2016
Advice
F Select position D for automatic
changing of the gears.
The gearbox then operates in auto-adaptive
mode, without action by the driver. It
continuously selects the most suitable gear for
the driving style, the relief of the road and the
load in the vehicle.
For maximum acceleration, without touching
the gear lever, press the accelerator pedal fully
down (kick down). The gearbox changes down
automatically or holds the gear engaged up to
maximum engine speed.
When braking, the gearbox changes down
automatically to provide effective engine
braking.
When you take your foot off the accelerator
pedal quickly, the gearbox does not change up,
for your improved safety.Manual mode
This mode allows manual sequential gear
changing.
F
M
ove the gear lever to M .
F

P
ush the lever for ward to change
up.
F

P
ull the lever back to change down.
Invalid value
This symbol is displayed if a gear
is not properly engaged (selector
between two positions). When the engine is at idle, if position
R
,
D or M is selected with the brakes
released, the vehicle moves on its own
without pressing the accelerator.
Never leave children unsupervised
inside the vehicle when the engine is
running.
Apply the parking brake and select
position P if carrying out a maintenance
operation with the engine running.
Never select position N when the
vehicle is moving.
Never select positions P or R unless the
vehicle is at a complete stop.
You can change from D to M and M to D
at any time. If position N is engaged by mistake
when moving, take your foot off
the accelerator pedal, then engage
position


D to accelerate.
When the ambient temperature is below
-23°C, the engine should be left running
at idle for four minutes after starting,
to ensure the correct operation and
durability of the engine and gearbox.
6

Driving133
208_en_Chap06_conduite_ed01-2016
Manual deactivation
- Press.
- T he indicator lamp in the control remains
on.
-

A m
essage is displayed.
If the vehicle is stationary in Stop mode, the
engine immediately restarts.
Manual reactivation
Driving on flooded roads
Before driving through a flooded road,
it is strongly recommended that you
deactivate the Stop & Start system.
For more advice on driving, particularly
on flooded roads, refer to the
corresponding section.
Opening the bonnet
Before doing anything under the
bonnet, deactivate the Stop & Start
system to avoid the risk of injury related
to an automatic change to START
mode.
In some circumstances, such as maintaining
a comfortable temperature in the passenger
compartment, it may be useful to deactivate
Stop & Start.
The system can be deactivated at any time,
once the ignition is on.
This control switches off the Stop & Start
system.
Operating fault
The Stop & Start system requires a
12 V battery of special specification and
technology.
All work on this type of battery must
be done by a PEUGEOT or a qualified
workshop.
For more information on the 12 V
battery, refer to the corresponding
section.
In the event of a fault with the system, the
"ECO OFF" switch warning lamp flashes then
comes on continuously.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
In the event of a fault in STOP mode, the
vehicle may stall. All of the warning lamps
come on. It is then necessary to switch off
the ignition and start the engine again using
t h e


key.
-

Press.
-

T

he indicator lamp in the control goes off.
-

A c

onfirmation message is displayed.
If the engine is in STOP mode, it then
restarts.
The Stop & Start

system is reactivated
automatically every time the ignition is
switched on.
6

Driving147
208_en_Chap06_conduite_ed01-2016
Park Assist
For entry into a parking space (parallel
parking) the system does not detect
spaces which are clearly much smaller
or larger than the size of the vehicle.
This "parking assistance" system
is activated automatically during
manoeuvres; it is therefore possible
that a symbol comes on in the screen,
accompanied by an audible signal,
without affecting the manoeuvre. The selection of the type of manoeuvre
(entering or exiting a parallel parking
space) prevents a change to STOP
mode of Stop & Start.
In STOP mode, this selection restarts
the engine.
The Park Assist system cannot in any
circumstances replace the need for
vigilance on the part of the driver.
The driver must remain in control of
their vehicle ensuring that the space
remains clear during the manoeuvre.
In some circumstances, the sensors
may not detect small obstacles located
in their blind spots. During a manoeuvre the steering wheel
turns quickly: do not hold the steering
wheel, do not place your hand between
the spokes of the steering wheel and
take care with loose and bulky clothing,
scarves, handbags... There is a risk of
injury.
The driver can take back control of the steering
at any time by grasping the wheel.
Changing tyre sizes (out-size tyres,
winter tyres, ...) can inter fere with
the correct operation of the parking
assistance system. The system provides assistance in entering and
exiting a parking space when parallel parking.
The system detects a parking space and then
provides assistance with the parallel parking
manoeuvres.
It controls the steering and provides visual and
audible information to the driver.
The driver manages the accelerator, brakes,
gears and the clutch in the case of a manual
gearbox.
6

Driving151
208_en_Chap06_conduite_ed01-2016
Under-inflation detection
The under-inflation detection system
does not replace the need for vigilance
on the part of the driver.
This system does not avoid the need to
check the tyre pressures (including the
spare wheel) every month as well as
before a long journey.
Driving with under-inflated tyres impairs
road holding, extends braking distances
and causes premature tyre wear,
particularly under arduous condition
(high loading, high speed, long journey). The inflation pressures defined for
your vehicle can be found on the tyre
pressure label.
See the "Identification markings"
section.
Tyre pressures should be checked
when the tyres are "cold" (vehicle
stopped for 1 hour or after a journey of
less than 6 miles (10 km) at moderate
speeds).
Other wise (when hot), add 0.3 bar to
the pressures shown on the label.
Driving with under-inflated tyres
increases fuel consumption.
System which automatically checks the
pressures of the tyres while driving.
The system monitors the pressures in the four
tyres, once the vehicle is moving.
It compares the information given by the four
wheel speed sensors with reference values,
which must be reinitialised ever y time the
tyre pressures are adjusted or a wheel
changed
.
The system triggers an alert as soon as it
detects a drop in the inflation pressure of one
or more tyres.
6

Practical information
170
208_en_Chap07_informations-pratiques_ed01-2016
Level
Brake fluid
The brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Checking levels
Changing the fluid
Refer to the manufacturer's service schedule
for details of the interval for this operation.
Fluid specification
The brake fluid must conform to the
manufacturer's recommendations. It is normal to top up the oil level
between two services (or oil changes).
PEUGEOT recommends that you check
the level, and top up if necessary, every
3 000 miles (5 000 km).
Oil level
The check is carried out either when the
ignition is switched on using the oil level
indicator in the instrument panel (depending
on version), or using the dipstick.
Engine oil change
Refer to the manufacturer's service schedule
for details of the interval for this operation.
In order to maintain the reliability of the engine
and emission control system, never use
additives in the engine oil.
Oil specification
The oil must be the correct grade for your
engine and conform to the manufacturer's
recommendations.
Check all of these levels regularly, in line with
the manufacturer's service schedule. Top them
up if necessary, unless other wise indicated.
If a level drops significantly, have the
corresponding system checked by a PEUGEOT
dealer or a qualified workshop.
Take care when working under the
bonnet, as certain areas of the engine
may be extremely hot (risk of burns) and
the cooling fan could start at any time
(even with the ignition off). It will only be correct if the vehicle is on level
ground and the engine has been off for more than
30

minutes.