belt Peugeot 208 2017 Owner's Manual

2
.
Instrument panels 7
W arning and indicator lamps 1 0
Indicators
23
Trip computer

3
0
Date and time adjustment

3
3
Lighting dimmer

3
4Remote control

3
6
Doors
3
6
Locking – Key
3
7
Central locking
4
0
Boot
4
0
Alarm

41
Electric windows
4
3
PE UGEOT i- Cockpit 4 5
Steering wheel adjustment 4 6
Mirrors
46
Front seats

4
8
One-piece bench seat
5

3
2/3 – 1/3 split rear bench seat

5
3
Head restraints

5
4
Recommendations for ventilation
and air conditioning

5
5
Heating
5

6
Manual air conditioning
5

6
Dual-zone automatic air conditioning
5

7
Recirculation of interior air

6
0
Demisting – defrosting

6
0
Courtesy lamp

6
1
Interior ambient lighting
6

2
Sunroof blind

6
3
Interior fittings

6
3
Boot fittings

6
5
Rear shelf
6 5 L

ighting control stalk
6
7
Direction indicators
6
8
Automatic illumination of headlamps
6
9
Daytime running lamps/Sidelamps
7
1
Headlamp adjustment
7
1
Cornering lighting
7
1
Wiper control stalk
7
2
General safety recommendations 7 5
Hazard warning lamps 7 6
Emergency or assistance call
7

6
Electronic stability control (ESC)

7
8
Seat belts
8

1
Airbags


84
Child seats

8
8
Deactivating the passenger's front airbag
8

9
ISOFIX mountings and child seats
9

7
Child lock

1
03
Dashboard instrumentsAccess
Over view
Ease of use and comfort Lighting and visibility
Safety
Instruments and controls 4
Contents

12
Warning / indicator lampStateCause Action / Observations
Door(s) open Fixed and associated
with a message
identifying the door. Speed below 6
mph (10 km/h), a
door or the boot is not properly
closed. Close the door or boot.
Fixed, associated with
a message identifying
the door, together with
an audible signal. Speed above 6
mph (10 km/h), a
door or the boot is not properly
closed.
Seat belt(s) not
fastened/
unfastened Fixed or flashing
accompanied by an
audible signal. A belt has not been fastened or
has been unfastened.
Pull the strap then insert the tongue into the buckle.
Battery charge Fixed. The battery charging circuit has
a fault (dirty or loose terminals,
slack or cut alternator belt, etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Engine oil
pressure Fixed.
The engine lubrication system
has a fault. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualified workshop.
Maximum
coolant
temperature Fixed, with the needle
in the red zone.
The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up to the required level, if necessary.
If the problem persists, contact a PEUGEOT dealer or
a qualified workshop.
Dashboard instruments

15
Warning / indicator lampStateCause Action / Observations
Under-inflation Fixed, accompanied
by an audible signal
and a message. One or more wheels has
insufficient pressure.
Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after adjusting one or
more tyre pressures and after changing one or more
wheels.
For more information on Tyre under-inflation
detection
, refer to the corresponding section.
+ Flashing then fixed,
accompanied by the
Service warning lamp.
The system is faulty: tyre
pressures are no longer
monitored. Check the tyre pressures as soon as possible.
Have the system checked by a PEUGEOT dealer or a
qualified workshop.
Dynamic stability
control
(DSC/ASR) Flashing.
The DSC/ASR regulation is
operating. The system optimises traction and improves the
directional stability of the vehicle in the event of loss of
grip or trajectory.
Fixed. The DSC/ASR system has a fault. Have the system checked by a PEUGEOT dealer or a
qualified workshop.
Airbags Temporarily on. This warning lamp comes on for
a few seconds when you turn on
the ignition, then goes off.
This warning lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Fixed.One of the airbag or seat belt
pyrotechnic pretensioner systems
has a fault. Have it checked by a PEUGEOT dealer or a qualified
workshop.
1
Dashboard instruments

52
Armrest
Comfort and storage system for the driver and
front passenger.
Cover with opening lever
F
L
ift the lever to raise the lid.
Storage space in the console
F

P
ull the armrest fully up.
Access to rear seats
(3-door)
Folding the front seat forward
Standard model
F Pull only this control upwards to fold the
backrest and slide the whole seat for ward.
The front seat returns to its original position
when straightening the backrest. Sport model
F
Pull only this control for ward to fold the seat
backrest and move the whole seat for ward.
The front seat returns to its original position
when straightening the backrest.
Ensure that no object or person might
prevent the seat runners returning to their
original position; the return to this position
is necessary to secure the seat.
Ensure that the seat belt has reeled in
correctly so as to not impede passengers'
access to the rear seats.
Ease of use and comfort

53
One-piece rear bench
Bench seat with fixed one-piece cushion and
folding one-piece backrest.
Folding the backrest
F Move the front seats for ward if necessary.
F
P
osition the outer seat belts on the backrest
and buckle them.
F

L
ower the head restraints to the lowest
position. F

R
elease the seat backrest 2 by pressing
controls 1 simultaneously.
F

F
old the seat backrest 2 on to the fixed
cushion.
Raising the seat backrest
F Raise the seat backrest 2 .
F L atch the backrest in place, the red
indicators on each control 1 are no longer
visible.
F

U
nbuckle and return the outer seat belts to
their normal positions ready for use.
2/3 – 1/3 split rear bench
seat
Bench seat with fixed one-piece cushion and
split backrest (left-hand 2/3, right-hand 1/3)
which can be folded individually to adapt the
load space in the boot.
Folding the backrest
F Move the corresponding front seat for wards if necessary.
F

P
osition the corresponding outer seat belt
against the backrest and buckle it.
F

F
ully lower or remove the head restraint.
3
Ease of use and comfort

54
F Release the backrest by pressing control 1 of backrest 2 .
F

F
old the seat backrest 2 on to the fixed
cushion.
The rear cushion is not removable.
Returning the backrest to
the normal position
F Raise the seat backrest 2 .
F S ecure it, the red indicator in the control 1 is
no longer visible. F

U
nbuckle and reposition the seat belts
ready for use.
F
R
efit the head restraint(s).
When folding the seat, the centre seat belt
should not be fastened but laid out flat
along the seat.
When repositioning the seat backrest,
take care not to trap the seat belts.
The rear seat cushion does not fold, only
the seat backrest can be folded in order to
increase the boot loading space.
Head restraints
These have one position for use (up) and a
stowed position (down).
They can be removed and are interchangeable
side to side.
F

p
ull the head restraint fully upwards,
F

t
hen, press the lug A .
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
To remove a head restraint:
Ease of use and comfort

81
Seat belts
At the front
The front seat belts are fitted with a
pretensioning and force limiting system.
This system improves safety in the front
seats in the event of a front or side impact.
Depending on the severity of the impact, the
pretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of
the seat belt on the passenger’s chest, thus
improving their protection.
Locking
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
Release
F Press the red button on the buckle.
F G uide the seat belt as it reels in.
Height adjustment (5-door)
F To lower the attachment point, squeeze control A and slide it downwards.
F

T
o raise the attachment point, slide control
A upwards.
5
Safety

82
Warning lamp
Not fastened / unfastened.
When the ignition is switched on,
this warning lamp comes on in the
instrument panel.
It remains on for a certain time if the front
passenger has not fastened their seat belt.
Once this period has elapsed, the warning lamp
goes off if the driver's seat belt is fastened.
From approximately 12
mph (20 km/h)
this warning lamp flashes for 2


minutes
accompanied by an audible signal of increasing
volume. Once these 2
minutes have elapsed,
this warning lamp remains on until the driver
and/or the front passenger fastens their seat
belt.
Release
F Press the red button on the buckle.
F G uide the seat belt as it reels in.
F

O
n the outer seat belts, raise the bar to the
top of the backrest to prevent the tongue
from knocking against the side trim.
Warning lamp
Unfastened.
From approximately 12 mph
(20
km/h) and for 2 minutes, this
warning lamp flashes, accompanied
by an audible signal of increasing
volume, when one or more rear
passengers unfasten their seat belt.
Once these two minutes have elapsed, this
warning lamp remains on until the one or more
rear passengers fasten their seat belt.
At the rear
The rear seats are each fitted with a three-point
seat belt equipped, for the outer seats, with a
force limiter.
Locking
F Pull the strap then insert the tongue in the buckle.
F

C
heck that the seat belt is fastened
correctly by pulling the strap.
Safety

83
Advice
The driver must ensure that passengers use
the seat belts correctly and that they are all
fastened before setting off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do not interchange the seat belt buckles as
they will not fulfil their role fully.
The seat belts are fitted with an inertia reel
permitting automatic adjustment of the length
of the strap to your size. The seat belt is
stowed automatically when not in use.
Before and after use, ensure that the seat belt
is reeled in correctly.
The lower part of the strap must be positioned
as low as possible on the pelvis.
The upper part must be positioned in the
hollow of the shoulder.
The inertia reels have an automatic locking
device at the time of a collision, during
sudden braking or if the vehicle turns over.
You can release the device by pulling the
strap firmly and then releasing it so that it reels in slightly.
In order to be effective, a seat belt must:
-

b
e tightened as close to the body as
possible,
-

b
e pulled in front of you with a smooth
movement, checking that it does not twist,
-

b
e used to restrain only one person,
-

n
ot show any signs of cuts or fraying,
-

n
ot be converted or modified to avoid
affecting its performance.
In accordance with current safety regulations,
for all repairs on your vehicle's seat belts, go
to a qualified workshop with the skills and
equipment needed, which a PEUGEOT dealer
is able to provide.
Have your seat belts checked regularly by a
PEUGEOT dealer or a qualified workshop,
particularly if the straps show signs of
damage.
Clean the seat belt straps with soapy water or
a textile cleaning product, sold by PEUGEOT
dealers.
After folding or moving a seat or rear bench
seat, ensure that the seat belt is positioned and reeled in correctly.
Recommendations for children
Use a suitable child seat if the passenger is
less than 12
years old or shorter than one and
a half metres.
Never use the same seat belt to secure more
than one person.
Never allow a child to travel on your lap.
For more information on Child seats , refer to
the corresponding section.
In the event of an impact
Depending on the nature and seriousness
of the impact , the pyrotechnic device may
be deployed before and independently of the
airbags. Deployment of the pretensioners
is accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
In all cases, the airbag warning lamp comes
on.
Following an impact, have the seat belts
system checked, and, if necessary, replaced,
by a PEUGEOT dealer or a qualified
workshop.
5
Safety

84
Airbags
Impact detection zones
A.Frontal impact zone.
B. Side impact zone. Airbag deployment generates slight
smoke emissions and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
Although this smoke is not harmful,
sensitive individuals may experience slight
irritation.
The noise generated by the deployment
of one or more airbags (detonation)
may result in mild and temporary loss of
hearing.
General points
System designed to contribute towards
improving the safety of the occupants (with
the exception of the centre rear passenger)
in the event of violent collisions. The airbags
supplement the action of the seat belts fitted
with force limiters (with the exception of the
centre rear passenger belt).
If a collision occurs, the electronic detectors
record and analyse the front and side impacts
sustained in the impact detection zones:
-

i
n the case of a serious impact, the airbags
are deployed instantly and contribute
towards better protection of the occupants
of the vehicle (with the exception of the
centre rear passenger); immediately after
the impact, the airbags deflate rapidly so
that they do not hinder visibility or the exit of
the occupants,
-

i
n the case of a minor or rear impact or in
certain roll-over conditions, the airbags
may not be deployed; the seat belt
alone contributes towards ensuring your
protection in these situations. The airbags do not operate when the
ignition is switched off.
This equipment will only deploy once. If a
second impact occurs (during the same or
a subsequent accident), the airbag will not
be deployed again.
Safety