key Peugeot 301 2015 Owner's Manual

KeyWarning:
this symbol marks warnings which it is essential to observe for your
own safety, for the safety of others or to avoid any risk of damaging
your vehicle.
Information:
this symbol draws your attention to additional information for better
use of your vehicle.
Protection of the environment:
this symbol accompanies advice relating to protection of
the environment.
Page reference:
this symbol invites you to refer to the pages which provide details of
the function.
Your vehicle is fitted with only some of the equipment described
in this document, depending on its trim level, version and the
specification for the country in which it was sold.
We draw your attention to the following point:
The fitting of electrical equipment or accessories which are
not recommended by PEUGEOT may result in a failure of your
vehicle's electronic system. Contact a PEUGEOT dealer to be
shown the recommended equipment and accessories.
Thank you for choosing a 301.
This Handbook has been designed to help you make the most
of your 301 in all circumstances.
WELCOME

.
.
Instrument panel 10
Indicator and warning lamps
1
1
Service indicator
2

0
Distance recorders

2
2
Setting the date and time

2
3
Trip computer

2
4
Monochrome screen C (Audio system / Bluetooth)

2
6
MonitoringOver view
Remote control key 3
0
Alarm
3
4
Doors
36
Boot


37
Windows


39
Access
Front seats 4 0
Rear seats
4
2
Mirrors

4
3
Steering wheel adjustment
4

5
Ventilation
4

6
Heating


48
Manual air conditioning (without display screen)

4
8
Electronic air conditioning (with display screen)

5
0
Front demist - defrost

5
3
Rear screen demist - defrost

5
4
Comfort
Driving recommendations 60
Starting-switching off the engine
6
1
Parking brake

6
4
Manual gearbox
6

5
Electronic gearbox
6

6
Automatic gearbox

7
0
Gear shift indicator

7
4
Speed limiter
7

5
Cruise control

7
7
Rear parking sensors
7

9
Driving
Lighting control 81
Headlamp adjustment
8
6
Wiper control stalk

87
C

ourtesy lamps
8
9
Visibility
Eco-driving
Interior fittings 5
5
Boot fittings
5
8
Fittings
Contents

13
301_en_Chap01_controle-de-marche_ed01-2014
Warning / indicator lamp State Cause Action / Observations
Diesel engine
pre-heating fixed.
The key is at position 2 (ignition on) in
the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the climatic conditions (up to about
thirty seconds in extreme climatic conditions).
If the engine does not start, switch the ignition off and
then on, wait until the warning lamp goes off again,
then start the engine.
Parking brake fixed. The parking brake is applied or not
properly released. Release the parking brake to switch off the warning
lamp, keeping your foot on the brake pedal.
Observe the safety recommendations.
For further information on the parking brake, refer to
the "Driving" section.
Foot on the
brake pedal fixed.
The brake pedal must be pressed. With an electronic gearbox, press the brake pedal to
start the engine (lever in position N).
With an automatic gearbox, with the engine running,
press the brake pedal before releasing the parking
brake, to unlock the lever and come out of position P .
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.
flashing. With an electronic gearbox, if you
hold the vehicle on an incline using
the accelerator for too long, the
clutch overheats. Use the brake pedal and/or the parking brake.
1
Monitoring

30
301_en_Chap02_ouvertures_ed01-2014
System which permits central unlocking or locking of the vehicle using the lock or from a distance. It is also used to locate and start the vehicle, as well
as providing protection against theft.
Remote control key
Unfolding / folding the key Unlocking the vehicle
Unlocking using the key
F Turn the key in the driver's door lock towards the front of the vehicle to unlock.
Unlocking using the remote
control
F Press the open padlock to unlock the vehicle.
Unlocking is confirmed by rapid
flashing of the direction indicators for
approximately two seconds.
F

P

ress this button to unfold or fold the key.
Unlocking and partial opening of
the boot
F Press this button for more than one second to unlock the boot.
The boot opens slightly.
T

his action unlocks the vehicle
first.
Access

31
301_en_Chap02_ouvertures_ed01-2014
If one of the doors or the boot is still
open, the central locking does not
take place; the vehicle locks then
immediately unlocks, identifiable by the
sound of the locks rebounding.
When the vehicle is locked, if it is
unlocked inadvertently, it will lock
again automatically after thirty seconds
unless a door or the boot is open.
Locking using the remote control
F Press the closed padlock to lock the vehicle.
Locking the vehicle
Locking is confirmed by fixed lighting of
the direction indicators for approximately
two


seconds.
Locking using the key
F Turn the key in the driver's door lock, towards the rear of the vehicle to lock it. This function allows you to identify your vehicle
from a distance, particularly in poor light. Your
vehicle must be locked.
Locating your vehicle
F Press the closed padlock on the
remote control.
This will switch on the courtesy lamps and the
direction indicators will flash for a few seconds.
Check that the doors and boot are fully
closed.
2
Access

32
301_en_Chap02_ouvertures_ed01-2014
If the problem persists, contact a
PEUGEOT dealer as soon as possible.
If the battery is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
Changing the battery
F Remove the flat battery from its location.
F
F it the new battery into its location
observing the original direction of fitment.
F

C
lip the cover onto the casing.
In the event of a fault with the remote control,
you can no longer unlock, lock or locate
your


vehicle.
F

F

irst of all, use the key in the lock to unlock
or lock your vehicle.
F

T

hen, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
F Switch off the ignition and remove the
ignition key.
F

P
ress the closed padlock immediately for a
few seconds.
F

T
urn the key to position 2 (Ignition on) .
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Battery ref.: CR2032 / 3 volts.
F

U
nclip the cover using a small screwdriver
at the cutout.
F

L
ift off the cover.
Access

33
301_en_Chap02_ouvertures_ed01-2014
Lost keys
Go to a PEUGEOT dealer with the vehicle's registration document, your personal
identification documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder code
required to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your
pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of
your vehicle. You run the risk of stopping it from working and the remote control would have
to be reinitialised.
No remote control can operate when the key is in the ignition switch, even when the ignition
is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the
emergency services more difficult in an emergency.
As a safety precaution, never leave children alone in the vehicle, except for a very short period.
In all cases, it is essential to remove the key from the ignition switch when leaving
the

vehicle.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could
cause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a PEUGEOT dealer,
to ensure that only your keys can be used to open and start the vehicle. Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
2
Access

35
301_en_Chap02_ouvertures_ed01-2014
Triggering of the alarm Locking the vehicle without activating the alarm
F Lock the vehicle using the key.
Failure of the remote control
To deactivate the monitoring functions:
F

U
nlock the vehicle using the key.
F

O
pen the door; the alarm is triggered.
F

S
witch on the ignition; the alarm stops.
Faults
This is indicated by sounding of the siren
and flashing of the direction indicators for
thirty

seconds.
When the ignition is switched on, fixed
illumination of the indicator lamp indicates a
fault with the system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp informs you
that the alarm was triggered during
your absence. When the ignition
is switched on, this flashing stops
immediately.
2
Access

36
301_en_Chap02_ouvertures_ed01-2014
Doors
From outside
F After unlocking the vehicle using the remote control or the key, pull the door
handle.
Opening
From inside
F Pull the interior control lever of a front door; this unlocks the vehicle completely. -

w
hen the engine is running
,
this warning lamp comes on,
accompanied by a message in
the multifunction screen for a
few

seconds,
-
w
hen the vehicle is moving (speed
higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an
audible signal and a message in the
multifunction screen for a few seconds.
Closing
When a door is not closed correctly:
Secondary control
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Insert the key in the lock to lock or unlock
the door.
Passenger doors
F On the rear doors, check that the child lock is not on.
F

R
emove the black cap located on the edge
of the door, using the key.
F

I
nsert the key into the aperture without
forcing, then without turning, move the
latch sideways towards the inside of
the


door.
F

R
emove the key and refit the cap.
Access

39
301_en_Chap02_ouvertures_ed01-2014
Windows
Electric controls Manual controls
The electric window switches remain
operational for about 45 seconds after
switching off the ignition or until a front
door is opened. During this period of
45 seconds, if you open a door while
operating a window, the window stops.
Operating the switch again has no
effect until the ignition is switched on
again.Always remove the key from the ignition
when leaving the vehicle, even for a
short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window switches, the driver must
ensure that no one is preventing correct
closing of the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be particularly aware of children when
operating the windows.
1.
Le

ft hand front electric window.
2.
R

ight hand front electric window.
3.
R

ight hand rear electric window.
4.
Le
ft hand rear electric window.
5.
D

eactivating the rear electric window
switches .
To open or close the window, press or pull the
switch. The window stops as soon as the switch
is released.
Turn the window winder located on the door
trim panel.
Deactivating the rear window
controls
For the safety of your children, press switch 5
t o prevent operation of all of the windows,
irrespective of their position.
With the warning lamp on, the switches are
deactivated. With the warning lamp off, the
switches are active.
Model with front electric windows
Model with front and rear electric windows
2
Access