ECU Peugeot 307 2002 Owner's Manual

10OPENING THE BONNET Inside the vehicle: Push the
handle on the left-hand side, under the fascia. Outside the vehicle: Lift the catch, raise thebonnet and secure thestrut to keep the bonnetopen.
FILLING WITH FUEL This operation must be carried out with
the engine switched off.
➜ Open the fuel filler flap.
➜ Insert the key then turn it to the left.
➜ Remove the cap and hook it onto the clip on the inside of the flap.
A label on the inside of the flap shows which type of fuel to use.
When you fill your tank, do not continue after the third cut-off of the pump. This could cause your vehicle to malfunction. The capacity of the tank is approximately 13 gallons (60 litres). ➜ After filling the tank, lock the cap and close the flap.
Low fuel level warning light From the time this light comes on, the range remaining is approximately 30 miles(50 km).
7171
YOUR 307 AT A GLANCE

YOUR 307 IN DETAIL
62
CHILD SEATS Although one of PEUGEOT's main criteria when designing your vehicle, the safety of your children also depends on you.
For optimum safety, please follow the following precautions:
- All children under the age of 10 are required to travel in approved restraining equipment*, suited to their weight in a seatfitted with a seat belt.
- front passenger seat*: children under the age of 10 must not travel in the "forwards facing" position, unless the rear seats are already occupied by other children or the rear seats cannot be used (not present, folded). In this case, adjust the front
passenger seat to the "mid-travel" position. The "rear facing" position is authorised.
After carrying out numerous tests, PEUGEOT recommends the following systems: Up to 18 months (up to 29 lbs. or 13 kg) "Ršmer Babysure", is installed with its back to the engine and secured with a three-point seat belt, on either the front or rear seat. In the front, the passenger seat must be adjusted to the "mid-travel" position.
From 9 months to 3 or 4 years (20 to 40 lbs. or 9 to 18 kg) "Ršmer Prince" is fitted in the rear with a three-point seat belt.For the safety of your children, the seat and the restraining cushion must never be separated.
From 3 to 6 years (33 to 56 lbs or 15 to 25 kg) "Ršmer Vario": is fitted in the rear with a two or three point seat belt.
1
2
3

OPENING THE BONNET From inside:push the handle on the
driver's side under the fascia. From outside: lift the catch and
raise the bonnet. Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. "Bonnet open" warning* With the engine running or the vehicle moving, flashing of the
"STOP" centralised warning light accompanied by an audible signaland a diagram on the multi-function
display, warns you that the bonnet isnot properly closed. FILLING WITH FUEL Low fuel level
When the minimum fuel level in the tank is rea-ched, this warning lightcomes on.
You can still drive
approximately 30 miles (50 km). Flashing of the warning light indi- cates a malfunction of the fuelgauge.
Contact a PEUGEOT dealer.The engine must be switched off when filling with fuel.
Open the fuel filler flap.
Insert the key then turn it to theleft.
Remove the cap and hang it onthe hook located on the inside ofthe flap.
A label affixed inside the fuel fillerflap indicates which type of fuel touse. When you fill your tank, do not conti-
nue after the third cut-off of the
pump. This could cause your vehicleto malfunction. The capacity of the tank is approxi- mately 13 gallons (60 litres). After filling the tank, lock the cap and close the fuel filler flap.
* According to specification.
YOUR 307 IN DETAIL 71

YOUR 307 IN DETAIL85
BOOT LAYOUT 1 - Rear parcel shelf To remove the shelf: Ð unhook the two strings,Ð slightly raise the shelf, then remove it.There are several options for storing the shelf:Ð either behind the front seats,Ð or behind the rear seat.
2 - Hooks
3 - Stowing rings
4 - Luggage retaining net* Hooked onto the stowing rings, this enables your luggage to be secured.
5 - Open storage trays
6 - Socket for accessories* This is a 12 volt socket (lighter type), installed on the left side of the parcel shelf.
It is supplied with the ignition off.
*According to specification

YOUR 307 IN DETAIL93
For the front and side airbags* to be fully effective, observe the following safety rules:
¥
Wear a correctly adjusted seat belt.
¥ Sit in a normal upright position (passengers must not place their feet on the ifascia).
¥ Do not leave any accessories, objects or pets between the occupants and the air bags. It could hamper the operation of the air bags or injure the occupants.
¥ All work on the air bag system is strictly forbidden unless it is carried out by an approved PEUGEOT dealer.
¥ After an accident or if the vehicle has been stolen or broken into, have the airbag systems checked.
¥ The air bag systems have been designed to be fully operational for 10 years from the date of registration of thevehicle. Have them replaced by a PEUGEOT dealer after this period.
Front airbags
¥ Do not drive holding the steering wheel by its spokes or resting your hands on the centre part of the wheel.
¥ Smoke as little as possible; deployment of the airbags can cause burns or the risk of injury from a cigarette or pipe.
¥ Never remove or pierce the steering wheel or hit it violently.
Side airbags*
¥ Only put approved covers on the seats. Contact your PEUGEOT dealer. ¥ Do not fix or glue anything to the backs of the front seats. This could cause injury to the chest or arms when the side air bag inflates.
¥ Do not sit with the upper part of the body any nearer to the door than necessary.
Curtain air bags*
¥ Do not fasten or glue anything to the door pillars or to the roof as this could cause head injuries when the curtain airbag inflates.
¥ Do not remove the bolts from the handles on the roof; they help to secure the curtain air bags.
* According to specification

YOUR 307 IN DETAIL93
For the front and side airbags* to be fully effective, observe the following safety rules:
¥
Wear a correctly adjusted seat belt.
¥ Sit in a normal upright position (passengers must not place their feet on the ifascia).
¥ Do not leave any accessories, objects or pets between the occupants and the air bags. It could hamper the operation of the air bags or injure the occupants.
¥ All work on the air bag system is strictly forbidden unless it is carried out by an approved PEUGEOT dealer.
¥ After an accident or if the vehicle has been stolen or broken into, have the airbag systems checked.
¥ The air bag systems have been designed to be fully operational for 10 years from the date of registration of thevehicle. Have them replaced by a PEUGEOT dealer after this period.
Front airbags
¥ Do not drive holding the steering wheel by its spokes or resting your hands on the centre part of the wheel.
¥ Smoke as little as possible; deployment of the airbags can cause burns or the risk of injury from a cigarette or pipe.
¥ Never remove or pierce the steering wheel or hit it violently.
Side airbags*
¥ Only put approved covers on the seats. Contact your PEUGEOT dealer. ¥ Do not fix or glue anything to the backs of the front seats. This could cause injury to the chest or arms when the side air bag inflates.
¥ Do not sit with the upper part of the body any nearer to the door than necessary.
Curtain air bags*
¥ Do not fasten or glue anything to the door pillars or to the roof as this could cause head injuries when the curtain airbag inflates.
¥ Do not remove the bolts from the handles on the roof; they help to secure the curtain air bags.
* According to specification

CHANGING A WHEEL Parking the vehicle Park the vehicle on level, stable and non-slippery ground.
Apply the handbrake, engagefirst or reverse gear (position P
for the automatic gearbox) and
switch off the ignition.
Access to the spare wheeland the jack in the boot Lift the floor using the handle and secure it by hooking the cords tothe hooks of the parcel shelf. Tools The following tools are located in a polystyrene holder in the centre ofthe spare wheel: 1 -
Wheelbrace.
2 - Centralising tool.
3 - Removable chock.
4 - Jack with handle.
5 - Removable towing eye.
6 - Alloy wheel bolt trim remover*. Removing the wheel
Place the holder and chock 3(or
chock 3on its own if necessary)
under the wheel diagonally oppo- site to the one to be changed.
Remove the trim*, using thewheelbrace 1, pulling at the valve
passage hole.
Loosen the wheel bolts (forvehicles fitted with alloy wheels,remove the chrome trim first; seeparagraph on "Special featuresof alloy wheels").
* According to specification.
PRACTICAL INFORMATION 101

Place the jack 4in contact with
one of the four locating points A
on the sub-frame, (the one clo- sest to the wheel to be changed).
Extend the jack 4until its base is
in contact with the ground.Ensure that the centre line of thebase of the jack is directly abovelocating point Aon the sub-frame.
Raise the vehicle.
Unscrew the bolts and removethe wheel.
Fitting a wheel Position the wheel using the cen- tralising tool to assist you.
Tighten the bolts by hand andremove the centralising tool.
Partly tighten the bolts using thewheelbrace 1.
Fold the jack 4and remove it.
Fully tighten the bolts using thewheelbrace 1.
Replace the wheel trim*, startingby placing the wheel trim notchopposite the valve, and press iton using the palm of the hand.
Put the tools and the wheel backin the boot.
Note: a diagram on the holder indi-
cates the location of the tools.
Tighten the spare wheel securing strap to prevent noise and for yoursafety in the event of impact.
* According to specification.
PRACTICAL INFORMATION
102
For your safety, always change the wheel:
- on level, stable, non-slippery ground,
- with the handbrake on and the ignition switched off,
- with first or reverse gear enga- ged (position Pfor the automatic
gearbox),
- with the vehicle chocked. Never go underneath a vehicle that is supported only by a jack(use a ramp) After changing the wheel:
- have the tightening of the bolts and the tyre pressure checked by a PEUGEOT dealer as soonas possible.
- have the punctured wheel repai- red and refit it to the vehicle assoon as possible.

Special features of alloy wheels* Bolt coversAlloy wheel bolts are covered by chrome trims. Use tool 6to remove the trims befo-
re slackening the bolts. Fitting the spare wheel If your vehicle is fitted with a steel spare wheel, when fitting it, it is
nor-
mal to notice that the bolt washers
do not come into contact with the
rim. The spare wheel is secured by
the cone shape of each bolt. Tighten
the bolts fully. Fitting snow tyres If you fit snow tyres mounted on steel wheels, it is essentialto use special
bolts available from your PEUGEOT
dealer. Anti-theft bolts** If your wheels are fitted with an anti- theft bolt (one per wheel), the chro-me trim and then the plastic covermust be removed using tool
6, befo-
re unscrewing the bolt using one ofthe two anti-theft sockets (whichwere given to you on delivery of yourvehicle along with the duplicate keysand the confidential card) and thewheel brace 1.
Note : make a careful note of the
code number engraved on the head
of the anti-theft socket. This willenable you to obtain duplicate anti-theft sockets from a PEUGEOT
dealer.
* According to specification
** According to model and country
PRACTICAL INFORMATION 103

CHANGING A BULB Front lights Note:on the right side, remove the style cover, fixed with
two plastic screws, to access the bulbs. Handle the bulbs with a dry cloth.
1 - Dipped beam headlamps (H7-55 W),
2 - Main beam headlamps (H1-55 W),
3 - Front fog lamps* (H1-55 W). Turn the protective cover corresponding to the faulty bulb a quarter of a turn and remove it.
Disconnect the connector.
Press the end of the securing clip to free it. Changethe bulb. When fitting the new bulb, ensure that the direction notches are positioned correctly and that the securing
clip is fixed properly.
Reconnect the connector.
Refit the protective cover, positioning it with the arrowupwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with aprotective coating.
Do not clean them with a dry or
abrasive cloth, nor with a detergent or solvent pro-duct. Use a sponde and soapy water.
4 - Side lights (W 5 W). Pull the socket rearwards, remove the bulb and change it
5 - Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
Change the bulb.
Note: In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
* According to specification
PRACTICAL INFORMATION
104