engine Peugeot 307 CC 2003 Owner's Guide

22-09-2003
PRACTICAL INFORMATION127
1 -
Power steering reservoir.
2 - Windscreen/headlamp* wash
reservoir.
3 - Coolant reservoir. 4 -
Brake fluid reservoir.
5 - Battery.
6 - Fuse box.
7 - Air filter. 8 -
Dipstick.
9 - Engine oil reservoir.
* According to destination.
1.6 LITRE 16V PETROL ENGINE

22-09-2003
PRACTICAL INFORMATION
128
1 -
Power steering reservoir.
2 - Windscreen/headlamp* wash
reservoir.
3 - Coolant reservoir. 4 -
Brake fluid reservoir.
5 - Battery.
6 - Fuse box.
7 - Air filter. 8 -
Dipstick.
9 - Engine oil reservoir.
* According to destination.
2 LITRE 16V PETROL ENGINE

22-09-2003
PRACTICAL INFORMATION129
1 -
Power steering reservoir
2 - Windscreen/headlamp* wash reservoir
3 - Coolant reservoir 4 -
Brake fluid reservoir
5 - Battery
6 - Fuse box
7 - Air filter 8 -
Dipstick
9 - Engine oil filler cap
* According to destination.
2 LITRE 16V (180 bhp) PETROL ENGINE

22-09-2003
PRACTICAL INFORMATION
130
CHECKING THE LEVELS Oil level 
Check the level regularly and top
up between changes. The maxi-mum consumption is 0.5 l per600 miles (1,000 km). Check the level with the vehicle level, engine cold, using the oil levelgauge on the instrument panel orthe dipstick.
Dipstick There are two marks onthe dipstick: A=maximum
Never fill past this mark
B= minimum
To maintain the reliability of engines and emissioncontrol systems, the useof additives in engine oilis prohibited.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid used oil coming into
prolonged contact with the skin. Viscosity selection In all cases, the oil selected must meet the manufacturer's requirements. Brake fluid level:
Ð The level must always be between
the DANGER and MAXIMUM
marks in the reservoir.
Ð If the level drops substantially, contact a PEUGEOT dealer
immediately.
Fluid change:
Ð must be carried out according to the manufacturer's servicing schedule.
Ð use fluids recommended by the manufacturer, which fulfil DOT4standards.
Note: brake fluid is harmful to health
and very corrosive. Avoid all contactwith the skin. Cooling system Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlled
by the engine fan. As this fan canoperate with the ignition keyremoved and because the coolingsystem is pressurised, wait for atleast one hour after the engine hasstopped before carrying out anywork. Slacken the cap to the first notch torelease the pressure to prevent anyrisk of scalding. When the pressurehas dropped, remove the cap andtop up the level. Note:
the coolant does not need to
be changed. Used oil Do not dispose of used oil, brake fluid or coolant into drains or into theground. Power steering reservoir  Open the reservoir, with the engine at ambient temperature.The level should always beabove the MIN. mark and closeto the MAX. mark.
Windscreen and headlamp* wash level For best quality cleaning and for your
safety, we would advise that you use
products recommended by PEUGEOT.
* According to destination.

PRACTICAL INFORMATION
138
CHANGING A FUSE The fuse boxes are located in the lower part of the fascia (passengerside) and in the engine compartment. The spare fuses and special pliers
A
are fixed to the inside of the lid of the fascia panel fuse box. Removing and changing a fuse Before changing a fuse, you must establish the cause of the fault andhave it corrected. The fuse numbers are indicated on the fuse box.  Use the special pliers A.
Always change a faulty fuse for one of the same rating. Fascia panel fuses 
Unscrew the screw a quarter of a turn with a coin, then pull thehandle to open the cover andaccess the fuses.
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2Ð Not used.
4 15 A Front electric windows - Roll-over hoops - Retractable roof.
5 15 A Left brake light including trailer.
7 30 A Rear courtesy light, front courtesy light, map reading
lights - 12 V front socket - Glove box lighting.
Correct
PliersAIncorrect
22-09-2003

22-09-2003
PRACTICAL INFORMATION
140
Engine compartment fuses Fuse box
To access the fuse box in the engine compartment (next to the battery): 
unclip the cover.
Carefully close the cover and refit the style cover when you havefinished.
Fuse N¡ Rating Functions 1* 50 A Fan unit.
2* 30 A ESP/ABS pump motor.
3* 30 A ESP/ABS solenoid valves.
4* 70 A Built-in Systems Interface supply.
5* 70 A Built-in Systems Interface supply.
6* 60 A Retractable roof pump.
7* 30 A Ignition switch.
8* 70 A Power steering electro-pump unit.
Rating Functions
FV1* 20 A Single speed fan unit.
FV2* 30 A Dual-speed fan unit.
The electrical system of your vehicle is designedto operate with standardor optional equipment.
Before installing other electricalequipment or accessories on yourvehicle, contact a PEUGEOT deal-
er. PEUGEOT will not accept respon- sibility for the cost incurred inrepairing your vehicle or for recti-fying the malfunctions resulting
from the installation of accessoriesnot supplied and not recommend-ed by PEUGEOT and not installedin accordance with its instructions,in particular where the equipmentin question consumes more than
10 milliamperes.
* The maxi-fuses provide additional protection for the electrical sys-
tems. All work on the maxi-fusesand external fuses must be car-
ried out by a PEUGEOT dealer.
External
fuse N¡

22-09-2003
PRACTICAL INFORMATION141
Fuse N¡ Rating
Functions
1 10 A Automatic gearbox reversing lights switch - Automatic gearbox starting inhibitor relay control - Manual gearbox reversing lights switch -
Vehicle speed sensor.
2 15 A Canister solenoid valve - Fuel pump.
3 10 A Power steering control unit - ABS or ESP control unit.
4 10 A Injection control unit - Fan unit relay control - Additional heating relay control -
Automatic gearbox control unit - Automatic gearbox sequential control -
Automatic gearbox shiftlock relay.
5Ð Not used.
6 15 A Front fog lamps.
7Ð Not used.
8 20 A Fan unit relay control - Engine ECU supply.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Right-hand main beam.
12 10 A Left-hand main beam.
13 15 A Horn.
14 10 A Wash-wipe pump.
15 30 A Oxygen sensors - Exhaust gas recirculation solenoid valve - Ignition coil -
Injectors supply.
16 30 A Petrol engine air pump with automatic gearbox.
17 30 A Low/high speed wiper.
18 40 A Air conditioning blower.

PRACTICAL INFORMATION
138
CHANGING A FUSE The fuse boxes are located in the lower part of the fascia (passengerside) and in the engine compartment. The spare fuses and special pliers
A
are fixed to the inside of the lid of the fascia panel fuse box. Removing and changing a fuse Before changing a fuse, you must establish the cause of the fault andhave it corrected. The fuse numbers are indicated on the fuse box.  Use the special pliers A.
Always change a faulty fuse for one of the same rating. Fascia panel fuses 
Unscrew the screw a quarter of a turn with a coin, then pull thehandle to open the cover andaccess the fuses.
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2Ð Not used.
4 15 A Front electric windows - Roll-over hoops - Retractable roof.
5 15 A Left brake light including trailer.
7 30 A Rear courtesy light, front courtesy light, map reading
lights - 12 V front socket - Glove box lighting.
Correct
PliersAIncorrect
22-09-2003

22-09-2003
PRACTICAL INFORMATION139
* Fuses located inside the top of the fuse box.
Fuse no. Rating Functions
9 30 A Front electric windows - Automatic front electric windows.
10 15 A Diagnostic socket - 12 volt rear socket - Trailer.
11 20 A Audio equipment - Multi-function display - Steering wheel controls - Automatic gearbox - Retractable roof control unit.
12 10 A Front right and rear right side lights - Number plate and trailer lighting -
Central locking/alarm/hazard warning lights/ESP switches lighting -
Air conditioning/ashtray lighting - Automatic gearbox switches lighting -
Lighter.
14 30 A Door opening/closing controls - Deadlocking controls.
15 30 A Press-operation electric rear windows - Hinged covers motor.
16 10 A Engine fuse box - Alarm - Steering wheel controls - Air bags.
17 10 A Rear right brake light - 3rd brake light.
18 10 A Diagnostic socket - Steering wheel controls - Electrochromatic mirror - Brake pedal (stop) andclutch switches - Coolant level switch - Second brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights - Number plate and trailer lighting.
23 15 A Alarm siren - Interior alarm control unit.
24 15 A Instrument panel - Audio equipment - Multi-function display - Air conditioning - Rear parking
assistance - Rain/brightness sensor.
26 30 A Heated rear screen.
27* Not used.
28* 40 A Retractable roof pump.

22-09-2003
PRACTICAL INFORMATION
142
CHANGING A WINDSCREEN WIPER BLADE Special front windscreen wiper position 
Within one minute of switching
off the ignition, operate thewipers stalk to position the wiperblades in the centre of the wind-screen (maintenance position).
Changing a wiper blade  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe arm.
Note: the shortest blade is fitted on
the vehicle's right-hand windscreenwiper arm.
To return the windscreen wipers to their normal position, switch onthe ignition and operate the wiperstalk. ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for a cumulative duration ofthirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and letit run for a few seconds. LOAD REDUCTION FUNCTION When driving, certain functions (air conditioning, heated rear screen,
etc.) may be switched off temporari-
ly, depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
A flat battery will preventthe engine from starting.