fog light Peugeot 307 CC 2003 Owner's Manual

22-09-2003
102104
6YOUR 307 CC AT A GLANCE
Front and rear lights (ring A)Lights off. Side lights.
Dipped/main beam headlamps. Automatic switching onof the lights.
Automatic switchingon of the lights
To activate or deactivate the function, place the key in theaccessories position, the lightsstalk in position 0and press the
end of the lights stalk for morethan four seconds. WINDSCREEN WIPERS
2 Rapid wipe(heavy rain).
1 Normal wipe(moderate rain).
I Intermittent wipe.
or
AUTO Automatic wipe.
0 Off.


Single wipe.
Windscreen wash-wipe: pull the stalk towards you. Automatic wipe In the AUTO position, the wiper
operates automatically and adjusts its speed to the intensityof the rainfall.
Front fog lamps/Rearfog lamp (ring B)
Front fog lamps (first rota-tion of the ring forwards)
Front fog lampsand rear fog lamp(second rotation ofthe ring forwards)
Switching off: rotation of the ringbackwards.
STEERING WHEEL STALKS LIGHTING

22-09-2003
INSTRUMENTS AND CONTROLS
28
PETROL INSTRUMENT PANEL DIALS: MANUAL GEARBOX
1 - Rev counter.
2 - Seat belt not fastened warning light.
3 - Engine diagnostics warninglight.
4 - Handbrake and low brake fluidlevel warning light.
5 - Left-hand direction indicator.
6 - Coolant temperature indicator.
7 - Battery charge warning light. 8 -
Central (STOP) warning light.
9 - Low fuel level warning light.
10 - Engine oil pressure warning light.
11 - Fuel gauge.
12 - Right-hand direction indicator.
13 - ABS warning light.
14 -
Air bags and rear, protective,pop-up roll-over hoops warning light.
15 - Passenger air bag disarming indicator light.
16 - Speedometer.
17 - Service indicator, oil level and
total distance recorder.
18 - Trip recorder zero reset.
19 - Rear fog lamp indicator light.
20 - ESP/ASR warning light.
21 - Front fog lamps indicator light.
22 - Low coolant level warning light*.
23 - Main beam headlampsindicator light.
24 - Dipped beam headlampsindicator light.
25 - Lighting rheostat.
26 - Engine oil temperature gauge.
* According to engine.

22-09-2003
INSTRUMENTS AND CONTROLS29
PETROL INSTRUMENT PANEL DIALS: AUTOMATIC GEARBOX
1 - Rev counter.
2 - Seat belt not fastened warning light.
3 - Engine diagnostics warninglight.
4 - Handbrake and low brake fluidlevel warning light.
5 - Left-hand direction indicator.
6 - Coolant temperature indicator.
7 - Battery charge warning light. 8 -
Central (STOP) warning light.
9 - Low fuel level warning light.
10 - Engine oil pressure warning light.
11 - Fuel gauge.
12 - Right-hand direction indicator.
13 - ABS warning light.
14 -
Air bags and rear, protective,pop-up roll-over hoops warning light.
15 - Passenger air bag disarming indicator light.
16 - Speedometer.
17 - Service indicator, oil level and
total distance recorder.
18 - Trip recorder zero reset.
19 - Rear fog lamp indicator light.
20 - ESP/ASR warning light.
21 - Front fog lamps indicator light.
22 - Main beam headlamps indicator light.
23 - Dipped beam headlampsindicator light.
24 - Lighting rheostat.
25 - Engine oil temperature gauge.
26 - Snow programme indicatorlight.
27 - Gear lever position indicator.
28 - Sport programme indicator light.

22-09-2003
YOUR 307 CC IN DETAIL
102
THE LIGHTS STALK Front and rear lights Selection is by turning ring
A.
Lights off Side lights Dipped/main beam headlamps Automatic switching on of lights Dipped/Main beam change Pull the stalk towards you. Note:
with the ignition off, if the
driver's door is open, a buzzer sounds if you have left your lights on. Front fog lamps and rear fog lamp Rotate the ring Bforwards
to switch on and backwards to
switch off. The status is confirmedby the light on the instrumentpanel.
Front fog lamps (1st for-wards turn of the ring)
The front fog lamps operate with theside lights and dipped headlamps. When the main beam headlamps are switched on, the front fog lamps are
switched off. They are switched onagain when the main beam head-
lamps are switched off. Front fog lamps andrear fog lamp (2nd for-wards turn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ringtwice backwards.
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manual-
ly, the front fog lamps, the rear foglamp and the side lights will remainon (turn the ring backwards to switch
off the front fog lamps. The side
lights will then be switched off). "Follow me home" lighting In poor light or at night, if you leave your vehicle, the side lights anddipped headlamps can be left on forapproximately one minute.
To do this:
Ð place the key in the STOPposi-
tion,
Ð place the lights stalk in the 0posi-
tion,
Ð flash the headlamps,Ð get out of the vehicle and lock it.
In good or rainy weather, both day and night, thefront fog lamps and therear fog lamp are daz-
zling and are prohibited. Do not forget to switch them off when they are no longer needed.

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.

22-09-2003
PRACTICAL INFORMATION135
CHANGING A BULB Front lights Note:
on the right-hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the bulbs with a dry cloth.
1 - Dipped beam headlamps (H7-55 W).
2 - Main beam headlamps (H1-55 W).
3 - Front fog lamps (H1-55 W). Turn the protective cover corresponding to the faulty
bulb a quarter of a turn and remove it.
 Disconnect the connector.
 Press the end of the securing clip to free it. Change the bulb. When fitting the new bulb, ensure that the direction notches are positioned correctly and the securing clip
is fixed properly.
 Reconnect the connector.
 Refit the protective cover, positioning it with the arrowupwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with aprotective coating.
Do not clean them with a dry or abra-
sive cloth, nor with a detergent or solvent product .
Use a sponge and soapy water.
4 - Side lights (W 5 W).  Pull the socket rearwards, remove the bulb and
change it.
5 - Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
 Change the bulb.
Note: In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.

22-09-2003
PRACTICAL INFORMATION
136
Direction indicator side
repeaters (WY 5 W amber). 
Push the repeater forwards and
release the assembly.
 Hold the connector and turn thelens a quarter turn.
 Change the bulb. Rear lights
1 - Brake lights (diodes).
2 - Side lights (diodes).
3 - Direction indicators (P 21 W).
4 - Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side. Direction indicators 
Remove the 3 bolts of the corre- sponding boot side trim to access
the light (use the 20 Torx TM
adaptor
of tool Clocated in the handbook
pocket),
 Remove the light fixing nut insidethe boot,
 Remove the light,
 Unscrew the bulb holder 5a
quarter of a turn,
 Remove the bulb holder,
 Change the faulty bulb.
Note: When refitting, take care to
position the bulb holder and the light
correctly.
Amber coloured bulbs
(direction indicators andside repeaters), must bereplaced with bulbs ofidentical specification
and colour.
All work on the diode lights must be carried out
by a PEUGEOT dealer.

22-09-2003
PRACTICAL INFORMATION
136
Direction indicator side
repeaters (WY 5 W amber). 
Push the repeater forwards and
release the assembly.
 Hold the connector and turn thelens a quarter turn.
 Change the bulb. Rear lights
1 - Brake lights (diodes).
2 - Side lights (diodes).
3 - Direction indicators (P 21 W).
4 - Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side. Direction indicators 
Remove the 3 bolts of the corre- sponding boot side trim to access
the light (use the 20 Torx TM
adaptor
of tool Clocated in the handbook
pocket),
 Remove the light fixing nut insidethe boot,
 Remove the light,
 Unscrew the bulb holder 5a
quarter of a turn,
 Remove the bulb holder,
 Change the faulty bulb.
Note: When refitting, take care to
position the bulb holder and the light
correctly.
Amber coloured bulbs
(direction indicators andside repeaters), must bereplaced with bulbs ofidentical specification
and colour.
All work on the diode lights must be carried out
by a PEUGEOT dealer.

22-09-2003
PRACTICAL INFORMATION137
Number plate lights (W 5 W) 
Insert a thin screwdriver into one of the external holes of the lens.
 Push it outwards to unclip it.
 Remove the lens.
 Change the faulty bulb.
Third brake light (diodes)
Reversing light/fog lamp  unclip the corresponding boot lid trim at two points,
 move the trim aside gently toaccess the bulb holder 6,
 unscrew the bulb holder a quar-ter of a turn,
 remove the bulb holder,
 change the faulty bulb.
Note: When refitting, take care to
position the bulb holder correctly.
All work on the diode lights must be carried out
by a PEUGEOT dealer.