tyre pressure Peugeot 307 CC 2003 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2003, Model line: 307 CC, Model: Peugeot 307 CC 2003Pages: 173, PDF Size: 2.12 MB
Page 23 of 173
PEUGEOT SERVICING25
TYPE A AND C SERVICES AND THE INTERMEDIATE VISIT
Level
Operations Operation descriptions1st service visitA C Intermediate
DRAIN AND REFILLÐ Engine oil
Ð Oil filter Ð Fuel filter* REPLACEÐ Air filter element Ð Spark plugs Ð Engine oil (check + top-up) Ð Manual gearbox oil (check + top-up) Ð Battery (check + top-up) if removable cap LEVELSÐ Front windscreen wash (check + top-up) Ð Coolant (check + top-up) Ð Brake fluid (check + top-up) Ð Power steering fluid (check + top-up according to specification) Ð Operation of lights and indicators Ð Condition of glass, headlamp and light lenses and mirrors Ð Horn Ð Windscreen jets Ð Condition of wiper blades Ð Condition and tension of the ancillary drive belts Ð Handbrake Ð Condition of hydraulic circuits (hoses and covers) and check for leaks CHECKÐ Condition of rubber boots and gaiters Ð Brake pad wear Ð Play in hubs, link rods, ball joints, flexible mountings Ð Shock absorbers: check for leaks Ð Rear drum brake lining wear Ð Condition and pressure of tyres (including spare tyre) Ð Emission control check according to current legislation Ð Passenger compartment filter (according to specification) Ð Visual check of the whole vehicle by a PEUGEOT dealer
SERVICE*Ð Courtesy vehicle
ROAD TEST
: All driving conditions : If there are specific conditions * According to destination.22-09-2003
Page 130 of 173
22-09-2003
YOUR 307 CC IN DETAIL
120
ANTI-LOCK BRAKING SYSTEM
(ABS) AND THE ELECTRONICBRAKE FORCE DISTRIBUTION(EBFD)
The ABS, in conjunction with the electronic brake force distribution,increases the stability andmanoevrability of your vehicle onbraking, in particular on poor or slip-pery road surfaces. Note:
when changing wheels (tyres
and rims), make sure that these are approved. The anti-lock braking system comes into operation automatically whenthere is a risk of wheel lock.
Normal operation of the ABS maymake itself felt by slight vibrationsof the brake pedal. In emergency braking, press very firmly without releasingthe pressure.EMERGENCY BRAKING
ASSISTANCE SYSTEM
In an emergency, this system enables the optimum braking pres-
sure to be reached more quickly,thus reducing the stopping distance. It is triggered by the speed at which
the brake pedal is activated. The
effect of this is a reduction in theresistance of the pedal and an
increase in braking efficiency.
When this warning lightcomes on, connected to the
STOP
and ABS warning
lights, accompanied by abuzzer and the message
'Braking fault' , it indicates that there
is a malfunction of the electronicbrake force distribution, which cancause a loss of control of the vehiclewhen braking.
Stop immediately. In both cases, consult a PEUGEOT
dealer.
or
When this warning light comes on, accompanied by a buzzer and themessage "ABS fault" , it indicates
that there is a malfunction of theABS, which can cause a loss ofcontrol of the vehicle when braking.
Page 145 of 173
22-09-2003
PRACTICAL INFORMATION133
Place the jack 4in contact with one
of the four locating points Aon the
sub-frame, (the one which is clos- est to the wheel to be changed).
Extend the jack 4until its base is
in contact with the ground.Ensure that the centre line of thebase of the jack is directly belowthe locating point Aused.
Raise the vehicle.
Unscrew the bolts and removethe wheel.
Fitting a wheel Position the wheel using the cen- tralising tool to assist you.
Tighten the bolts by hand andremove the centralising tool.
Partly tighten the bolts using thewheelbrace 1.
Fold the jack 4and remove it.
Fully tighten the bolts using thewheelbrace 1.
Replace the wheel trim, startingby placing the wheel trim notchopposite the valve, and press iton using the palm of the hand.
Put the tools and the wheel backin the boot.
Note: a diagram on the holder indi-
cates the location of the tools.
Tighten the spare wheel securing strap to prevent noise and for yoursafety in the event of impact. For your safety, alwayschange the wheel:
Ð on level, stable, non-slippery ground,
Ð with the handbrake on and the ignition switched off,
Ð with first or reverse gear engaged (position Pfor the
automatic gearbox),
Ð with the vehicle chocked. Never go underneath a vehicle that is supported only by a jack(use a ramp). After changing the wheel:
Ð have the tightening of the bolts and the tyre pressure checked by a PEUGEOT dealer as soonas possible.
Ð have the punctured tyre repaired and refit it to the vehi-cle as soon as possible.
Page 159 of 173
22-09-2003
PRACTICAL INFORMATION145
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is primarily designed for transporting people and luggagebut it may also be used for towing a
trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.Above 1 000 metres, the maximumtowing load must be reduced by
10 % and so on for every
1 000 metres of altitude. The rear parking assistance function will be disarmed automatically whena towbar is fitted.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approach-es the maximum permitted withoutexceeding it. Cooling: towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
check the tyre pressures of
the towing vehicle and of the trailer,observing the recommended pres-sures. Braking: towing increases the braking
distance.Lights: check the electrical sig-
nalling on the trailer.Side winds: take into acount the
increased sensitivity to side wind.
Page 173 of 173
TECHNICAL DATA159
THE IDENTIFICATION FEATURES OF YOUR 307 CC
A. Manufacturer's plate.
B. Serial number on the bodywork.
C. Serial number on the fascia.
D. Tyres and paint colour reference. The label Don the driver's door pillar, near the hinges, indicates:
Ð the wheel and tyre sizes,
Ð the brands of tyres* approved by the manufacturer,
Ð the tyre pressures (the tyre pressure must be checked when the tyre is cold, at least once a month) ,
Ð the paint colour reference*.
E. Fuel consumption* in the corner of the windscreen.
* According to destination.
22-09-2003