wiper blades Peugeot 307 CC 2003 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2003, Model line: 307 CC, Model: Peugeot 307 CC 2003Pages: 173, PDF Size: 2.12 MB
Page 23 of 173
PEUGEOT SERVICING25
TYPE A AND C SERVICES AND THE INTERMEDIATE VISIT
Level
Operations Operation descriptions1st service visitA C Intermediate
DRAIN AND REFILLÐ Engine oil
Ð Oil filter Ð Fuel filter* REPLACEÐ Air filter element Ð Spark plugs Ð Engine oil (check + top-up) Ð Manual gearbox oil (check + top-up) Ð Battery (check + top-up) if removable cap LEVELSÐ Front windscreen wash (check + top-up) Ð Coolant (check + top-up) Ð Brake fluid (check + top-up) Ð Power steering fluid (check + top-up according to specification) Ð Operation of lights and indicators Ð Condition of glass, headlamp and light lenses and mirrors Ð Horn Ð Windscreen jets Ð Condition of wiper blades Ð Condition and tension of the ancillary drive belts Ð Handbrake Ð Condition of hydraulic circuits (hoses and covers) and check for leaks CHECKÐ Condition of rubber boots and gaiters Ð Brake pad wear Ð Play in hubs, link rods, ball joints, flexible mountings Ð Shock absorbers: check for leaks Ð Rear drum brake lining wear Ð Condition and pressure of tyres (including spare tyre) Ð Emission control check according to current legislation Ð Passenger compartment filter (according to specification) Ð Visual check of the whole vehicle by a PEUGEOT dealer
SERVICE*Ð Courtesy vehicle
ROAD TEST
: All driving conditions : If there are specific conditions * According to destination.22-09-2003
Page 110 of 173
22-09-2003
YOUR 307 CC IN DETAIL
104
After the ignition has been switched off, if the stalk was in awipe position, you must reactivatethis function:
Ð move the stalk to any position,
Ð then move it back to the required
position.
Special position of the front windscreen wiper
In the minute following switching off of the ignition, any action on the stalkpositions the wipers in the centre ofthe windscreen. This action enables you to position the wiper blades for winter parking,cleaning or replacement (See sec-tion "Practical information -Changing a wiper blade").
To park the wipers after this has been done, switch on the ignitionand operate the stalk.
Windscreen wash Pull the wipers stalk towards you. The windscreen wash, then the windscreen wipers, operate for afixed period.
WINDSCREEN WIPER STALK
Front windscreen wiper with intermittent wipe 2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
I Intermittent wipe.
0 Off.
Single wipe (press downwards).
In the Intermittent position, the wip-
ing speed is in proportion to the vehi-cle speed. Front windscreen wiper with automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
Single wipe (press downwards).
In the AUTOposition, the wiping
speed is in proportion to the intensityof the rainfall.
Page 156 of 173
22-09-2003
PRACTICAL INFORMATION
142
CHANGING A WINDSCREEN WIPER BLADE Special front windscreen wiper position
Within one minute of switching
off the ignition, operate thewipers stalk to position the wiperblades in the centre of the wind-screen (maintenance position).
Changing a wiper blade Lift the wiper arm, then unclip the blade and remove it.
Fit the new blade and push backthe arm.
Note: the shortest blade is fitted on
the vehicle's right-hand windscreenwiper arm.
To return the windscreen wipers to their normal position, switch onthe ignition and operate the wiperstalk. ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for a cumulative duration ofthirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and letit run for a few seconds. LOAD REDUCTION FUNCTION When driving, certain functions (air conditioning, heated rear screen,
etc.) may be switched off temporari-
ly, depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
A flat battery will preventthe engine from starting.