ignition PEUGEOT 4008 2012 Service Manual

121
4
Driving
The system is reactivated automatically at every new star t using the key or the STA R T/STOP button.

Reactivation

Press the "AS&G OFF"switch again.
The s
ystem is active again; this is confirmed by
the "AS &G O FF "
warning lamp going off in the
instrument panel or instrument panel screen.
Operating fault
In the event of a malfunction with the system,
the "AS&G OFF"warning lamp flashes in theinstrument panel or instrument panel screen,and the system no longer operates.
have it checked by a PEUGEOT dealer or a qualified workshop.
This system requires a specific battery with a special specification and technology (reference numbersavailable from a PEUGEOT dealer or aqualified workshop).
Fitting a battery not listed by
PEU
GEOT introduces the risk of malfunction of
the system.

Maintenance

The "Auto Stop & Go" system makes use of advanced technology. All work on this type of battery must be doneonly by a PEUGEOT dealer or aqualified workshop.
In the event o
f a fault in STOP mode, the
vehicle may stall. The following warning lampscome on in the instrument panel or instrumentpanel screen:
It is then necessar
y to switch off the ignition,
then restart the engine using the key or theSTA R T/STOP button.

124
Driving





Cruise control
System which automatically maintains the vehicle speed at the value programmed by the driver, without any action on the accelerator pedal.
The cruise control is switched on
manually:
the vehicle speed must be at least 25 mph(40 km/h) and second gear or higher must be engaged in the case of a manual gearbox.
Th
e cruise control is switched offmanually, byfan action on the brake or clutch pedal or if theASC system is triggered.
The pro
grammed speed can be exceeded
temporarily by pressing the accelerator pedal.
The cruise control cannot, in any circumstances, take the place of the need to comply with speed limits or of the vigilance and responsibility of the driver. The controls o
f this system are grouped
together on the steering wheel.1."ON/OFF"
button: activation / deactivation of the cruise control mode.
2
."COAST SET"button: store a drivingspeed and decrease the cruising speed. 3."ACC RES"
button: increase the cruising speed and recall the stored speed.4."CANCEL"button: stop control of the
vehicle's speed.

Steering mounted controls
When you press button 1, the "CRUISE"indicator comes on in the instrument panel.
Display in the instrument panel


Programming
)Press button 1.)Set the programmed speed byaccelerating to the required speed, then press button 2 "COAST SET" .

To return to the pro
grammed speed, simply release the accelerator pedal.
Switching off the ignition cancels any programmed speed value.

133
5
Visibility
rear foglamp
Rotate and release the rin
g C:) forwards a first time to switch on the front foglamps,)
forwards a second time to switch on the rear foglamp,)
rearwards a first time to switch off the rear foglamp,)
rearwards a second time to switch of thefront foglamps.
In good or rainy weather, both dayand night, the front foglamps and the rear foglamps are prohibited. In these situations, the power of their beams
may dazzle other drivers.
Do not forget to switch off the front foglamps and the rear foglamps when they are no longer necessary.
Model with front foglamps and a rear foglamp
Foglamp selection ring
.
The
y operate if at least the sidelamps are on.
) To switch on the rear foglamp, turn the ring C
forwards. )
To switch off the rear foglamp, turn thering C
rearwards.


front and rear fo
glamps

Lighting on reminder

An audible signal when the driver's door is opened warns the driver if the vehiclelighting is on, with the ignition off.
Switching off the lighting stops theaudible signal.

134
Visibility
The sensitivity of the automatic illumination of headlamps can be configured via the colour screen "Equipment" menu.
In foggy weather or in snow, thesunshine sensor may detect sufficient light. The lighting will not come on automatically. Do not cover the sunshine sensor, the
associated functions will no longer becontrolled.
Automatic switching off
When the lighting control stalk is at "dipped or main beam headlamps", if the ignition switch
is at "LOCK" or "ACC" or if the key has been
removed from the ignition switch, the lamps switch off automatically when the driver's
door is opened .

Daytime running lamps
Daytime lighting which comes on automatically
when the engine is star ted making the vehicle
more visible to other users.
This
function is assured by special lamps.
The lighting control stalk must be placed in
position "0"
or "AU TO "(day mode).

Automatic illumination of
headlam
ps
The sidelamps and the dipped beam headlamps come on
automatically, without any action on the par t of the driver, if a low level of exterior light is detected or if the wipers are switched on.
When the light returns to a sufficient level or the wipers areswitched off, the lighting is switched off automatically.
The sensor is located at the base of the windscreen.
Contact a PEUGEOT dealer or a qualified workshop to adjust
the sensitivity of the sensor.

135
5
Visibility

Switching off
The manual guide-me-home lighting switchesoff immediately if you.


- flash the headlamps again,

- place the lighting control stalk in another
position,

- switch the ignition on (or select "ON" mode
for vehicle with the "Keyless Entry and Starting" system).

Manual guide-me-home
lighting
Switching on
)
Place the lighting control stalk in the "OFF"
position, or "AUTO" for vehicles that have it. ) Place the ignition switch on "LOCK" and remove the key (or select "OFF" mode for
vehicles that have the "Keyless Entry andStarting" system). ) Within one minute after switching off the
ignition, "flash" the headlamps using the lighting control stalk.
The headlamps come on for around30 seconds. ) A further "headlamp flash" within 60 seconds of switching the ignition to OFF (or selection of "OFF" mode for vehicles
with the "Keyless Entry and Star ting" system) reactivates the function for a
further 30 seconds. Te m p o r a r i l
y keeping the dipped beam headlamps
on after the vehicle's ignition has been switched
o
ff makes the exit of the vehicle's occupants easier
when the light is poor.

The duration of the guide-me-home
lighting can be set in the colour screen"Equipment" menu.

136
Visibility





Exterior welcome lighting Remote switching on of the lighting makes your approach to the vehicle easier in poor light.
It comes on when the vehicle is unlocked remotely.
Switching on
) Place the lighting control in
position "OFF" or "AUTO".
) Press the open padlock on the
remote contro
l or the electronic key.
The sidelamps come on for about 30 seconds. For vehicles fitted
with automatic illumination of
headlamps, the welcome lightingonly comes on under conditions of low ambient light.




Switching off


The welcome lighting goes off immediately if:


- you press the open padlock on the remote control,

- you place the lighting control in another position,

- you switch on the ignition (or select "ON"
mode for vehicles fitted with the "Keyless
Entry and Star ting" system).




It is possible to choose the type of lamps switched on or to deactivatethe function via the colour screen"Equipment" menu.

142
Visibility











Courtesy lamps
Front courtesy lamp
Position 1
The cour tesy lamp comes on when a door or
the tailgate is opened.
When the door or the tailgate is closed again,
the lighting gradually dims for a few seconds
before switching off.
However, the cour tesy lamp is switched off automatically in the following cases:
- When the doors and the tailgate are closedand the ignition switch is placed in the
"ON"
position.
- When the doors and the tailgate are closedand you lock the vehicle.



Position 2

The cour tesy lamp is permanently off.
There are two map reading lamps, one on eachside of the cour tesy lamp.
Press the corresponding lamp lens A.


Map reading lamps
The durations of lighting of the front courtesy lamps can be configured viathe colour screen "Equipment" menu.

143
5
Visibility

Rear courtesy lamp


Position 1 "ON"

The cour tesy lamp is permanently on.
Position 2 "●"
The cour tesy lamp comes on when a door or
the tailgate is opened. When the door or the
tailgate is closed again, the lighting gradually
dims for a few seconds before switching off.
However, the cour tesy lamp is switched off immediately in the following cases:
- When the doors and the tailgate are closedand the ignition switch is placed in the"ON"
position.
- When the doors and the tailgate are closed
and you lock the vehicle.
Position 3 "OFF"
The cour tesy lamp is permanently off.

Courtesy lamps automatic
switch off
The duration of lighting of the rear courtesy lamps can be configured viathe colour screen "Equipment" menu. With the en
gine off, the cour tesy lamps,
map reading lamps and boot lamp switch off automatically after 30 minutes to prevent
discharging of the battery.
The cour tesy lamps are switched on again if
the ignition switch is placed in the "ON"
or "ACC"
position, if you open then close a door or the tailgate or if you use the remote control.

144
Visibility





Boot lamp
This comes on automatically when the boot is
opened and goes off automatically when the boot is closed.





Panoramic roof lighting


When active, the panoramic roof lighting comes
on if the ignition switch is placed in the "ON"
or
"ACC"
position.

Deactivation
When the ignition switch is placed inposition "ON"or "ACC":)Press this button repeatedly until the
lighting goes off.

Settings

When the ignition switch is placed inposition "ON"or "ACC":)Press this button repeatedly to obtain the
desired lighting level (high, medium, low).

145
6
Safety











Direction indicators
)Left: lower the lighting stalk passing thepoint of resistance.)Right: raise the lighting stalk passing thepoint of resistance.
"Motorway" function
)Press briefly upwards or downwards,
without going beyond the point of resistance; the direction indicators will flash 3 times.


The function can be deactivated via the colour screen "Equipment" menu.







Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicators flash.
They can operate with the ignition off.
Automatic operation of
hazard warnin
g lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lampscome on automatically.
They switch off automatically the first time youaccelerate. ) You can also switch them off by pressing
the button.







Horn
Audible warning system to alert other road
users to an imminent danger. ) Press the central part of the steeringwheel.
Use the horn moderately and only in thefollowing circumstances:


- immediate danger,





- approaching a location lackingvisibility.