lock Peugeot 406 2003 Owner's Manual

17-02-2003
11 -Driver's air bag. Horn.
12 - Windscreen wash-wipe stalk.
Trip computer stalk.
13 - Radio remote control stalk.
14 - Steering lock and ignition.
15 - Electric mirror controls.Window controls.Rear window locking control.
16 - Electronic Stability Programme (ASR/ESP)switch.
17 - Headlamp height adjustment.
18 - Fuse box.
19 - Steering wheel adjustment.
20 - Cruise control.
21 - Rear ashtray. 22 -
Cup-holder.
23 - Handbrake.
24 - Heated seat switches. Passenger air bag disarming switch. Alarm button.
25 - Lighter.
26 - Rear footwell heating vent.
27 - Front ashtray.
28 - Gear lever.
29 - Radio.
30 - Heating/ventilation controls.
31 - Multifunction display.
YOUR 406 AT A GLANCE
3
1 - Speaker (tweeter) location.
2 - Window demisting vent.
3 - Side adjustable heating/ ventilation vent and air flowregulation.
4 - Glove box.
5 - Passenger air bag.
6 - Windscreen demistingvents.
7 - Central adjustable heating/ventilation vents and air flowregulation.
8 - Hazard warning lightsswitch.
9 - Lights and directionindicators stalk. Arming/disarming of automatic switching on oflights.
10 - Instrument dials.

17-02-2003
THE KEYS The keys allow you to switch on the ignition and to independentlyoperate the locks on the frontdoors, the glove box and the pas-senger air bag disarming switch.
Central locking
From the driver's door, the keysallow you to lock and unlock thedoors and the boot. If one of the front doors is open, the central locking does not work. The remote control performs the same functions at adistance.The remote control LockingPressing button
Alocks the vehicle.
This is confirmed by the fixed lighting of the direction indicatorsfor approximately two seconds. Unlocking Pressing button Bunlocks the
vehicle.This is confirmed by the rapid flashing of the direction indicators. STARTING
STOP position:
The ignition is off.
1st notch, Accessories position:
The ignition is off but the acces- sories can be used. 2nd notch, Running position: The ignition is on. Starting position:
Operates the starter.
YOUR 406 AT A GLANCE
4
Key without
remote control Key with
remote control
103

SEAT BELTS Front seat belt height adjustment Pinch control 1and slide it.
To lock the seat beltsPull the strap, then insert the end into the buckle.
YOUR 406 AT A GLANCE
7
144123
STEERING WHEEL
HEIGHT AND DEPTHADJUSTMENT  Pull handle Ato unlock the
steering wheel.Adjust the height and depth of the steering wheel then lock itby pushing handle Ain fully.
142
ELECTRIC MIRRORS
Turn knob 6to the right or left to
select the corresponding mirror.Then move the knob in all four directions to adjust. Fold-back electric mirrors With the ignition switched on, turn knob 6to position A.
17-02-2003

17-02-2003
Moving Off
To move off from position P:
 It is essential to press the brake pedal to exit position P (shift lock).
 Select the required function ( R, D, 3, 2or1), then gradually release the pressure on the brake pedal; the vehi-
cle will move off immediately.
You can also move off from position N:
 Release the handbrake, with your foot on the brake.
 Select the required function ( R, D, 3, 2 or 1) then gradually release the pressure on the brake pedal; the vehi-
cle will move off immediately.
The four speed automaticgearbox provides the comfort of integral automatic regulation, enhanced by a sport
programme (switch A) and a snow programme (switch B).
Gear selection gate  Move the lever in the gate to select one of the functions.
Once it has been selected, the indicator light for that function illuminates on the instrument panel display.
P ark (parking): for parkingthe vehicle and startingthe engine, with the handbrake on or off.
R everse: for reversing. Select this function with the vehicle stationary and the engine at idle.
N eutral: for startingthe engine and for parking, with the handbrake on.
D rive: for driving in auto-adaptive mode (automatic changing of the four gears).
3: for urban driving or driving on winding roads, (automatic changing of the first three gears only).
2: for driving on mountain roads or fortowing a trailer (automatic changing of the first two gears only).
1: for tackling steep gradients (selection of first gear only).
Special feature of the gearbox (1.8 litre, 2 litre petrol and 2 litre turbo diesel HDI) Selection of first gear is by press- ing switch Cwith the gear lever in
position 2.
To change out of first gear, pressswitch C again or operate
the lever.
148
12YOUR 406 AT A GLANCE
THE AUTOMATIC AUTOADAPTIVE GEARBOX V6 engine 1.8 litre, 2 litre petrol and 2 litre turbo diesel HDI engines

17-02-2003
Handbrake, low brake fluid level and electronic brake force distribution warning light This comes on each time the ignition is switched on.
It indicates either:
Ð that the handbrake is on or has not been released correctly,
and when coupled with the central (STOP) warning light:
Ð an excessive drop in the brake fluid level (if the light remains on even with the handbrake released),
Ð lit at the same time as the ABS warning light, it indicates a malfunction of the electronic brake force distribution system.
Stop immediately.
Contact a PEUGEOT dealer.
Anti-lock braking system (ABS) warning light This comes on for 3 seconds each time the ignition is switched on.If it comes on at over 8 m.p.h. (12 km/h), it indicates a malfunction of the ABS.
However, the vehicle retains conventional servo-assisted braking.
Contact a PEUGEOT dealer.
Clogging of the particulate emissionfilter warning light(diesel engine)
Display of this warning light is accompanied by an audible signal. The flashing of this light while the engine is running is caused either bythe particulate emission filter beingoverloaded or by the engine runningtoo long at idle (white smoke from
the exhaust). There is a risk of the fil-ter clogging if the same conditions ofoperation are maintained. As soon as possible, drive for at least three minutes at a speedexceeding 37 m.p.h. (60 km/h), if dri-ving conditions allow this. If the light comes on, contact a
PEUGEOT dealer as soon aspossible. Front brake pad wear warning light
For your safety, have the pads replaced as soon as this light comes on.
YOUR 406 IN DETAIL
131
ESP Electronic Stability Programmeoperation indicatorlight
This flashes when the system is operating. It is lit continuously if disarmed or if there is a fault.

YOUR 406 IN DETAIL
60
AUDIO RB2
1 -
Press (behind)
2 - Press (behind) Function
Increase volume Decrease volume
1 + 2 - Simultaneous press
3 - Press Cutting off the sound (mute); restoring the sound by pressing any button Automatic search of higher frequencies (radio) Selection of next track (CD and cassette)
4 - Press Automatic search of lower frequencies (radio)
Selection of previous track (CD and cassette)
5 - Press the end Source selection
(radio, cassette, CD changer)
6 - Rotation(clockwise) Selection of higher frequency station stored in memory (radio)Selection of next CD - Reversal of direction of play (cassette)
7 - Rotation(anti-clockwise) Selection of lower frequency station stored in memory (radio)Selection of previous CD -
Reversal of direction of play
(cassette)
Movement
17-02-2003

YOUR 406 IN DETAIL
70
AUDIO RM2
1ÐPress (behind)
2Ð Press (behind) FunctionIncrease volume. Decrease volume.
1 + 2 Ð
Simultaneous press
3Ð PressCutting off of the sound (mute); restoring of the sound by pressing any button. Automatic search of upper frequencies (radio) - Selection of the following track (CD).
4ÐPressAutomatic search of lower frequencies (radio) - Selection of the previous track (CD).
5ÐPress the endChange of source (radio/cassette/CD changer).
6ÐRotation
(clockwise)Selection of next memorised station (radio) - Selection of following CD.
7Ð Rotation
(anti-clockwise)Selection of previous memorised station (radio) - Selection of previous CD.
Stalk movement
17-02-2003

YOUR 406 IN DETAIL
80
AUDIO RD3
1 Ð Press (behind)
2 Ð Press (behind) Function
Increase volume Decrease volume
1 + 2 Ð Simultaneous
press
3 Ð Press Cutting off the sound (mute); restoring the sound by pressing any button Automatic search of higher frequencies (radio) Selection of next track (CD)
4 Ð Press Automatic search of lower frequencies (radio)
Selection of previous track (CD)
5 Ð Press the end Source selection (radio/CD/CD changer)
6 Ð Rotation
(anti-clockwise) Selection of higher frequency station stored inmemory (radio) - Selection of next CD (CD changer)
7 Ð Rotation
(anti-clockwise) Selection of lower frequency station stored in memory (radio) - Selection of previous CD (CD changer)
Movement
17-02-2003

17-02-2003
VENTILATION 1 -Windscreen de-icing or demisting vents.
2 - Front window de-icing or demisting vents.
3 - Side vents.
4 - Central vents.
5 - Air outlet to the front passengers' feet.
6 - Air outlet to the rear passengers' feet.
Recommendations for use  Position the air flow control at a level which allows adequate air circulation inside your vehicle.
 Select the air distribution which best suits your requirements and the climatic conditions.
 Select a temperature setting and only alter it gradually for your comfort.
For an even air distribution, make sure that you do not block the air inlet grille at the base of the windscreen, the vents, th e
air passages under the front seats and the air extractor in the boot.
YOUR 406 IN DETAIL 55

17-02-2003
REAR SEATS Rear seats (saloon)Before moving the seats, to avoid damage to the seatbelts, carefullyplace them to the side of the seatback (for side seat belts) and gentlylower the seat to avoid blocking thecentre belt. The seat back folds down in two sec- tions.To fold down the seat back The unlocking controls are located in the boot. Pull the control corresponding to the part of the seat back that you wish tofold down. When returning the seat back to its original position, for your safetymake sure that it is correctly locked. Ski flap Lower the arm rest to access the ski flap. Open the flap from the boot.
YOUR 406 IN DETAIL
114