clutch Peugeot 508 2011 Owner's Manual

94
i
!
i
i
Driving








Starting-switching off the engine
With a manual gearbox
, put the gear lever in neutral.
With an electronic gear control gearbox
, put the gear lever in N
.
With an automatic gearbox
, put the gear lever in P
or N
.


)
Inser t the key in the ignition switch.

)
Turn the key fully towards the dashboard to
position 3 (Star ting)
.

)
When the engine star ts, release the key.



Starting using the key

Switching off using the key



)
Immobilise the vehicle.

)
Turn the key fully towards you to
position 1 (Stop)
.

)
Remove the key from the ignition switch.
For Diesel vehicles, in very cold
weather the engine will not start until
the preheater warning lamp has gone
off.

Key left in the ignition

If the key is left in the ignition switch,
there is an audible signal on opening
the driver's door.


If one of the star ting conditions is not met, a
reminder message appears in the instrument
panel screen. In some circumstances, it is
necessary to turn the steering wheel slightly
while pressing the "START/STOP" button to
assist unlocking of the steering; a message
warns you when this is needed.


If the vehicle is not immobilised, the
engine will not stop.


)
With the electronic key inside the vehicle,
press the brake pedal for vehicles with
automatic or electronic gear control
gearbox, or declutch fully for vehicles with
a manual gearbox.

Starting using the
electronic key

)
Press the " START/STOP
" button.


Switching off using the
electronic key


)
Immobilise the vehicle.

)
With the electronic key inside
the vehicle, press the " START/
STOP
" button.
The engine stops and the steering column is
locked.

Accessory position

With the electronic key inside the
vehicle, press the "START/STOP"
button, with no action on the pedals,
to switch the ignition on or off and so
activate accessories.

98
!!
Driving

Automatic release

The electric parking brake releases
automatically and progressively
when you
press the accelerator:


)
Manual gearbox:
press down fully on the
clutch pedal, engage first gear or reverse,
press on the accelerator pedal and move
off.

)
Electronic gear control gearbox
: select
position A
, M
or R
then press on the
accelerator pedal.

)
Automatic gearbox:
select position D
, M

or R
then press on the accelerator pedal.
Full release of the parking brake is confirmed by:


- the braking warning lamp and of
the P
warning lamp in the control
lever A
going off,

- display of the message
"Handbrake off ".


When stationary, with the engine running, do
not press the accelerator pedal unnecessarily,
as you may release the parking brake.



Before leaving the vehicle, check that
parking brake warning lamps in the
instrument panel and the control lever A

are on fixed, not flashing.




Immobilising the vehicle,
engine running
With the engine running and the vehicle
stationary, in order to immobilise the vehicle
it is essential to manually
apply the parking
brake by pulling
control lever A
.
The application of the parking brake is
confirmed by:


- illumination of the braking warning
lamp and of the P
warning lamp in
the control lever A
,

- display of the message
"Handbrake on".
When the driver’s door is opened, a loud beep
is heard and a message is displayed if the
parking brake has not been applied, unless the
selector lever is in position P
(Park) in the case
of an automatic gearbox.


Par ticular situations

In cer tain situations (e.g. star ting the engine),
the parking brake can automatically alter its
force. This is normal operation.
To advance your vehicle a few centimetres
without star ting the engine, but with the ignition
on, press on the brake pedal and release the
parking brake by pushing
then releasing

control lever A
. The full release of the parking
brake is confirmed by the warning lamps
in the control lever A
and in the instrument
panel going off and display of the message
"Handbrake off ".
If a parking brake fault occurs while applied
or
if the battery runs flat, an emergency release is
always possible.
In order to ensure correct operation and
so your safety, the number of successive
application/release operations of the parking
brake is limited to eight.
In the event of abuse, you are aler ted by a
message "Parking brake faulty" and a warning
lamp flashes.

104
!
i
!
i
Driving
Only engage reverse gear when the
vehicle is stationary with the engine at idle.
As a safety precaution and to facilitate
star ting of the engine:


- always select neutral,

- press the clutch pedal.










6-speed manual
gearbox


)
Raise the ring under the knob and push the
gear lever to the left then for wards.


Engaging reverse gear

Only engage reverse gear when the
vehicle is stationary with the engine at idle.
As a safety precaution and to facilitate
star ting of the engine:


- always select neutral,

- press the clutch pedal.








5-speed manual
gearbox


)
Push the gear lever to the right then
backwards.


Engaging reverse gear

4
123
i
i
Driving





Cruise control

System which automatically maintains the
speed of the vehicle at the value programmed
by the driver, without any action on the
accelerator pedal.
The cruise control is switched on
manually: it
requires a minimum vehicle speed of 25 mph
(40 km/h) and the engaging:


- 4th gear or higher on a manual gearbox,

- 2nd gear or higher on an electronic gear
control gearbox or automatic gearbox,

- position A
on the electronic gear control
gearbox or D
on the automatic gearbox.
The cruise control is switched off
manually
or by pressing the brake or clutch pedal or
on triggering of the ESP system for safety
reasons.
It is possible to exceed the programmed speed
temporarily by pressing the accelerator pedal.
To return to the programmed speed, simply
release the accelerator pedal.
Switching off the ignition cancels any
programmed speed value.

1.
Cruise control mode selection button

2.
Speed programming/programmed value
decrease button

3.
Speed programming/programmed value
increase button

4.
Cruise control suspension/resume button
(pause)

5.
Cruise control off button

Steering mounted controls

The cruise control cannot, in any
circumstances, replace the need to
obser ve speed limits, nor can it replace
the need for vigilance and responsibility
on the par t of the driver.





This information also appears in the
head-up display.
For more information on the head-up
display, refer to the relevant page in this
"Driving" section. The programmed information is grouped
together in the instrument panel screen.

Displays in the instrument panel



A.
Cruise control on/pause indication

B.
Cruise control mode selection indication

C.
Programmed speed value